elastic shear deformation 中文意思是什麼

elastic shear deformation 解釋
彈性剪切形變
  • elastic : adj. 1. 有彈力[彈性]的。2. 伸縮自如的，靈活的。3. 機變的，輕快的。n. 橡皮線，松緊帶，橡皮圈。adv. -ally
  • shear : vt vi （sheared 〈古語〉 shore; shorn sheared）1 剪（羊毛等）；修剪（樹木）；剪（呢絨的）長毛。2 ...
  • deformation : 變形,走樣
  1. Based on the numerical simulation and accuracy analysis to previous slab ' s test with the ansys program, the study of composite wall, with various detail design under potential load action respectively or jointly is carried on and the wall ' s atress behavior and failure mode is obtained, also the influence to wall ' s stiffness and bearing capacity by kinds of factors, including wall ' s shear span ratio, member ' s section, bar arrangement, etc. based on the hammer blow test and stiffness test, a 1 / 3 scale ten - bay model ' s modality parameter and elastic deformation characteristic is analyzed

    在對密肋復合墻板運用ansys ~ （ （ ? ） ）程序進行數值模擬、分析驗證的基礎上，對典型組合墻體在不同連接構造和不同荷載效應組合作用下的受力形態和破壞模式進行研究；計算分析了復合墻體剪跨比、邊框柱截面尺寸、邊框柱配筋大小以及墻板內肋梁肋柱配筋等諸多因素對密肋復合墻體承載力及剛度的影響，得出其變化規律。
  2. The equations of motion governing the axisymmetric elastic deformation of finite orthotropic cylindrical shells, involving the effect of transverse shear and rotational inertia, are derived. by applying the reverberation method, the displacement and the resultant forces of the shell in the phase space are expressed. then the transient waves in the finite orthotropic cylindrical shell subjected to the axisymmetric impact are obtained by using inverse laplace transforms. furthermore, the transient solutions are decomposed to the generalized ray integrals and computed numerically

    分析了計及剪切變形和轉動慣性的有限長正交異性圓柱殼中彈性瞬態波的傳播問題，採用回傳矩陣法，在相空間中給出了位移和內力的表達式。再利用laplace逆變換，得到正交異性圓柱殼受軸對稱沖擊作用時彈性瞬態波解，然後將其分解為若干廣義射線積分之和，並用數值方法求解之。
  3. The deformation of the structure mainly focused on the isolated layers and the superstructure shift as a whole. the interlayer displacement of the isolation system is far low. the earthquake effect of the base - isolated structure is dicided on the horizontal stiffness and elastic and plastic capability of the isolated layer, the base shear, the interlayer shear, th ' e interlayer displacement of the isolation system is far lower than the result of the base - fixed system under the same condition of the superstructure

    橡膠墊隔震結構在水平地震作用下的反應以「整體運動」為主，結構位移主要發生在隔震層，上部結構的層間位移很小。隔震結構的地震反應主要決定於隔震層的剛度和彈塑性性能。其中，隔震結構的基底剪力，上部結構的層間剪力在多遇地震下，比不隔震時均有所降低。
  4. Numerical viscoelastic modeling for porphyroclast rotation in ductile shear zones is done by a viscoelastic finite element program based on detailed investigation to three ductile shear zones, the taihangshan mountains, north china. in this model porphyroclast garnet is assumed as isotropic elastic material with small elastic deformation, while the matrix quartz, feldspar as viscous fluid maxwell material which has increasing deformation with time. the viscosity of matrix is supposed to be 10

    採用粘彈性力學分析程序對太行山阜平地區剪切帶中斑晶旋轉問題進行了有限元數值模擬。在計算模型中假定：石榴石斑晶為彈性材料，在應力作用下只產生很小的彈性變形石英長石質的基質部分為粘彈性材料，它具有隨時間變形不斷增大的特性。
  5. This paper, in allusion to damage of expansion joint of bridge, introduces a sort of new structure of jointless device - semi - integral abutment jointless bridge, and establishes model of general structure finite element of this bridge, and in details analyses its qualities of stress. the model considers the interaction of superstructure - substructure - soil. resistance of the soil behind abutment adopts still soil pressure and elastic resistance when the temperature rising, but active soil pressure when dropping. analysis of qualities stress of bridge includes of action of dead load, car load, temperature load of season character. taking an 100m length pc semi - integral abutment jointless bridge as instance, the paper establishes the model of plane frame by applying large common software - anasys, and analyses it by elastane and large deformation to imitate character of stress and deformation of general bridge. at the same time corresponding models of finite element of joint bridge and integral abutment bridge are established, and unique stress and performance of structure of semi - integral abutment jointless bridge are researched by comparing and analysing character of three different models under same loading, and controlling factor of design and constitution are generalized. in conclusion, for semi - integral abutment jointless bridge, on one hand shear, moment and deflection of the main beam and axis force of substructure are approximate with that of joint bridge, and integral stifmess of structure is increased and damage of expansion joint is eliminated, on the other hand there is axis force in main beam, shear and moment of substructure are bigger than that of joint bridge. in all this type of jointless bridge has rational stress and is worth of application and popularization

