direct pressure 中文意思是什麼
direct pressure
解釋
定向壓力-
Affusions use stream of water with or without pressure direct on various parts of the body knee, leg, full body, arm, face, chest, neck, lumber, etc. it can be cold, warm and alternate temperature
-注水利用無壓或加壓水流以喉管直接澆在身體的各部位膝蓋，腳，全身，手臂，臉，胸，頸，淋巴等等。可以是冷水或熱水，也可以冷熱交替。 -
A direct method for measuring this is the pressure bleed test.
一種直接測定的方法就是壓力泌水試驗。 -
Tight scale is usually a problem encountered in forgings hardened from direct - fired gas furnaces having high - pressure burners
用高壓爐頭直燃煤氣爐對鍛件進行淬火時，通常會出現鱗片問題。 -
Simulated experiments effects of intrathoracic pressure change on hemodynamics model i and ii tests demonstrated that the same itpc had different actions on the simulated ventricular fillings. the itpc would not change the pressure in the simulated right heart but its volume while it changed the pressure in the simulated left heart without direct influencing on its volume
模擬實驗胸壓變化對血流動力學的影響3第四軍醫大學博士學位答辯論文外周靜脈壓和模擬胸腔壓力變化相同時所引起的右心室容積的變化是相同的；當兩者同時同步變化時，右心室容積無變化。 -
The variations in trace element contents and ratios may hold up a mirror to the lake - level fluctuations and climatic changes, which, in turn, have exerted a direct and important effect on the sequence stratigraphic development. collectively, the reservoir rocks from the yanchang formation consist dominantly of the delta front subfacies subaqueous distributary channel and channel - mouth bar microfacies and delta plain subfacies subaerial distributary channel microfacies fine - grained feldspar sandstones and siltstones. the reservoir rocks have been subjected to three stages of diagenetic and porosity evolution : ( 1 ) the porosity reduction by the mechanical compaction and chemical pressure solution during the early diagenetic stage ; ( 2 ) the porosity increase by the dissolution during the a substage of the late diagenetic stage, and ( 3 ) the porosity reduction by the cementation and filling during the b substage of the late diagenetic stage
系統的儲層特徵研究表明，該區延長組儲層成因類型主要為三角洲前緣水下分流河道、河口砂壩及三角洲平原水上分流河道微相細粒長石砂巖、粉砂巖；儲層巖石經歷了壓實，膠結，溶蝕等成巖作用，歷經早成巖機械壓實和化學壓溶孔隙縮小期、晚成巖a亞期溶蝕作用孔隙擴大期及晚成巖a亞期（ b亞期）膠結充填孔隙縮小期三個成巖-孔隙演化階段；儲層物性總體上具有較低孔滲、低孔滲的特點，孔隙類型主要為粒間溶孔、殘余粒間孔隙、粒內溶孔、晶間孔及晶間溶孔，裂縫不發育，儲集巖排驅壓力和中值壓力較高，孔隙結構類型以細小孔-微孔隙，微細喉-微喉型為主。 -
In this paper, thermal evolution history of organic matter of the source rocks and hydrocarbon generation history have been researched by tti method, hydrocarbon migration direction and migration times were probed combining with the area structure development feature ; distribution pattern of the main reservoir intervals on lateral and longitudinal have been predicted by researching on development feature and control factors of the reservoir intervals, the actions of reservoir conditions in hydrocarbon accumulation and bearing also were probed combining with pore evolution feature ; the micro - pore feature of regional cap and direct seal in carboniferous - lower triassic in this area have been determined with micro - capillary pressure curve and intrusive mercury curve ; the prospecting districts have been pointed out combining with the hydro - geologic feature, the potential reservoirs were classified according to trap types in this area, the author attempt to evaluate on the hydrocarbon - bearing condition in the str ata of carboniferous ~ lower triassic from hydrocarbon generation and migration reservoir condition, reserved condition etc, and predict the reservoir types and hydrocarbon - bearing patterns combining with the structure evolution. based on above, the author point out that the central block of chenghu - tuditang synclinorium and the southern block of dangyang synclinorium are the advantageous regions for exploration
本文用tti方法研究了烴源巖有機質的熱演化史和油氣生成史，並結合區內構造發育特徵，探討油氣在區域上的運移方向和在時間上的運移期次；通過對儲集層段的發育特徵和控制因素的研究，預測了本區主要的儲集層段在橫向上和縱向上的分佈規律，並結合孔隙演化特徵，探討儲集條件在油氣聚集成藏中的作用；利用微毛細管壓力曲線法和壓汞法，對石炭系?下三疊統的區域蓋層和直接蓋層的微孔隙特徵進行了定量評價，並結合水文地質分佈特徵，指出有利於油氣保存的地區；根據區內存在的各種圈閉類型，對可能存在的油氣藏進行了分類，並試圖從油氣的生成與運移、儲集條件、保存條件等方面，動態地綜合評價石炭系?下三疊統油氣成藏條件，並結合構造演化特徵，預測其油氣藏類型和成藏模式。 -
