finite difference equation model 中文意思是什麼

finite difference equation model 解釋
有限差分公式模型
  • finite : adj. 有限的；【語法】限定的；【數學】有窮的，有盡的。n. 〈the finite〉 有限（性）； 〈集合詞〉有限物。adv. -ly ,-ness n.
  • difference : n. 1. 差異，差別。2. 不和，爭論。3. 【數學】差，差額。4. 【邏輯學】特殊性。vt. 〈罕用語〉區別，使有差別。
  • equation : n. 1. 平衡，均衡；平均，相等。2. 【數學】方程式，等式。3. 【天文學】（時）差；均分，等分。4. 【化學】反應式。
  • model : n 1 模型，雛型；原型；設計圖；模範；（畫家、雕刻家的）模特兒；樣板。2 典型，模範。3 （女服裝店僱...
  1. Based on the navier - stockes equation, the finite difference method was applied to variance the simplified n - s equation on cylindrical coordinate system. then, 3 - d model of the spiral flow locally generated in circular pipe with steady and axial - symmetry condition was founded. the ordinary iterative method of gauss - seidel was induced

    太原理工大學碩士學位論文本文以局部起旋條件下的圓管螺旋流為模擬對象，從以速度和壓強為自變量的微分方程一navier一5tokes方程出發，利用有限差分法對柱坐標系下簡化后的n一s方程進行離散，建立定常的、軸對稱的三維計算模型。
  2. According to energy conservation equation and fusion and evaporation characteristics of electrode materials, a simplified one - dimension mathematical model was made and numerically solved by means of fdtd ( finite - difference time - domain )

    根據能量守恆方程，同時考慮了電極材料的熔解和氣化特性，建立了電極燒蝕過程的一維簡化數學模型，並採用時域有限差分法（ fdtd ）進行了數值求解。
  3. When the author sets up the mathematics model with describing the process of two - dimensional debris flow, he develops the continuity equation by the law of conservation of mass and establishes the momentum equations by the law of conservation of momentum. the author makes full use of the advanced computer technologies, establishes the finite difference equation of numerical simulation by the differential operator fission method, and writes programs for computers which contact friendly with the other programs. the parameters are directly input on the keyboard

    在泥石流堆積數值模擬方面，作者以前人工作成果為基礎，在建立數學模型時，根據質量守恆原理，推導建立了泥石流連續性方程，根據動量守恆原理，推導建立了泥石流運動方程;在數值解法上，充分利用高速發展的計算機技術，採用運算元分裂法建立數學模型的差分格式，開放式編製程序，人機對話方式設置參數，計算機程序具有通用性、可擴展性和易維護性。
  4. The control equation consist of completely coupled deformation equation, seepage equation, conduction and convection equation of heat, which describe the reservoir non - liner performance. 2, present the detailed strategy and methods to solve this mathematics model, the basic strategy as follows : regard the deformation equation ? seepage equation conduction and convection equation of heat as separate system, and solve the equation by coupling and iterative method ; disperse the control equation in the geometry field by the finite element method ( galerkin ), and in the time field by the finite difference method : programme the computer program on this task ; when the solving, take the combinative measures of the thick and thin mesh ; successfully carry out the numerical simulation in vast 3d heat extraction system of hdr

    2 、提出了高溫巖體地熱開發的固、流、熱多場耦合數學模型的數值解法，其基本的求解策略是：將固體變形，流體滲流與溫度場方程看成獨立的子系統，耦合迭代求解；利用有限元離散（ galerkin ）方法將控制方程在幾何域上離散，並用差分法得到時間域上的離散方程，並在此基礎上，編制了相應的計算機源程序；有限元求解中，為減小邊界效應的影響，在計算中採取粗細網格結合的方法，順利地實現了高溫巖體地熱開發三維巨系統的數值模擬。
  5. Based on former work, a finite difference viscous code that uses a high convergence, high accuracy, high resolution lu - sgs - ge implicit scheme and an improved fourth ( fifth ) - order high resolution muscl tvd scheme to integrate the full 3d navier - stokes equations and the low - reynolds number two - equation turbulence model is extended to simulate the flow field inside centrifugal impeller mechanism

    並且在現有工作基礎之上，將基於有限差分方法的高收斂率、高精度、高解析度的lu - sgs - ge隱式格式和四（五）階muscltvd格式求解全三維navier - stokes方程和低雷諾數雙方程湍流模型的計算程序推廣到離心葉輪機械內部流場的數值求解。
  6. The heat transfer of the wall and the internal thermal mass is considered in this model. the control equation can be solved by an implicit finite - difference method

    利用有限差分方法對該數學模型得到的控制方程組進行離散，並對離散得到的差分方程的計算求解過程進行了編程。
  7. Base on the kinematics relation of ctp, the corresponding reynolds equation or average reynolds equation, fluid film thickness equation under qusi - stable state in polar coordinates, balance equations of load and moments under full - film contact and partial - film contact states were set up respectively. these model equations were calculated by the finite difference method, and the instantaneous 3 - d distribution of fluid pressure and the slurry film was simulated by the matlab software

    根據ctp的運動關系，分別建立了極坐標下，全膜接觸工況時的非穩態牛頓流體在ctp過程中的一般reynolds方程、流體膜厚方程、載荷平衡方程和轉矩平衡方程，以及部分膜接觸工況下的平均reynolds方程、平均膜厚方程、接觸壓力方程、總載荷平衡方程和總轉矩平衡方程。
  8. Based on the shale code, the early code of ale, the two dimensional finite difference elastic - plastic flow code hepale has been developed, in which the ideal elastic - plastic model and equation of state of gruneisen are used to describe the solid material, the programmed burn technique is used to simulate the propagation of detonation, and the equation of state of jwl is used to describe the detonation products

    藉助于ale方法的早期程序shale的基本框架，開發研製了二維彈塑性流ale方法計算程序hepale 。程序包含用彈塑性本構模型和gr nrisen狀態方程來描述固體材料的行為；採用jwl狀態方程來描述爆轟產物的性質；採用程序燃燒法來模擬爆轟波陣面的傳播。
  9. The model assimilates the latest results in the research and is solved by numerical approach which is called finite - difference equation 。 combined with experimental system, this model simulates the temperature of the water which comes from ground heat exchangers and the round temperature field

    結合實驗系統和傳熱模型，我們對製冷運行中地下換熱器的出水溫度及周圍溫度場分佈進行了模擬分析，並給出了鉆孔的平均傳熱系數的公式。
  10. This article establish horizontal heat exchanger model and ground temperature renewing in transition season with adoption of energy balance theory and combination thermal conduction equation and reference of vc. mei model, and process simulation and calculation with the methods of finite difference, and the value of testing accords with value of calculation very well

    本文參考vc . mei傳熱模型，採用能量平衡理論並結合熱傳導方程建立了水平埋管換熱器傳熱模型和過渡季地溫恢復模型，並採用有限差分方法進行了模擬計算，實測值與計算值吻合較好。
分享友人
分享到 Line

分享到臉書