fiber press 中文意思是什麼
fiber press
解釋
纖維壓榨機-
Optical fiber coating loose tube, fill in fiber compound, strengthened steel wire in the middle, tube gasket around steel wire as se intertwist, cable fiber fill in cable core, and then coating water blocking tape, double - faced pe outer jacket. best se intertwist protect optical fiber away from drawing and press
光纖被覆松套管，纖膏填充，金屬加強件置於纜芯中心，束管圍繞鋼絲作sz層絞，纜芯內充纜膏，外縱包阻水帶，雙面塗塑鋼帶粘結pe護套。 -
After looking up a large amount of native and foreign information, the materials used in the experiment were as follows : ptfe base, graphite filler, molybdenum disulfide filler, copper powder filler, carbon fiber and so on. the experimental method is that the formula was designed according to uniform experimental method, the relationship between formula and frictional property was found with spline function and then the representative test points were chosen from fitting curve to make verification test for optimization. the preparative technique of solid lubricant is cold - press sintering method
經過查閱大量國內外文獻資料后確定原料為：聚四氟乙烯樹脂為基體，加入石墨、二硫化鉬、銅粉、碳纖維等填料；試驗方法為：根據均勻試驗方法設計配方，用樣條函數找出配方與摩擦性能的關系，然後在擬合曲線上選取具有代表性的試驗點進行驗證試驗，達到優化的目的；制備工藝：冷壓燒結法制備固體潤滑劑。 -
Automatic fiber placement ( fp ) is a new manufacture technique to produce the affordable composite materials. in fp process fiber is placed on the surfaces of the model by the press roller to form composite structure with low manufacture cost, high efficiency and good quality
自動鋪絲技術是一種新型復合材料低成本自動化製造技術，它是通過壓輥傳遞一定的正壓力將纖維鋪設在芯模曲面上形成復合材料殼體結構。 -
It is suggested in this paper that phenolic resin with three components and hybrid fiber were used to prepare clutch friction materials by cold - press process
摘要提出採用三組份改性酚醛樹脂和混雜纖維冷壓工藝制備離合器摩擦材料。
分享友人