drying conditions 中文意思是什麼

drying conditions 解釋
乾燥條件
  1. The flow diagram of a lpg bottle paint - drying heating system using heat carrier as heat - medium, which has similar properties as other heat - carrier heating systems, has been improved, which has good effect in avoiding oil - spraying, shortening dehydration time and power - fail protecting etc. after making a series of analysis, calculational methods of expansion tank dimension have been deduced, which takes the moisture boiling - off of heat carrier into account and accords with real conditions

    對與其它熱載體加熱系統具有共性的鋼瓶熱載體加熱系統的流程圖進行了改進和完善,在防止噴油、縮短脫水時間和停電保護等方面取得了良好效果。通過分析,整理出了熱載體加熱系統膨脹器容積的計算方法,該方法考慮了熱載體所含水分汽化而帶來的影響,比原有的計算方法更加符合實際。
  2. Continuous air circulation is required in confined areas in order to obtain sufficient drying conditions

    為了獲得足夠的乾燥條件,須保持良好通風。
  3. A differential fixed - bed reactor was employed to study the reaction between iron blast furnace slag ( bfs ) / hydrated lime ( hl ) sorbent and so2 under conditions similar to those in the bag filters of a spray - drying flue gas desulfurization system

    摘要本研究以微分固定床反應器,在模擬噴霧乾燥除硫系統中的袋式過濾器的條件下,探討爐石/氫氧化鈣吸收劑與二氧化硫于低溫下之反應動力學模式。
  4. In order to study the influence factors of aoa of rose flowers, the effects of drying and extraction methods on the aoa of rose flowers were investigated. the results indicated that drying after high - temperature short - time pretreatment was rather effective to maintain their aoa ; the aoa of water extracts was stronger when the temperature was raised from 25 to 100 ; by using orthogonal test, the optimum extraction conditions of rose flowers were : solvent - 75 % ethanol ; ratio of material and solven - 1 : 10 ; extraction times - three times with 24 h at one time, at the room temperature. the extracts obtained by 75 % ethanol were fractionatedly extracted with petroleum, diethyl ether, ethyl acetate and n - butanol in turn, and the various fractions " aoa were analyzed

    為了探討玫瑰花抗氧化活性的影響因子,比較了不同乾燥方法、提取方法對其抗氧化活性的影響,發現:經短時高溫處理后再進行乾燥有利於較好地保持玫瑰花的抗氧化活性;以水作溶劑提取時, 25 100范圍內水提液的抗氧化活性隨著溫度的升高而增強;通過正交實驗篩選得到常溫下玫瑰花抗氧化活性物質的最佳提取方法為: 75乙醇為溶劑,液料比1 : 10 ,提取3次,每次24h ; 75乙醇提取物依次用石油醚、乙醚、乙酸乙酯、正丁醇等有機溶劑進行兩相分部萃取,發現玫瑰花的抗氧化活性物質主要存在於乙酸乙酯部,說明玫瑰花抗氧化活性主要成分可能是單寧類、黃酮苷類和原花色素類化合物; 4
  5. The optimization research is given on the technological conditions of preserved kiwi fruit, such as peeling, color and luster protection and drying

    摘要對獼猴桃果脯生產過程中的去皮、護色、乾燥等工藝條件進行了研究。
  6. The fate of nitrogen forms of nitrogen fertilizers under alternate leaching and drying conditions

    間歇淋洗干濕交替條件下氮肥的氮行為研究
  7. Irrational drying conditions would lead to crack of rice, increasing sensitivity of breakage and lowering percentage of head rice during milling

    摘要不合理的乾燥條件導致稻穀出現裂紋,破碎敏感度增大,碾米時整米率降低。
  8. During the preparation process of the solid solution, a series of effect conditions were discussed such as ph value, si / h2o, the content of ligant, the surface active agent, the aging temperature, the drying means, the drier gel calcine and their effects on the gel quality, the process of sol - gel, the granular of powder and the density of the pellets, from which the best reaction condition was found

    在制備過程中系統地研究了各種反應條件如ph值、 sal ; o 、絡合劑的添加量、老化溫度、乾燥方式、干凝膠的鍛燒方式等對溶膠「的質量、溶膠凝膠過程、粉體粒度及燒結體密度等的影響,確定了最佳反應條件:三、以li 。石i 。 。
  9. Effect of drying and storage conditions on salidroside content in root of rhodiola sachalinsis

    乾燥與貯藏條件對高山紅景天根部紅景天苷含量的影響
  10. Under normal weather conditions, the panels display the weather forecast together with cloud movements, wind distribution, marine forecasts, local temperature, laundry drying information, uv radiation information, tide levels at the local harbor entrance, typhoon information and assorted local information. however, when emergency information such as tsunami or high tide information is input, the panels automatically switch to the alarm information screen under which the expected tsunami arrival time is displayed

    通常氣象信息會依次進行天氣預報,雲的動向,風向風力,海上預報,各地氣溫,洗滌信息,紫外線信息,港口的潮位,臺風信息,各地區信息等,不過,在有緊急情況時,會加入警報信息,預報海嘯到達時間,通過超聲波裝置110db呼籲高地避難。
  11. The optimum technic conditions have been gotten in in preparaing high dispersive a1 ( oh ) 3 colloid by controlling reactant concentration, ph value, reaction temperature, matured time. they are the prereguisite to prepare nanopoder of a - a1203. this paper entirely and systematically studies the following three kinds of drying stages : oven drying, dehydration with alcohols and azeotropic distillation stage

