influence of aging on 中文意思是什麼

influence of aging on 解釋
老化所造成的影響
  • influence : n 1 影響，感化 （on; upon）。2 勢力，權勢。3 有影響的人物[事物]，有權勢的人。4 感應。vt 1 影響。2...
  • of : OF ＝Old French 古法語。
  • aging : n. 1. 陳釀。2. 熟化。
  • on : adv 1 〈接觸、覆蓋〉上去；開（opp off）。 turn on the light [radio water gas] 開電燈[收音機、自來...
  1. The admixing technology aging mechanism and the influence of rubber powder on the performance of asphalt were studied

    研究了膠粉和瀝青的摻配工藝，分析了廢橡膠粉改性瀝青的老化機理。
  2. In this paper, 6013al / sicp / gr metal matrix composite ( mmc ) was produced by spray codeposition, by means of changing the medium of quenching, influence of five types of heat treatment system ( furnace cooling, air cooling, water quenching, dry ice quenching, liquid nitrogen quenching ) and different aging temperature on the damping was studied systematically

    本文採用噴射共沉積方法制備了6013al sicp gr金屬基復合材料（ mmc ） ，通過改變淬火介質，較為系統地研究了五種熱處理制度（爐冷、空冷、水冷、乾冰冷及液氮冷）以及不同時效溫度（ 120 、 150 、 170 、 190及210 ）對6013al sicp grmmc阻尼性能影響。
  3. The investigation of a lot of parameters about treated sandstone, brick materials and earthen materials with fluorited polymers has been carried out, such as the formation of polymer, the penetration depth, porosity, capillary absorption and penetration coefficient, water uptake, compressive strength, drilling resistance, absorption isotherms of water vapor, water vapor diffusion, color changes as well as resistance to desegregation of water, frizzing - throwing cycles, worming - cooling cycles, and so on. in addition, the influence of salt crystallization, acid and base, and uv aging have also been assessed in order to better understand the protection effects and utilization possibility of two fluorinated polymers, mainly according to astm standard and the combination of international methods together with general technological

    分別以國家級文物保護單位的土質、砂巖和磚材文物樣品為對象，依據astm標準及國際通用文物保護研究方法與評估準則相結合，通過膠化物形成周期、滲透深度、孔隙度、毛細吸水和滲透系數、持水量、抗壓強度、抗鉆強度、吸附水蒸氣的能力、透氣性、外觀顏色等系列參數的測定，及凍融、冷熱循環、酸堿腐蝕后抗壓強度的衰減、可溶鹽對保護效果的影響、酸堿及光照對表面保護效果的影響，對兩種含氟聚合物及其與有機硅的共混物在文物加固保護和表面防護中的可行性和保護效果給予了系統研究。
  4. In the third chapter, the influence of current density, solution concentration, erosion time and aging in ambient air on the pl spectra of ps suggests that peak would blue shift with current density increasing, and with erosion time and aging time prolonging ; with the increasing of solution concentration, peaks would red shift when solution concentration less than 1 : 1 but blue shift when solution concentration greater than 1 : 1. above phenomena can be explained by quantum confinement and light center model, but do not deny the action of si - h bonding and defect on the surface in the process of photoluminescence. at present, radiation mechanism is still one of the primary problems in the study of ps

    在第z三章中；通過對比，分析了電流密度、陽極化時間、溶液濃度以及自i然氧化時間對多孔硅光致發光光譜的影響，認為在一定的范圍內，多i孔硅的發光峰位會隨電流密度的增大而藍移，要獲得較強的發光，需z要選擇合適的電流密度；隨著腐蝕時間的延長，多孔硅的發光峰位會i發生藍移；當f酸的濃度較小q ： 1 ）時，峰位隨濃度的增大表現為向i低能移動；而當f酸的濃度較大河山時，峰位隨濃度的增大則表現z為移向高能；多孔硅在空氣中自然氧化；其發光峰位發生藍移，而強i度隨放置時間的延長而降低。
  5. The results showed that sequence and way of feeding, reaction temperature, time of aging, stirring speed and drying and calcinations had remarkable influence on the pore structure

    結果表明，加料順序、加料方式、成膠溫度、老化時間、攪拌速率以及乾燥焙燒等因素對孔結構均有明顯影響。
  6. In early stage of aging, cerium lessens influence of coplanar slip on anisotropy by making " phase particles smaller and more disperse, while it makes contribution of t1 phase to anisotropy contrary to that of textures

