driven shaft 中文意思是什麼

driven shaft 解釋
【機械工程】從動輪。

  • driven : adj. 1. 被逼迫的，不得已的，被驅使的。2. 打入的。3. 吹積起來的。4. 【機械工程】從動的。
  • shaft : n 1 箭；箭桿。2 （槍、槌、斧等的）柄；矛。3 【植物；植物學】稈；莖；柄。4 【動物；動物學】羽軸；...
  1. Simulation based on matlab software for the hooke ' s joint driven shaft

    八關節三動桿蛇形機器人的運動模擬
  2. The reason of rupture of driven shaft of idler wheel for some factory is analyzed

    摘要文章分析了某單位移動工位滾輪架從動軸的斷裂原因。
  3. Driving and driven machines - shaft heights

    驅動機械和從動機械.旋轉軸高度
  4. Borehole shaft driven pump

    井下長軸傳動泵
  5. Internal concrete vibrators with eccentric weight driven by electric motor through flexible shaft

    電動軟軸偏心插入式混凝土振動器
  6. When the belts have been located in the belt pulley grooves, moves the drive motor away from the driven shaft so that uniform teensioning of the belts is achieved

    在安裝新皮帶時，要用手動的方式使電機向驅動軸移動而使所有皮帶均處于滑輪槽內。
  7. Planetary internal concrete vibrator with flexible shaft driven by electric motor

    電動軟軸行星插入式混凝土震動器
  8. Repairing technical requirement for special equipment of bucket dredgers part 1 : main rotary shaft, turning shaft and driven shaft

    抓鬥挖泥船專用設備修理技術要求第1部分：旋轉中心軸轉車軸傳動軸
  9. Because the newly designed clutch is installed on the driven shaft, smooth acceleration is possible

    因為最新設計的離合器安裝在從動軸上，所以平穩加速是可能的。
  10. Effect of driven - mechanism on natural frequency of torsional vibration of motor shaft

    被驅動機構對電動機軸扭振固有頻率的影響
  11. Shaft heights for driving and driven machines

    傳動和從動機械的軸高
  12. A carriage, which had been following the escort, had driven into one of their carts and run a shaft into it. several soldiers ran up to the cart from different sides ; some hit the carriage horses on the head as they turned them round, other were fighting among themselves, and pierre saw one german seriously wounded by a blow from the flat side of a sword on his head

    押送隊後面的一輛馬車撞到押送隊的一輛大車上，把車子撞了一個洞，有幾個士兵從不同方向跑到大車前一些士兵把套在馬車上的馬牽到一邊，抽打著馬頭，另一些士兵則相互打起架來，皮埃爾看見，一個德國士兵的頭被刀砍成重傷。
  13. The front / reverse switching mechanism was placed on the driving shaft, while the acceleration clutch was placed on the driven shaft

    前/后機械開關安裝在驅動軸上，同時加速離合器安裝在從動軸上。
  14. No need of alignment when employing a torque arm ( optional part ). installation can be compelted only by inserting a driven shaft to the hollow output shaft of the gearmotor

    在使用反扭矩桿（可選部件）時無需定位調整，只要將從動插入齒輪減速機的空心輸出軸即可完成安裝。
  15. When the shaft is rotated, the pinion with the same axle remains stationary, driven in the opposite direction by another gear

    當軸轉動時，同軸心的小齒輪不動，由另一個齒輪帶動它往反方向轉動。
  16. Internal combustion engines driven generating sets. limits and measuring methods for torsional vibration of shaft systems

    內燃發電機組軸系.扭轉振動的限值及測量方法
  17. Two - way clutch rotor is attached to the output shaft, and clutch bearing cam is on the output - input shaft. when the right side is energized the output - input shaft is driven and when current is cut to the right side it disengages so the output - input shaft stops

    雙側的離合器轉子被固定在出力軸上而離合器的軸在出入軸上，當右側的離合器通過電流時出力軸就會被帶動，當右側斷電時離合器就會分離，出入軸就停。
  18. Shaft - driven generator

    軸驅動發電機
  19. When the clutch is energized the output shaft is driven ; and when the clutch is disengaged and the brake is energized, the output shaft stops

    當電流通過離合器時，出力軸被帶動，當離合器分離時，剎車有電流通過時，出力軸就停止。
  20. When the left side is energized the output - input shaft is driven, and when current to the left side is cut the clutch disengages and the output - input shaft stops

    當左離合器通電時出力軸被帶動，左側斷電時離合器就會分離，出力軸就停止。
分享友人
分享到 Line

分享到臉書