discharge-flow system 中文意思是什麼

discharge-flow system 解釋
放電流動系統
  • discharge : vt 1 發射（炮等），打（槍），射（箭）。2 起，卸（貨）。3 排泄，排出，放出（水等）。4 釋放；解除，...
  • flow : vi 1 流，流動。2 （血液等）流通，循環。3 流過；川流不息；（時間）飛逝；（言語等）流暢。4 （衣服、...
  • system : n 1 體系，系統；分類法；組織；設備，裝置。2 方式；方法；作業方法。3 制度；主義。4 次序，規律。5 ...
  1. To provide necessary data for design bypass pipe, an enlargement to bi liu river reservoir, the following problems have been studied by hydraulic model and theoretical analysis : the energy losses in water head of the bypass pipe system and of the flow - control valve and their scale effects, measurement and calculation of the discharge of the bypass pipe system during the bypass pipe system operation with and without the new water power station, the hydraulic characteristics of the water tunnel and draw - off pipe, the flow rate of the aqueduct bridge and the draw - off pipe and the water elevation of the flow in the aqueduct bridge during the old water power station operation with and without the new water power station

    大連市碧流河水庫供水工程取水頭部由引水渡槽、節制閘、進水閘、泄水閘等建築物組成。由於本工程場地條件限制，增設旁通管后布置非常緊湊，管道急轉角度大且轉彎距離較小，對于管內水流流態是否滿足要求，需要經過模型試驗進行論證，以確保工程的可靠性。旁通管具有上水與泄水要求，對其過流能力也要經試驗確定，為碧流河水庫增建旁通管設計提供依據。
  2. In the first part of this paper, mn ( iii ) / mn ( ii ) couple in h2so4 was firstly applied as the positive couple to this system, i. e. redox flow cell. its chemical, electrochemical properties, redox kinetics and related parameters were characterized and discussed by rotating disc electrode ( rde ), cyclic voltammetry ( cv ), a. c. impedance ( a. c. imp ), chronoamperometry, tafel curve, and galvanostatic charge / discharge techniques. conclusions have been drawn as follows : 1. the electrochemical kinetics of mn ( iii ) / mn ( ii ) redox couple in 6. 3m h2so4 solution were studied by means of rotating disc electrode ( rde ) technique on platinum electrode

    本文第一部分首次成功地將酸性介質中的mn （ iii ） / mn （ ii ）電對應用於氧化還原液流電池這一新型儲能裝置的正極活性材料，通過旋轉圓盤（ rde ） 、循環伏安（ cv ） 、交流阻抗（ a . c . imp ） 、恆電位階躍、 tafel實驗以及mn （ iii ） / mn （ ii ）單電極的恆流充放電實驗，我們得出以下結論： 1 .在旋轉圓盤電極上，不同轉速范圍，不同的極化過電位， mn （ ） / mn （ ）體系氧化還原電極過程的控制步驟不同，電荷傳遞、擴散傳質可分別或聯合成為控制步驟。
  3. 4. through the galvanostatic charge / discharge experiments with different schedules, it was found that mn ( ) / mn ( ) in acidic media as half - cell in a novel redox flow system is practically feasible in that it has such advantages as low cost, high open voltage, a certain coulombic efficiency with low charge / discharge current, and long cycling life. in the second part, cosn alloy and cu - sn samples were synthesized firstly by h2 - reduction following solid - state reaction between co ( ii ) 、 cu ( ii ) 、 sn ( iv ) 、 and naoh at ambient temperature

    並研究了其分別作為鋰離子電池陽極材料在1mol / llipf6 / ec + dmc電解液中的恆流充放電性能，各樣品均存在較大的首次不可逆容量損失； 10個循環內cu - sn可逆放電容量可保持在280mah / g以上，而第十周時cosn 、 cu6sn5的可逆放電容量分別為50mah / g和60mah / g 。
  4. The open - channel flow - measuring system described in this paper is used for the measurement of the waste discharge in the city or from the factories

    本文所描述的明渠流量測量系統是用於對屬于明渠流動范疇的城市和工礦企業的污水排放進行流量計量的。
  5. The growth of the groundwater flow system is controlled by recharge and discharge of the aquifer and structure of the aquifer system

    水流系統的發育受含水層補給和排泄條件及含水系統結構控制。
  6. Considering of the problems exist in practice, large orifice discharge principle is employed to study the pressure distribution of ring runner system, the even ab lity for discharging of gates, the relationship of flow with the position of spr ue and the type of gates. a new design idea about circular runner system of cast is proposed

    根據生產中存在的問題，用大孔出流理論研究了環形橫澆道系統的壓力分佈、內澆道出流均勻性及流量與直澆道引入位置和內澆道引入方式之間的關系，提出了圓形鑄件環形橫澆道系統新的設計思想。
  7. Abstract : the limitations to the discharge of ship ballast water set by imo raise new problems in the design of ship ballast piping & ballast tank construction. a system through which ballast water can be flow - through exchanged is designed and some other suggestions to solve the problems are provided

    文摘: imo對船舶壓載水的排放限制給船舶壓載管系和壓載艙室的設計提出了新的課題，文中設計了以噴射泵的抽吸作用進行循環更換壓載水的壓載系統，為解決相關問題提供了若干建議和思路。
  8. Chapter 3 gives an introduction to the flow rate dividing principle based on meter - in flow rate feedback control of multi - actuators control system. special analysis about simultaneously operating multi - actuators with different inertia loads is made. finally the results of simulation proved that the new method is an effective way to improve the flow - used ratio when the pump discharge flow rate is insufficient

    第三章介紹了基於執行器進油側流量反饋的分流控制的原理，並針對大小慣性執行器同時起動時採用該分流控制方法進行了具體分析；最後通過模擬說明該分流控制方法能在大小慣性執行器同時起動並在泵輸出流量不足的情況下有效提高泵輸出流量的利用率，並能實現優先級和分流比混合控制。
  9. For the larger area contraction ratio, the flow condition becomes more complicated, the discharge of the tunnel and the change of the negative pressure in the cavity pocket will be reduced, but the cavity diameter of the level rotary cavity flow and the dissipation ratio of the system will be increased

    面積收縮率較大時，流態變化復雜，泄流量和環流空腔內的負壓的變化減小，但空腔環流的空腔直徑和泄洪洞的消能率增大。
  10. Introduces the structure of the multi - actuators control system based on pressure decrease sensing. then a multi - actuators control system model is developed for the constant pump discharge pressure hydraulic system. also the factors that affect the static accuracy of actuators " speed and flow rate and the dynamic characteristic are analyzed in this chapter

    第二章簡單敘述了基於壓差傳感的計算流量反饋流量控制原理及其實現；介紹了基於壓差傳感的多執行器復合控制系統的構成；之後主要針對定壓系統多執行器復合控制建立了數學模型，並分析了影響執行器速度及流量穩態控制精度和動態特性的一些因素。
  11. Discharge measurement and control system for unsteady flow hydraulic model and its performance analysis

    非恆定流水力模型流量檢測控制系統及其特性分析
分享友人
分享到 Line

分享到臉書