gel coating 中文意思是什麼
gel coating
解釋
凝膠塗料-
Preparation process of aerogel films for icf target by sol - gel spin - coating method
靶用氣凝膠薄膜工藝研究 -
In this paper, the al3 + - doped zno thin films were prepared on na - ca - si glass substrate ( microscope slides ) by sol - gel process from 2 - methoxyethanol solution prepared by zinc acetate as premonitor, monoethanolamine as stabilizator and aluminum chloride reaction. homogenous, transparent, polycrystalline zno thin film was formed finally by diping coating conducted for film - plate on substrate, drying, pre - heat - treatment, anealing
所用的溶膠是以乙二醇甲醚為溶劑，醋酸鋅為前驅體，乙醇胺為穩定劑反應制得，用浸漬提拉法在基體上鍍膜，經烘烤、預燒、退火，最後形成均勻、透明的多晶zno薄膜。 -
Among various fabrication techniques of thin film, the sol - gel process has gained much interest for the preparation of pzt thin film, due to ihe advantages of good homogeneity, easy control of composition, low in - ill i reaving temperature, easy formation of large area thin films pb ( zrxti : - k ) 0 :, ( pzt ) films were prepared on the ito coated glass plates and low resistor silicon wafer in sol - gel dip - coating process associated wi di heat treatment : at different temperatures and characterized by x - ray diffraction ( xrd ) and transmission electron microscopy ( tem ). lt is shown that the pzt ferroelectric thin films with ( 110 ) preferred orientation and well - crystallized perovskite structure can be obtained after annealing at 680 ? for 30 minutes on ito substrate and at 800 " c for lornin on silicon substrate
Pzt的制備方法有很多，其中溶膠?凝膠（ sol - gel ）方法可以和集成電路（ ic ）光刻工藝相互兼容，處理溫度低，有大面積塗敷性能，能精確地控制組分，無需復雜的真空設備，成本低廉，所以對于集成鐵電薄膜電容的應用這種方法有很廣闊的前景。本文利用sol - gel技術在摻錫的in _ 2o _ 3透明導電薄膜（ ito ）襯底和低阻硅襯底上成功地制備了pzt鐵電薄膜。運用了x射線衍射， sawyer - tower電路和lcr電橋分別對薄膜的晶化溫度，結構和電學性能進行了測試。 -
Effect of heat treatment on color sol - gel coating glass
熱處理對銅系鍍膜玻璃色彩的影響 -
Effect of annealing temperature on the properties of nickel oxide thin films prepared by sol - gel dip coating
凝膠法制備的氧化鎳薄膜的影響 -
Status and prospects of the sol - gel coating technology
溶膠凝膠塗層技術的現狀與展望 -
Above year productive forces 10, 000 tons, variety specification complete, the versatility, mainly applies in the epoxy, fills seals the material, pours the material, the envelope anticipates the electronic electric appliance, the plastic, the coating, the printing ink, the building material, the silica gel, the tooth material, the ceramics, is fireproof, shi cai, the precision casting and so on as well as other chemical domains
年生產力1萬噸以上，品種規格齊全，用途廣泛，主要應用於環氧、灌封料、澆注料、包封料及電子電器、塑料、塗料、油墨、建築材料、硅橡膠、齒料、陶瓷、耐火、石材、精密鑄造等以及其它化工領域。 -
The technologies i explored consist of photolithography technology, lift - off lithography process, technology of growing silicon dioxide films using sol - gel coating technique, and fabrication of na + - k + ion - exchanged glass waveguide. in this thesis, the experiment principles were investigated and the experimental results were given and discussed
本論文中具體研究的工藝內容有：光刻的工藝參數研究；剝離法光刻工藝的研究；用溶膠凝膠法制備二氧化硅膜； na ~ + - k ~ +離子交換玻璃波導的製作。 -
Then the gel film can be prepared by dip - coating or spin - coating technique on the surface of glass and followed by drying in the ethanol vapor
使用浸漬提拉法或旋轉塗敷法，並通過放在乙醇蒸汽中乾燥，可在玻璃表面得到均勻的凝膠膜。 -
And then, zno thin films were synthesize on quartz and silicon substrates by sol - gel dip - coating and spin - coating. the properties of the films and the effects of growth parameters on the quality of zno films were studied using x - ray diffraction, optical absorption, photoluminescence techniques, etc. to modify the energy gap of the zno, mg2 + was added in the sol - gel solution, and mgxzn1 - xo films were prepared by the same method as that for zno films
利用溶膠凝膠法成功地在石英玻璃和單晶矽片等襯底上制備出了c軸擇優取向的zno薄膜，並利用x射線衍射儀、紫外-可見光光譜儀、熒光光譜儀等對zno薄膜的結構和性能進行了測試、分析，並研究了熱處理參數等條件對zno薄膜性能的影響。 -
Testing methods for paint - part 9 : coating powders - section 1 : determination of gel time of thermosetting coating powders at a given temperature
