experimental alloy 中文意思是什麼

experimental alloy 解釋
試驗合金
  • experimental : adj 實驗（上）的；試驗性的；經驗上的。 experimental parthenogenesis 人工單性生殖，人工孤雌生殖。 ...
  • alloy : n 1 合金。2 （合金中的）劣等金屬。3 （金銀的）成色，成份。4 〈比喻〉攙雜品。vt 1 合鑄，熔合（金屬...
  1. ( 2 ) design of the implantating device : some quantity of 316l stainless steel, perform forging and thermal rolling, drawing filament ( diameter 0. 4mm and 0. 23mm respectively ), enlacing and jointing, after that assembling the products into guiding filum, a technical examination was carried out to appraise their physical capability. the second part : experimental study : animal experiments were used to screen and observe its validity and security : under general anesthesia, tracheotomy was performed on the healthy dog, the bronchus was localized using x - ray fluoroscopy fibrobronchoscope and with the help of the implanting equipment, several niti alloy occludes were implanted into the target bronchus of the dogs through the biopsy channel in the fibrobronchoscope

    （ 2 ）推送器的研製：取316l不銹鋼熱軋，分別拉製成不同直徑的不銹鋼絲分別用作製作內芯、外環及車制螺絲，再經纏繞、焊接、裝配成推送器。對上述兩者進行技術鑒定。第二部分：支氣管封堵器的實驗研究：四種形狀的封堵器分四組（上述四種封堵器各12隻）進行動物實驗，分別觀察其安全性與有效性。
  2. Abstract : based on the present possessed experimental data of steels with their different major chemical composition, this article formularized the calculation of linear expansion coefficients of fine carbon steels and low alloy constitutional steels through a series of alternate analysis, generalized statistics, curve superimposition and mathematical modeling

    文摘:對優質碳素結構鋼和幾類低合金結構鋼，在現有實驗數據的基礎上，通過迭代分離、綜合統計、圖象分析和數學擬合，得出按鋼的主要化學成分確定其線膨脹系數的計算關系。
  3. The study work in the dissertation is an important part of the tenth five - year defence advanced research project of “ study on control technology of the machining distortion for complex structure parts ” supported by pla general armament department of china. theoretical analysis and experimental study are carried out on the initial residual stresses and their effects on milling distortion for thick aero - aluminum - alloy plate

    本文作為總裝備部「十五」預研項目「復雜結構件加工變形控制技術研究」的主要組成部分，以航空鋁合金厚板為對象，研究重點定位在其初始殘余應力分佈規律及其對數控銑削加工變形的影響。
  4. An experimental study on dynamic penetration performance of fragile tungsten alloy projectile

    鎢合金易碎材料動態穿甲特性試驗研究
  5. An experimental investigation on formability of 1420al - li alloy sheet

    1420鋁鋰合金板材成形性能試驗研究
  6. In chapter 2, the property of libs in cu - pb alloy and the determination of the optimum experimental condition in elemental quantitative analysis are investigated

    第二章研究了鉛黃銅合金固體樣品libs的性質，確定將libs用於樣品雜質元素定量分析時的最佳實驗條件。
  7. The experimental result of superplastic compression indicates that strain rate has intensive effect on flow stress of ti - 1023 alloy and the effect of temperature is related with strain rate

    超塑性壓縮實驗結果表明，應變速率對ti - 1023合金流動應力具有強烈的影響，溫度對流動應力的影響程度與應變速率大小有關。
  8. Based on experimental data, the bp model is built, which reflects the relationship between the mechanical properties, phase transformation points of material and its composition, micro - structure. hardenability curves, alloy composition, austenite temperature, martensite start temperature and yield strength are predicted by means of artificial neural network technology

    本研究在實驗數據的基礎上，採用反向傳播演算法（ bp演算法）建立了反映合金成分-組織-性能之間的定量關系的網路模型，並利用所得到的模型，分別對淬透性曲線、合金成分、力學性能、相變點進行分析和預測。
  9. This paper determines the technological process, bath formularizstion and experimental parameter of electroless multicomponent cobalt based soft magnetic film with rare earth elements joined such as co - ni - b - re and co - fe - b - re by the means of perpendicular experiment and regression analysis. this paper also studies the active mechanism of rare earth elements, ultrasonic irradiation and magnetic field on the plating process, chemical component, surface configuration, microstructure and properties of electroless multicomponent cobalt based soft magnetic film in the way of examining in the component, microstructure and properties of such alloy

    本文採用正交實驗和回歸分析的方法，確定了稀土化學沉積co - ni - b - re 、 co - fe - b - re多元鈷基軟磁薄膜的工藝流程、鍍液配方和實驗參數，並通過對合金鍍層的成分含量測定、形貌結構分析和力學磁學性能評估，研究了稀土元素、超聲波、磁場介入化學沉積多元鈷基軟磁薄膜工藝后，對合金成分、結構和性能的作用機制。
  10. Experimental study on a new type of shape memory alloy intrasegmental fixation instrument for the treatment of lumbar spondylolysis

    腰椎峽部裂翼狀記憶合金節段內固定器的研製
  11. Experimental studies on ductile fracture mechanism of aluminum alloy 2a

