elastic bending 中文意思是什麼

elastic bending 解釋
彈性彎曲
  • elastic : adj. 1. 有彈力[彈性]的。2. 伸縮自如的，靈活的。3. 機變的，輕快的。n. 橡皮線，松緊帶，橡皮圈。adv. -ally
  1. The stiff floor structure has bigger displacement and smaller internal forces. under seismic forces, frame with eiastic fioor has bigger vibration period, and takes on complicated modes of vibration. due to the big vertical rotation, structure with elastic floor shows more prominently coupling vibration of bending rotating and twisting

    如，彈性樓板的結構位移比剛性樓板結構的位移大，內力也是彈性樓板結構的大；在地震力作用下，考慮彈性樓板變形的空間框架振動周期比剛性樓板框架長，而且其振型表現得也比較復雜，由於豎向扭轉位移較大，彈性樓板結構表現出更明顯的彎扭耦聯振動。
  2. In light of the elastic thin plate theory, the author induced equilibrium differential equation of bi - direction cellular slab, which was proved correct through analysis and comparison to result of ansys to with theoretical calculation. through the deflection and bending moment coefficient calculation of bi - direction cellular slab under various boundary conditions, the author brought forward the theory that the deflection of mid - span and bending moment coefficient calculation of mid - span and support of bi - direction cellular slab could be in accordance with solid plates ", which could satisfy the precision of engineering

    本文根據彈性薄板理論，導出了雙向空腹板的平衡微分方程，並通過理論計算和通用有限元程序ansys結果對比，驗證了其正確性；通過對各類邊界條件下雙向空腹板撓度和彎矩系數的計算比較，本文提出：雙向空腹板跨中撓度及跨中、支座彎矩可使用本文空腹板剛度公式查找現有的實心板撓度彎矩系數表進行計算，完全能滿足工程精度要求。
  3. The elastic foundation model is considered as two - parameter elastic foundation model and its effect to moderate - thick plates are taken into account by a set of governing differential equations. united with hu hai - chang ’ s function, least squares collocation weighted residual method which uses b - spline function as trial function is put forward for solving the bending problems. compare with the results of finite element method of lines, spline finite strip method, accurate solution of series etc. it is proved that the method in this article has adequate accuracy and practical feasibility

    本文採用瑞斯納中厚板理論求解彈性地基板，建立雙參數地基與中厚板相互作用的控制微分方程，結合胡海昌的解耦函數，運用雙五次b樣條函數作為試函數的離散型最小二乘加權殘值法分析了雙參數地基上的中厚板的彎曲問題，並將結果與有限元線法、有限條法、級數精確解等進行比較，證明本文方法具有足夠的精確性與實際的可行性。
  4. Elastic theory and plastic theory are adopted in the analysis of the two section composite beam. elastic theory suggests, on the condition of the same steel beam section size, the composite beam for the floorslab is suited lower flanges convertion section stiffness cuts down by 75. 1 %, elastic limit bending resistant capability cuts down by 47. 9 %, than the composite beam for the floorslab is suited on the top flange. it s conversion section stiffness is lifted 8. 0 %, elastic limit bending resistant capability is lifted 0. 20 %, than the steel beam

    彈性理論分析的結果表明，在鋼梁截面大小相同的條件下，樓板位於鋼梁下翼緣的組合梁和樓板位於鋼樑上翼緣的組合梁相比，其換算截面剛度降低75 . 1 ，梁的彈性極限抗彎承載力降低47 . 9 ，樓板位於鋼梁下翼緣的組合梁和純鋼梁相比，其換算截面剛度提高8 . 0 ，梁的彈性極限抗彎承載力提高0 . 2 。
  5. This paper focuses on the research of the stress mechanism of the ribbed shell structure in statics, dynamics and under the explosive load on the basis of the engineering practice of cave depot of single aircraft. in this paper, according to the classical shell theories, the basic differential equilibrium of the ribbed shell structure and the finite element analysis of 3d rippled plate are established, in which the function of annular ribs reinforcement bars and 3d ripped steel plates are distributed in the range of the steel, and the functions along the longitude direction of tension, bending, and torsion are neglected ; applied with dynamic analytical theory, the dynamic model of ribbed shell structure and the analytical theory model of elastic - plastic are set up ; the triangle series method is used to solve the displacement and stress under the distributed load and the concentrated load of the ribbed shell structure