塗料的試驗方法.第9部分:塗料粉末.第1節:在給定溫度下測定熱固性塗料粉末的膠凝時間 -
Based on the infrared anomalous dispersion of compact alumina film, the character of alumina sols and the processing for fabricating compact alumina film were studied by using sol - gel method, combining dip - dropping, spin - coating method and electrophoretic deposition techniques
本文基於緻密氧化鋁膜的紅外反常色散特性，結合溶膠-凝膠技術，採用浸漬提拉法、旋覆法和電泳沉積工藝，對氧化鋁溶膠的性質和緻密氧化鋁膜的制備工藝進行了研究。 -
A convenient and effective testing system for plastic eacapsulated microcircuit is designed. the testing results show that si3n4 passivation on test chip has the better protection than that without si3n4 passivation, and silicone gel coating can prevent moisture from the surface of the chip more effectively than polyimide coating, and molded plastic from varied manufacturers has the different effect on microcircuit due to its diversity
貯存試驗的結果表明，在晶元上加氮化硅鈍化層比不加鈍化層具有更好的防護效果；與聚酰亞胺膠內塗層相比，硅酮膠內塗層更能有效地阻止水分到達晶元的表面；由於材料本身的差異，不同廠家生產的模塑封裝材料對微電路的影響也不同。 -
( 2 ) zno thin films were prepared on glass substrates by sol - gel spin - coating method. the optical properties and surface morphologies of the films were investigated using photoluminescence ( pl ), optical transmission spectra, and atomic force microscope ( afm ), respectively
（ 2 ）利用sol - gel旋塗法在普通蓋玻片上生長了zno薄膜，用光學透射譜、光致發光譜和原子力顯微術研究了zno薄膜的光學性質和表面形貌。 -
Methods of test for paints - testing of coating powders - determination of gel time of coating powders
塗料試驗方法.塗粉試驗.第j3部分:塗層粉末凝膠時間測定 -
Prepared technical parameters were optimized by l9 ( 34 ) experiment analysis. a unique method for cleaning and drying of substrate - cleaning used by scour, drying used by infrared light was fished out by large numbers of experiment. chemical mechnism of zno thin film prepared by sol - gel technique was discussed by dta for the first time. by the measurements of sem, xrd and uvs, the thin film was analysed. the result proved that the thin film with strongly preferred orientation of c - axis perpendicular to the substrate surface which surface was homogenous, dense and crackfree was the crystalline phase of hexagonal wurtzite. the thin film was composed of plentiful asteroidal crystal which crystal dimension approximately 10 30nm. the average transmittance of thin film in visible region was above 90 %. the results of measurements else also proved that the thickness of single dip - coating was 75 240nm, this films resistivity was found to be 3. 105 102 3. 96 105 ? cm. the thickness and resistivity of thin film influenced by dope - content, withdrawal speed, pre - heat - treatment, anealing were reseached respectively
利用xrd 、 sem以及uvs光譜儀等分析方法對薄膜進行了研究，結果顯示，所制備的薄膜為六方纖鋅礦型結構，具有高c軸擇優取向性；表面均勻、緻密，薄膜材料由許多星狀晶粒組成，晶粒尺寸大約為10 - 30nm左右；薄膜可見光透過率平均可達90 % ；對薄膜厚度以及電學性能進行了測定后發現：單次鍍膜厚度約為75 - 240nm ， al ~ （ 3 + ）離子摻雜型氧化鋅薄膜的電阻率在3 . 015 102 - 3 . 96 103 ? cm范圍內；分別研究了摻雜濃度、提拉速度、預燒溫度、退火溫度等工藝參數對薄膜厚度和電阻率的影響。 -
Standard test method for gel time of thermosetting coating powder
熱固塗料粉的膠凝時間的標準標準試驗方法 -
A new improved method of fiber tip fabrication was put forward, which is a coating technique of sol - gel tio2 film on the surface of the fiber tip for improve its anti - pollution capacity
提出了傳感頭製作的改進方案，即採用溶膠-凝膠法在光纖尖上鍍一層tio _ 2膜來提高光纖尖的抗污染能力。 -
The licoo2 coating is deposited by sol - gel process, which enhanced the uniformity of the surface coverage
陽離子（ co卜和zn入）摻雜在高溫下將使limno 。 -
Thin films with thickness of 0. 31m and 0. 36m respectively on si substrate, have been successfully prepared by a sol - gel spin coating method. cubic nanocrystals can be obtained at relatively low sintering temperature with an average grain size of about 47 nm and 51 nm respectively. the aluminia - doped scsz thins film are the same dense as the scsz thin films. however, there are a small amount of pinholes found in the microstructure of the titania - doped scsz films
0 . 70固體電解質納米晶薄膜。燒結實驗結果表明，兩種薄膜均在650以上開始晶化，溫度越高，晶化越完全，在800可完全晶化所得納米晶顆粒呈純的螢石結構立方相鋁和鈦摻雜的納米晶顆粒的平均大小分別為47和51nm 。
分享友人