    12韌性斷裂機制的實驗研究
  12. Experimental research on stability parameters for i - section aluminium alloy bars loaded by axial compressive force

    工字形鋁合金軸心壓桿穩定系數的試驗研究
  13. In chapter 2, based on the status analysis on the research of milling force, its characteristic is studied for the aero - material of aluminum alloy 7075 - t7351, and the empirical model is established by using the regression - orthogonal experimental method where the factor number is five and the standard number is four

    第二章在總結國內外銑削力研究現狀的基礎上，採用多因素正交試驗研究了航空鋁合金7075 - t7351的銑削力學特性，建立了該材料的銑削力經驗模型，為研究切削力對加工變形的影響提供了依據。
  14. Experimental study of the rabbit fracture healing using niti alloy elastic fixation

    記憶合金彈性固定對家兔骨折愈合的影響
  15. Under the careful retrospection and analysis on the previous and recent experiments about mechanical behavior of nanocrystalline metals performed by almost main investigators, the dislocation and atomic diffusion is believed to contribute hardly to the deformation of nanocrystalline alloy, and a model based on thermal activation process was applied to fit the experimental data of nanocrystalline ag

    結果表明，納米晶金屬ag的不僅具有比粗晶ag高2 - 6倍的拉伸和壓縮強度，而且在大范性形變階段顯示了極低的加工硬化和應變速率敏感性。結合位錯理路和非晶合金形變特徵，提出納米晶金屬ag的塑性變形主要由於晶界滑移貢獻。
  16. Computational simulation in nano size alloy system chapters, we applied an approach to the development of many - body interatomic potentials for niti, nizr alloys, the database used for the development of a potential includes both experimental data and a large set of energies of different structures of the material generated by dft calculations. the molecular dynamic simulation results prove the structure change in nano materials grain size

    納米合金體系的計算模擬通過用dft詳細地對niti二元合金簇的研究導出其原子間相互作用並加以模擬研究納米晶界結構與穩定性，結果表明dft導出的相互作用函數更適合研究納米材料晶界或非晶納米合金行為，而用經驗勢能函數的模擬納米合金相變有很好的模擬結果。
  17. The optimized experimental conditions are determined and the densities of some elements in the mental alloy standard samples are measured. the experimental results shows that the spectral intensity of the plasma enhances significantly with the increase of the operating voltage and the power density. ( 1 ) to the steel ally sample, the emission intensities of the spectra reach to the maximum values when the laser operating voltage is 1600v and the argon pressure is 600 torr. under the same pressure, the spectral intensity of the plasma in the argon atmosphere is stronger than that in the air. when the argon pressure is 320 to rr, the signal - noise ration is about 5 times than that which the argon pressure is 700 torr, but the temperature of plasma is less about 1000k

    （ 1 ）對于光譜標鋼準樣品，當激光器工作電壓為1600v 、氬氣壓力為600乇時，譜線強度達到最大，並且在相同壓強下，氬氣中的等離子體與空氣中的等離子體相比，其輻射強度明顯增強；氬氣壓力為320乇時的譜線信背比約為600乇條件下的5倍，而等離子體溫度卻下降了近1000k ，即等離子體溫度隨環境氣壓的增大而增大；當激光束的焦斑在樣品表面上下移動時，激光誘導量、等離子體的激發溫度、譜線強度都呈不對稱性分佈，其最大值對應的焦斑位置都位於樣品表面之下0 . 4mm左右。
  18. X - ray diffraction ( xrd ), uv - vis absorption spectroscopy and photoluminescence spectroscopy ( pl ) were employed to study the structural and optical properties of mgxzn1 - xo alloy thin films. the experimental results show that the films were hexagonal wurtzite structure and the band - gap of mgxzn1 - xo alloy thin films gradually increased with increasing mg content. the quality of mgxzn1 - xo alloy thin films can be greatly improved by means of annealing in oxygen ambient

    實驗結果表明，利用溶膠-凝膠法制備的mg _ xzn _ （ 1 - x ） o納米薄膜為六角纖鋅礦結構，粒徑為3 5nm ，隨著mg含量的增加帶隙變寬；通過在氧氣氣氛下退火處理后， mg _ xzn _ （ 1 - x ） o納米薄膜表現出了較好的結構和發光特性，表明熱處理可提高薄膜質量。
  19. The experimental results show that the quality of zno films prepared by electron beam evaporation can be greatly improved by means of two - step annealing of metallic zn films in oxygen ambient, and it is feasible to fabricate high quality mgxzn1 - xo alloy films with mgo buffer layers by using thermal evaporation technique following by two - step annealing process. this method gives a new path to prepare mgxzn1 - xo alloy films

    實驗結果表明利用電子束蒸發技術制備的zno薄膜材料，在經過氧氣氣氛下的二次退火處理后，能夠表現出較好的發光和結構特性；以mgo薄膜作為緩沖層制備出了高質量的mgzno合金薄膜材料，這為開展mgzno合金薄膜材料的研究開辟了新的途徑。
  20. Rigidity analysis and experimental validation of aluminium alloy structure repaired by composite material patches

    復合材料修復鋁合金構件的剛度分析和試驗驗證
分享友人
分享到 Line

分享到臉書