Compared with traditional numerical methods such as the fem, fdm, etc, the lb method has several important features, including : simplicity in algorithm, easily programming, direct calculation of pressure from a state equation and amenability to simulate all kinds of flow field with complex boundaries, it also has much advantage in the respect of parallel computation because of its regional evolution
與傳統的計算方法如fem 、 fdm等相比， lb方法具有演算法簡單、編程容易、壓力可以通過狀態方程直接求解、能夠模擬各種復雜邊界的流場等優點，並且計算的局域性使其在并行計算方面也具有很大的優勢。 -
Direct blood - pressure meters for clinical use
臨床用直觀式血壓計 -
In this paper, three unique models were designed to research atom diffusion at interface, contacting line and joining point under bpec heating and compare with it under radiation heating in order to find out if bpec speed atom diffusion. the first model was aimed to research atom diffusion at interface under bpec heating. experiment condition of bpec diffusion welding sheet cu and ni : direct diffusion welding, at a pressure of l0mpa, welded at 750 ~ 900, with heat rate of 200 ~ 400 / min for 10mm, on / off of 6 / l ~ 48 / 8, with die or not, vacuum of 6pa
本文設計出三種樣品預構件，研究脈沖大電流加熱條件下片狀材料、線狀材料和球形顆粒之間的原子擴散過程，弄清脈沖大電流加熱條件下原子擴散與一般燒結和焊接過程中原子擴散的區別，以證實特殊的電場和磁場是否對原子的擴散有推動作用，揭示脈沖大電流加熱條件下原子的擴散過程，探索脈沖大電流熱加工技術快速高效的原因。 -
Using outputs of ground temperature, vapor pressure, wind speed and low cloudage. middle cloudage as well as high cloudage from mm5v36, and ground direct radiation and out - going scattered radiation from modtran3
利用數值預報模式mm5v36輸出地面氣溫、水汽壓、風速和低雲量、中雲量及高雲量等氣象要素。利用大氣輻射傳輸模式modtran3 . 0輸出地面太陽直接輻射和射向天空的散射輻射以及總輻射。 -
If the direct pressure method cannot control bleeding, apply pressure over the arterial pressure points to facilitate blood coagulation. press for 5 to 10 minutes and never exceed 15 minutes
如直接壓法仍未能止血，則可用動脈壓點，施壓協助止血，施壓時間為五至十分鐘，切勿超過十五分鐘。 -
Glass ) and rinse the wound with water. - do not attempt to remove objects that are firmly embedded in the wound, this may worsen bleeding. - control bleeding by applying direct pressure over the wound for at least 5 - 15 minutes by covering it with a gauze
如傷口不斷流血，就需要用直接壓法止血，即用手指或手掌隔著消毒紗布，直接壓住傷口（沒有異物的部位）控制出血，大約施壓5 - 15分鐘，止血后再包紮妥當。 -
Do not attempt to remove objects that are firmly embedded in the wound, this may worsen bleeding. - control bleeding by applying direct pressure over the wound for at least 5 - 15 minutes by covering it with a gauze. - seek medical treatment if bleeding continues
-如傷口不斷流血，就需要用直接壓法止血，即用手指或手掌隔著消毒紗布，直接壓住傷口沒有異物的部位控制出血，大約施壓5 - 15分鐘，止血后再包紮妥當。 -
Test methods for microbiological monitoring of water used for processing electron and microelectronic devices by direct pressure tap sampling valve and by the presterilized plastic bag method
用直接加壓分接抽樣閥和用預先消毒塑料包法對電子和微電子器件加工用水微生物監測的測試方法 -
The direct pressure clamping mechanism structure has some feature of high running speed, great clamp mold force and the variable lengthy travel distance of moving mold according to mould - width, therefore no moulding - adjustment system needed
採用了直壓式鎖模結構，超長鎖模行程，強大的鎖模力，無調模機構，不需調模，鎖模行程可依模厚改變，高速運轉。 -
When using the direct pressure method, the injured should lie down and rest with the injured limb cushioned above the ground ( except for fracture victims ). inspect the wound, cover and bandage it with dressing
直接壓法是讓傷者躺臥休息，墊高傷肢（骨折者除外） ，檢查傷處，然後用敷料遮蓋傷口，再用繃帶施壓包紮，切勿太緊，以免影響肢體末端血液循環。 -
When using the direct pressure method, the injured should lie down and rest with the injured limb cushioned above the ground except for fracture victims. inspect the wound, cover and bandage it with dressing. exert pressure but avoid bandaging it too tightly by which may impair blood circulation to the end of the limb
直接壓法是讓傷者躺臥休息，墊高傷肢骨折者除外，檢查傷處，然後用敷料遮蓋傷口，再用繃帶施壓包紮，切勿太緊，以免影響肢體末端血液循環。 -
Direct pressure and indirect pressure methods are most commonly used in first aid
直接壓法及間接壓法是急救最常用的。 -
The ways to stop bleeding include direct pressure method and indirect pressure method
止血方法可分為直接壓法及間接壓法。 -
For larger wounds, or in case bleeding does not stop quickly, use direct pressure
如果傷口很大，或是不能很快止血，就要直接將它壓緊。
分享友人