    半整體式橋臺無縫橋梁計算模型考慮了上部結構-下部結構-土的共同作用；臺後土抗力升溫時採用靜止土壓力加彈性土抗力，降溫時採用主動土壓力；分析橋梁受力性能時考慮了結構自重、車輛荷載和季節性溫變荷載的作用。以一座橋長100mpc半整體式橋臺無縫橋梁為實例，採用大型通用軟體ansys建立平面框架模型，進行彈性、大變形分析，模擬全橋受力和變形特點；同時建立與此對應的有伸縮縫橋梁和整體式橋臺無縫橋梁有限元模型，通過三種橋型同步加載對比分析，研究半整體式橋臺無縫橋梁獨特的受力特點和結構性能，總結其設計控制因素和構造要求。通過本文研究知：半整體式橋臺無縫橋梁主梁的剪力、彎矩、撓度和下部結構的軸力與梁式橋相近，結構整體剛度增大，併除去了伸縮縫病害；但主梁增加了軸力，下部結構剪力、彎矩較梁式橋大；綜合分析是一種受力合理有實踐和推廣價值的橋型。
  6. Its test specimens are four r. c hollow shear walls with vertical seams ; they have different heights and two loading measures. firstly, studies the stress distribution and deformation of the shear wall in elastic phase with ansys limited element program

    本課題為帶豎縫鋼筋砼空心剪力墻板抗震性能試驗研究，試驗的對象為四個不同剪跨比和加載條件的帶豎縫鋼筋砼空心剪力墻板。
  7. Secondly, the author assumes material is elastic, separately adopts planar model and spatial model of the 6 - 12 - 18 - storey spatial concrete frames reckons in shear deformation and axial deformation and contrastingly analyzes lateral displacement of the frames under taft. e1 - centro and tianjfn seismic wave considering geometric non - linear effect or not in order to find out the rule about geometric non - linear effect on earthquake - resistant behavior of multi - storey and highrise concrete frame structure under strong - motion earthquake. simultaneously, the author weighs the effect of spatial self - bracing function on structural analysis by contrasting lateral displacement between planar model and spatial model of the frames

    其次，作者在彈性材料假定下，對六層、十二層、十八層空間混凝土框架，分別取其空間模型和平面模型，計入剪切變形、軸向變形的影響，按考慮幾何非線性因素與否，分別在taft 、 e1 ? centro及天津地震波作用下，作以對比分析，以找出幾何非線性效應對多高層混凝土框架結構在強震作用下抗震性能的影響的規律；同時，對平面模型與空間模型之間的空間相互作用，均以其幾何非線性情況下的位移反應作對比分析，來衡量空間相互作用對結構分析的影響。
  8. This paper analyzes and designs the big - space rc thin shear wall residential structure, ! ! includes designs and analysis for shear walls by method of material mechanics and related software, columns, it is designed and analyzed for beams and slabs by theory of elastic and method of moment index, but it is principal for beams and slabs to compute deformation and crack. at last it is compared with three structrual types, although the cast of new structrual types is higher than marnoey structre. it has some merits. lt gives the theory base for design of resident

    本文對大開間鋼筋砼薄壁剪力墻節能住宅結構進行了相應的結構分析設計；對豎向承重結構構件剪力墻、柱採用了材料力學分析方法及相應的軟體進行了內力分析及設計；對水平承重結構構件梁、板進行了內力分析及設計，主要進行了變形、裂縫的計算；對節能墻體進行設計；最後對三種住宅結構形式進行了建築經濟比較分析，雖然新型住宅結構高於磚混結構住宅，但新型住宅結構具有一些優點。
  9. Based on the experimental investigation and numerical analysis, the slab ' s shear and bending resistant expression is proposed and a representative wall ' s reliability index under small earthquake is figured out. sensitivity of every factors affecting shear strength is evaluated. the elastic stiffness and deformation of mrs and shear wall structure is compared

    （ 4 ） .密肋復合墻體承載力實用設計表達式的提出根據試驗結果和數值分析，建立了的密肋復合墻體抗剪和抗彎承載力表達式，並對其在地震作用下的可靠性進行了分析，得出了墻體的承載力可靠指標。
分享友人
分享到 Line

分享到臉書