    在時效早期， ce通過細化和彌散化相來減弱共面滑移對各向異性的貢獻；而在整個時效過程中， ce均使t _ 1相對各向異性的貢獻與形變織構對各向異性的貢獻相反。
  7. The influence of china ' s aging population on its economy and the countermeasures

    21世紀日本人口問題與經濟發展
  8. An investigation on the influence factors and regularity of aging memory changes

    增齡性記憶改變規律及影響因素的研究
  9. According to the general principles of biomineralization, we used many functional organic templates, which can efficiently interact with caco3 crystal, to control the crystal form and the morphology of caco3. many systematic studies o f the influence of various experimental parameters, such as ph of solution, concentration of additives and caco3, temperature, aging time, etc., on the morpho - logy and size of caco3 crystals are investigated

    我們系統地分析了各種實驗參數，例如溶液的ph值、有機大分子的濃度、碳酸鈣的濃度、環境溫度、陳化時間等對碳酸鈣粒子形貌及大小的影響，合成出了一系列具有奇異形貌的碳酸鈣材料，豐富了碳酸鈣形貌的種類，並對這類材料的礦化機理進行了較深入的研究。
  10. But due to the historical influence by the plan economy, aisc has been facing many difficulties. it is a fact that both the ideas and the equipment are aging, the products are outdated, the supernumerary is excessive, both the obligation and society burden are heavy, system conversion is hard to achieve, and the market competitive ability has been lower year by year, etc. particularly with the market economy, it had been ever on the edge of deficit

    鞍鋼是我國大型國有企業之一，有著輝煌的發展歷程，但由於計劃經濟的影響等歷史原因，鞍鋼處于觀念老化、設備老化、產品老化、冗員多、債務重、社會負擔重、機制轉化難、市場競爭力逐年降低的困境，尤其是進入市場經濟后，企業一度跌入虧損的邊緣。
  11. The segregation mechanism of tramp element sn during continuous cooling and isothermal aging and its influence on the hot ductility of low carbon steel are discussed and the brittleness during continuous casting of the sn - doped low carbon steel is forecasted. at a strain rate of 10 - 2s - 1 and a cooling rate of 10 / s, there exists a third ductility trough for both steels at 750

    在應變速率和冷卻速率分別為10 ~ （ - 2 ） s和10 s的條件下進行熱模擬拉伸時，兩種試驗鋼均在750時出現由先共析鐵素體沿奧氏體晶界呈薄膜網狀析出所引起的第類脆性谷底。
  12. Based on the fast freeze - thaw test, the alkaline resistance test, the water immersion test, the wet thermal exposure test and artificial accelerated aging test, the influence of the corroding environment on the mechanical behavior of fiber reinforced polymer ( frp ) laminates and adhesive was studied

    摘要通過快速凍融試驗、耐堿性試驗、浸水試驗、濕熱暴露試驗、人工加速老化試驗，研究了腐蝕環境對纖維增強復合材料（ frp ）的復合體及粘結劑力學性能的影響。
  13. ( 2 ) the influence of content of sbs on the temperature sensitivity, performance under high temperature, anti - crack ability under low temperature, elasticity, anti - aging ability of substrate asphalt is studied. the influence of content of sbs on the water - stability, property under high temperature and anti - crack ability under low temperature of asphalt mixture is also researched. the suitable content of sbs is 6 %

    （ 2 ）研究了改性劑用量對瀝青的溫度敏感性、高溫特性、低溫抗裂性、彈性及耐久性的影響，同時研究了改性劑用量對瀝青混合料的水穩定性、高溫特性和低溫抗裂性的影響，認為6 %的sbs加入量比較適合。
  14. 6013 aluminum alloys containing different main alloying elements minor alloying elements were designed and prepared by ingot - metallurgy processing. the tesile mechanical and aging properties of the studied alloys were tested ; the microstructure of those alloys were observed and analyzed using optical microscope ; the influence of main alloying element mg, si, minor alloying elements mn, cu and homogenization process on the structure and property of studied alloys were studied

    採用鑄錠冶金方法，設計並制備了不同合金元素含量的6013鋁合金，將鑄錠熱加工以後，測試了合金的拉伸力學性能和時效性能，採用金相顯微鏡觀察分析了合金的顯微組織結構，研究了合金中主合金元素mg 、 si ，微量元素mn 、 cu添加量、均勻化溫度和時間對合金組織和性能的影響。
分享友人
分享到 Line

分享到臉書