    本文以軍用機場地面單機掩蔽庫工程建設為工程背景，首次對內襯三維波紋鋼板混凝土拱型復合結構的受力機理進行了靜力、動力和爆炸荷載的分析研究。根據將橫肋、鋼筋及三維波紋鋼板的作用均勻分佈在殼體范圍內的情況，忽略橫肋、鋼筋及三維波紋鋼板沿殼體母線方向的抗拉、抗彎及其抗扭作用，首次推導出了內襯三維波紋鋼板混凝土殼體的微分平衡方程，建立了有限元計算模型，並採用三角函數法，求解了三維波紋鋼板混凝土拱型復合結構在分佈荷載和集中荷載作用下的位移響應和應力響應，並與普通殼體進行了比較。
  6. The calculation of lacunaris elastic plane bending or torsioning stress concentration problem by collocation method

    用配點法計算多孔彈性平板彎曲或扭轉應力集中問題
  7. This subject is to combine the steel fiber reinforced concrete with the lightweight aggregate concrete to form a steel fiber reinforced lightweight aggregate ( haydite ) concrete, which owns the advantages of high toughness of steel fiber reinforced concrete and the light weight of lightweight aggregate concrete. in order to get the main character and mechanical property parameter of strength and deformation of steel fiber reinforced lightweight aggregate concrete, we do the experiments of cubic compressive strength, splitting - tensile strength, bending strength, elastic modulus and axial compressive strength and summarize the influence laws to the relation of mechanical performance of steel fiber reinforced lightweight aggregate and the quantity of steel fiber

    鋼纖維輕骨料混凝土兼有鋼纖維混凝土的韌性高和輕骨料混凝土質量輕的優點，為了掌握這種新型材料的主要特徵和強度、變形等力學性能，本文進行了鋼纖維輕骨料混凝土的立方體抗壓強度、軸心抗壓強度、劈裂抗拉強度、抗折強度和彈性模量等試驗研究，總結出鋼纖維摻量對鋼纖維輕骨料混凝土的力學性能的影響規律。
  8. Application of natural boundary element method to the bending problem of the elastic thin circular plate

    自然邊界元法在彈性圓形薄板彎曲問題中的應用
  9. As regards to the spheric thin shell structure under external hydro static pressure, basing on flat - plate theory and by using basic von karman equations for large deflection, the equilibrium problem of axisymmetric bending of the spheric shell under uniform external pressure is simplified to an equilibrium problem of bending of elastic basic flat - plate and further converted into an equilibrium problem of beam on elastic fundation taking into consideration of the deformation characteristics

    對球形薄殼結構隨靜水外壓的情況，應用平板理論中的vonkarman大撓度基本方程，將球形薄殼在均勻外壓下的軸對稱彎曲平衡問題簡化為彈性基礎平板的彎曲平衡問題，進而再根據變形特點將其轉化為彈性基礎梁的復雜彎曲平衡問題。
  10. In this part, it is also found that the equivalent prismatic column, which is obtained based on the equal elastic critical load as the non - prismatic member, is not actually equivalent to the tapered column in inelastic stability, and the latter has higher load carrying capacity. finally, the behavior of tapered beam - column acted by combined axial load and transverse load has been investigated. a bending - thrust interaction curve is established which is similar to the ones for the design of prismatic members