    本文採用逐步逼近法進行了氫氧化鋁膠體的沉降實驗,對膠體形成的體系反應物的初始濃度、體系的ph值、反應溫度和膠體的陳化時間進行了系統優化,並獲得了制備高分散氫氧化鋁膠體的最佳工藝參數;此膠體經過過濾、 80下烘乾后所得樣品,在掃描電鏡下直接觀察其粒徑為50nm ,且分佈范圍窄,顆粒的表面清潔,為球形。
  12. Directed by the adsorption theories, sepiolite was selected as micropore inorganic material and dodecanol was selected as pcm, and carried out the optimization of experimental parameters, such as selection of sepiolite minerals, sepiolite modification, absorption temperature, pcms solution concentration, stirring time, drying mode, dehydration of sepiolite. by the optimization, the best conditions on tsous preparation were achieved. measurement method of pcms exudation was established to estimate the exudation of pcm in tsous, the temperature self - operating effects and energy saving effects of tsous was also examined

    在以上微孔吸附理論研究基礎上,選用海泡石作為微孔無機材料、十二醇作為相變工質材料,對自調溫單元的制備工藝參數進行了優化研究,包括:海泡石原料的選擇、海泡石改性的影響、吸附溫度的選擇、 pcm有機溶液初始濃度的選擇、攪拌時間的確定、烘乾方式的選擇、海泡石含水量的確定,最終得到自調溫單元的最佳制備工藝。
  13. In the paper, the composition of water - soluble polyurethane grouting was presented, the influence of the drying conditions and reaction time and temperatures for some property of the polyurethane grouting have been studied

    摘要研究了水溶性聚氨酯灌漿材料中多異氰酸酯與聚醚多元醇原料的選擇,聚醚的脫水條件,反應溫度與時間,以及穩定劑及增塑劑對漿材性能的影響。
  14. ( 2 ) base on the analysis of the atomizing principles of spray nozzle, mathematical model of combined spin - flow pressure spray drying was set up and the essential parameters such as spraying pressure, liquid quantity, temperature, spraying angle, inject distance, particle diameter and distribution, hollow diameter for several materials in normal conditions by experiment and ldv

    ( 2 )對旋流式組合壓力噴嘴噴射霧化機理加以分析,建立了旋流式噴嘴霧化的數學模型,採用冷態試驗法並藉助激光霧滴測試等實驗裝置對噴嘴的霧化參數(如霧化壓力、噴液量、料液溫度、霧化角、霧距、霧滴直徑和分佈以及噴嘴的空芯半徑等)進行測量和計算。
  15. After extensive conditional experiments such as reactant concentration, acidity ph, temperature and time of reaction have been done, and the factors influencing the sol stability such as washing method, drying temperature and roasting temperature and time have been discussed, the best conditions in this work are given

    通過考查超細粉體制備過程中反應物濃度、 ph值、反應時間與溫度、影響溶膠穩定性的因素、洗滌方式、乾燥溫度、燒結溫度與時間對產品性能影響的大量實驗,給出了本實驗的最佳參數。
  16. Reasearch on conditions preparing nano - mgo by freeze - drying method

    冷凍乾燥法制備納米氧化鎂條件的研究
  17. ( 1 ) two edt monomer synthetic paths have been investigated. ( 2 ) using the method of depositing the pedt film on the glass base, the affect of processing and environmental conditions - - such as the polymerizing temperature, the state of the polymer material, the polymerization correctives, the drying temperature, and the amount of the solution etc. - - to the pedt material ' s electroconductivity has also been examined in this paper

    主要研究內容包括: ( 1 ) edt單體合成路線的兩種方案,以及具體的制備過程; ( 2 )在玻璃基片上淀積pedt膜層,研究了聚合溫度、聚合物狀態、聚合改良劑、烘乾溫度、溶劑含量等工藝及環境條件對pedt材料電導率和成膜速度的影響。
  18. So in our experiment, we applied with freezing and drying bone and bone marrow stem cells ( bmsc ) as cellular seeds. in these conditions, freezing and drying bones provided fine interspaces structure and good adhesive and grow conditions. at the same time, bmsc which transfected vascular endothelial growth factors ( vegf ) as cellular seeds provided the seeds and stimulating factors

    目前,深凍骨已商品化,免疫排斥反應罕見發生,故本實驗以凍干松質骨作為基質材料、轉染有血管內皮細胞生長因子( vegf )的骨髓基質幹細胞( bmsc )為種子細胞,這樣既保持了骨組織優良的空間結構,又提供了種子細胞和血管化的刺激因子。
  19. The so - called vacuum drying is heating & drying of the materials under vacuum conditions to which, vacuum pump is adopted for air - bleed and humidity suction thus speedy drying is reached

    真空乾燥,就是將被乾燥物料處于真空條件下,進行加熱乾燥,它是利用真空泵進行抽氣抽濕,加快了乾燥速度。
  20. Standard test method for evaluation of durability of rock for erosion control under wetting and drying conditions

    在潮濕和乾燥條件下評價侵蝕控制巖石耐久性的標準試驗方法
分享友人