filling culvert 中文意思是什麼

filling culvert 解釋
充水廓道
  • filling : n. 1. 裝滿,填裝;填補。2. 填料;填土。3. (糕點內的)餡。4. (織品的)緯紗,漿料。
  • culvert : n. 暗渠,陰溝;【電學】電纜管道;涵洞。
  1. Anteklise filling plans for bridge and culvert structures in expressway

    高速公路橋涵構造物的臺背填築方案
  2. The operation measures for controlling over - filling ( over - emptying ) are feasible ; the hoisting loads of valve and miter gate are less than their design values respectively ; but, there exists cavitation phenomenon needed to pay attention to the first crossover culvert when the value is near and after whole opening

    控制超灌(泄)操作方式可行;閥門、人字門啟閉力均小於設計值;閥門接近全開至全開后,輸水廊道第一分流口有空化現象。
  3. In the simulation and analysis on culvert construction, the method of foundation - pit excavation layer by layer and step by step was used, i. e. the method that makes the surface of excavation have no stress, when the elements were excavated gradually in period of construction. at this process, the state of soil is unloading, the laws of stress field and displacement field with the depth of excavation were studied. based on the obtained stress field and displacement field after the excavation was completed, by using of the newly increased filling - elements " gravity and the grinding force, the simulation of the construction of body of the culvert and foundation - pit ' s filling layer by layer had also been done in this dissertation

    用有限元法模擬分析涵洞基坑開挖時,採用分層、分步模擬開挖過程的方法,即將計算域內單元分層「挖去」 ,使開挖表面成為無應力表面的方法,分析土體在卸載狀態時的應力場和位移場隨開挖深度的變化規律;在洞體施工后,回填土體時,據開挖完成時的應力場、位移場,通過逐級增加計算域內的單元數目,施加每級新增加單元的自重荷載,利用有限元法模擬基坑及上覆土體分層填築的施工過程,這不僅反映土體處于再加載應力狀態時,填土受力及變形的一般規律,而且這種將地基? ?涵洞? ?土體作為一個統一整體進行模擬的方法,量化了三者之間的相互作用關系。
  4. Study on the filling amp; amp; emptying system of three - branched culvert in shiplock bottom

    船閘閘底三支廊道頂縫出水輸水系統研究
  5. According to the design code for filling and emptying system of shiplocks and the layout characteristics of the second line of qililong sea route on fuchun river and the upstream navigation tunnel, the type of the filling and emptying system of shiplocks is determined, the area of the culvert transect at the valve is calculated, and the layout type and key size of the filling and emptying system are recommended

    摘要根據富春江七里瀧航道第二通道工程船閘及其上游通航隧道總體布置的特點,按照《船閘輸水系統設計規范》的要求,確定了船閘的輸水系統型式,並計算了輸水閥門處廊道斷面的面積;推薦了通航船閘輸水系統的布置及關鍵尺寸。
  6. It is proved that polypropylene fiber concrete performs well in resisting impact, abrasion and crack, and thus well applicable in sandy flow region characterized in high speed and turbulence, such as the filling & emptying culvert of shiplock, etc

    表明聚丙烯纖維混凝土具有良好的抗沖耐磨性能和抗裂性能,可較好地應用於船閘輸水廊道等處于高速、紊亂、含沙水流區。
分享友人