    三是研究了楔形變截面懸臂構件在大端固定，小端同時承受橫向及軸向荷載共同作用下的強度和彎矩平面內的穩定，同時參考等截面構件的設計公式，得到了用大端截面來表示的軸力p與彎矩m的之間的相關關系。
  11. Novel method for solving plane bending of elastic arches with arbitrary profile

    求解任意外形彈性拱平面彎曲的一種新方法
  12. Aiming at the shortages and demerits in the study of constitutive relationship of concrete based on elastic - plastic mechanics, damage expressions of concrete subjected to uniaxial tension - compression was deduced based on damage mechanics, and general damage evolution equation of concrete in bending state was received also

    摘要針對彈塑性力學研究混凝土本構問題帶來的不足和缺陷，運用損傷力學的方法，導出混凝土在單軸拉、壓狀態下的損傷表達式，得到了混凝土在彎曲狀態下的統一的損傷演化方程。
  13. Medium density fiberboard determination of static bending strength and elastic modulus

    靜曲強度和彈性模量的測定
  14. The model considers the torsional deformation of transmission axes, bending and longitudinal deformation of links, geometrical nonlinearity of guiding leaf springs, and the elastic nonlinearity of balance springs

    該模型考慮了傳動軸的扭轉變形，連桿和導向板彈簧的彎曲和拉伸變形，導向板彈簧的幾何非線性及平衡彈簧的非線性等因素的影響。
  15. Although strict design calculations are made to guarantee the members have sufficient strength in their work life, yet dash and improper loads may damage them during construction and in service. these damages include elastic - plastic bending and local dent in the walls of the tube. in addition, corrosive medium such as atmosphere and contaminated water can also bring corrosion damage in the walls of the tube

    雖然都經過嚴格的設計計算，以保證其在使用壽命期內有足夠的強度，但在安裝施工和使用期間，往往因受到沖撞和非正常荷載而產生彈塑性彎曲和凹陷等損傷，此外大氣、受污染的水分等腐蝕性介質也可能在管壁上產生腐蝕損傷。
  16. The elastic - thin - plate bending method for predicting ground subsidence due to underground mining

    地下開采引起地表沉陷預測的彈性薄板法
  17. The total elastic coupling is the sum of the restraints due to the bending of the tapes and the twisting of the wire.

    總的彈性耦合是張力帶彎曲及張力線扭轉所產生的約束力矩之和。
  18. Taking the bending stiffness, cable sag and cable inclination into consideration, the space vibration control of the cables using the visco - elastic dampers in cable - stayed bridges is investigated by joining the center difference method and the state space strategy. both the maximum modal damping ration and the optimal damper size are obtained, then the practical suggestions are proposed for the design of the dampers. the space nonlinear vibration equations of the cable - damper system are derived, and a new hybrid method for solving the cable - damper system is presented by combing the newmark method and pseudo - force technology

    綜合考慮了拉索抗彎剛度、垂度的影響，研究了粘彈性阻尼器對斜拉橋拉索的空間振動控制，聯合中心差分方法及狀態空間法，得出了拉索麵內、外振動各階模態可能達到的最大阻尼比及相應的最優阻尼器系數，並對斜拉橋拉索的阻尼器設計提出了參考建議：考慮拉索抗彎剛度、垂度及幾何非線性，導出了索-阻尼器系統的空間振動非線性方程組，結合newmark方法及偽力（ pseudo - force ）方法，創新地提出了求解非線性方程組的雜交方法，根據拉索-阻尼器系統的阻尼特性，在各種荷載作用下，對索-阻尼器系統的非線性瞬態振動響應進行了研究，從系統響應的角度更加直接地驗證了阻尼器的控制效果。
  19. Elastic - plastic bending induced residual stress and its influence on tensile yield strength of plates

    彈塑性彎曲所致殘余應力及其對板料拉伸屈服強度的影響
  20. Unified solution method of rectangular plate elastic bending

    矩形薄板彈性彎曲統一求解方法
分享友人
分享到 Line

分享到臉書