laser power 中文意思是什麼

laser power 解釋
激光功率
  • laser : n 鐳射激光，受激發射光，激光；萊塞；激光器，光激射器 （ ＝ light amplification by stimulated emis...
  • power : n 1 力，力量；能力；體力，精力；（生理）機能；〈常 pl 〉才能。2 勢力，權力，權限；威力；政權；權...
  1. And the dependences of the depth of exposal on exposal time as well as on laser power are studied

    然後在實驗上研究並分析了曝光深度隨曝光時間的變化規律和曝光深度隨曝光功率的變化規律。
  2. It is found that with fixed laser power and increasing exposal time, the increasing of the depth of exposal grows slower, the exponential increasement can be express by the equation :, the depth of exposal becomes satured with increasing exposal time ; with fixed exposal time and increasing laser power, the depth of exposal increases linearly and can be express by the equation : y = 40

    結果表明，當固定曝光功率，不斷增加曝光時間時，曝光深度的增加趨于緩慢，程指數曲線形式變化，可表示為，當曝光時間不斷增加時，曝光深度的增加趨近於飽和;當固定曝光時間，不斷增加曝光功率時，曝光深度程線性趨勢增加，可表示為y = 40 . 5x0 . 151y = 0
  3. The feasibility and some advantages of employment of sil have been discussed. the numerical aperture are calculated when laser pulse is defocusing. in contrast with traditional microscopy objective, the employment of solid immersion lens can effectively increase the numerical aperture of the recording system ; thereby it can increase the volumetric density and decrease the demand of the incident laser power

    當脈沖聚焦點相對于固體浸沒透鏡底面離焦時，對系統的有效數值孔徑進行了計算，結果表明採用固體浸沒透鏡離焦的方式進行記錄，系統的有效數值孔徑最低可增大到固體浸沒透鏡插入前的折射率倍，其數值孔徑的理論極限值為存儲介質的折射率。
  4. Effect of laser power on microstructures and wear properties of wcp ni metal ceramics coating

    基金屬陶瓷塗層的組織與磨損性能的影響
  5. Research on metrology method for laser power and energy

    激光功率能量計量方法研究
  6. The results showed that increasing scan rate and decreasing laser power can minish balling effect to a certain extent

    研究表明，適當提高掃描速度或減小激光功率可以在一定程度上減小316不銹鋼粉末激光燒結的球化效應。
  7. Laser power meter 946 1064 1342 nm dpss laser

    473 457 nm半導體泵浦藍光激光器
  8. Based on the analysis of the effect on the maximum range of the equation ' s each parameter and the traditional method of extinction ratio, the noncooperative regulable attenuation - measure the minimum detectable power of laser altimeter on the condition of constant miss probability by attenuating the laser power transmitting to the diffuse reflected simulant target - was put forward

    在傳統的消光系數法基礎上，根據對月測距方程各系數的影響權重分析，提出了非合作目標可調衰減法，即：通過對漫反射模擬目標，衰減出射激光功率，在一定的漏警概率條件下測量激光高度計的最小可探測功率。
  9. We analyze the influences of the perturbed energy - level space and superposion, laser power and intermediate level offset on quantum interference. experimentally, in the sodium dimmer rhomb - type four - level system with a pair of perturbed levels, the interference enhancement of two - photon absorption caused by coherent superposition of the perturbed levels is experimentally observed

    分析了微擾能級的間隔和疊加程度、激光功率以及中間能級的失諧對量子干涉效應的影響，實驗上觀察了包含有一對微擾疊加中間能級的菱形四能級系統中的雙光子激發現象，發現微擾能級的相干疊加可增強雙光子吸收。
  10. Remote control system for high voltage laser power supply based on can bus

    總線的高壓激光電源遠程控制系統
  11. Improving design of a yag pulsed laser power system

    脈沖激光電源系統的改進設計
  12. The paper has founded the model of laser transmission in launch process and the movement model of laser - powered vehicle, and has analyzed the influence on performance of launch system, which was raised by some factors, for instance, the performance of thruster, the attenuation in transmission, the height of mode - transform, the laser power, the air drag force, the launch height, and so on

    本文研究了激光推進微小衛星發射系統的概念和性能。建立了發射過程激光傳輸和激光推進運載器運動模型，分析了推進系統性能、大氣傳輸衰減、模式轉換高度、激光器功率、大氣飛行阻力、發射點高度等因素對發射系統性能的影響。
  13. The relation between area of ccd saturation and 0. 632 m 、 1. 06 m laser power / energy was measured. the ccd camera was disturbed by strong radiation from laser outside the field of view in experiment. the relation between the area of ccd saturation and off - axis angle was measured

    通過實驗，得到激光干擾ka - 320型面陣ccd光電探測器的像元飽和閾值、探測器靶面飽和閾值、局域損傷閾值，並得到了0 . 632 m與1 . 06 m波段入射激光功率與ccd靶面飽和程度的對應關系曲線，了解了面陣ccd探測器受激光干擾的各個階段。
  14. The laser power is detected through the pd ’ s movement across the faculous region. when the value of the peak value of laser power is got, the power of the facular boundary points can be found according to definition of the facular boundary such as “ 1 / e ~ 2 ” theory. then the equation of the facular boundary can be made fitting by using the least square method, and calculate the beam divergence at last

    採用兩個光電探測器分別檢測光束不同高度上的兩個光斑，在確定光斑中心最大光強值后，根據光斑截面尺寸的1 / e2定義，得到光斑截面邊界點的光強值，並以其為標準判定光斑截面的邊界點，對探測到的邊界點通過最小二乘法進行擬合，得到橢圓光斑截面的方程，根據空間幾何關系求出發散角。
  15. Then the key process parameters of laser bonding, including laser power, scanning velocity, and initial temperature, are obtained with the help of scanning experiments

    運用該模型計算了不同的工藝參數條件下硅玻璃的溫度場分佈，並由此得出鍵合線寬。
  16. Experimental study on that 532nm 、 1064nm 、 1319nm 5khz frequency pw laser irradiate the ccd respectively. with the data of experiment, the thresholds of laser power density that induce ccd saturation, crosstalk and irreparability damage were calculated. the phenomenon that 532nm 5khz laser can induce part of ccd functional damage but absolutely damage was found

    根據實驗數據計算了532nm 、 1064nm高重頻脈沖激光使ccd出現飽和、串擾以及被破壞的功率密度閾值;實驗發現一定功率密度的高重頻532nm脈沖激光可以使ccd局部損傷而不致整體破壞;實驗進一步證實了1319nm激光不能使可見光ccd產生響應。
  17. On describing a genetic algorithm ( ga ), we present a method for applying ga to optimize the lasers. a programming is presented for obtaining the maximum laser power. by using the method we optimize the cvl and the co2 laser, including lc circuit parameters of the cvl, the cvl system, the lasing resonator and the gas components mixtured in the co2 laser tube

    在這個部分中，首先簡述了遺傳演算法，討論了應用遺傳演算法來優化激光器的思想和方法，給出了優化大功率激光器的計算機程序設計；然後，對銅蒸汽激光器lc放電電路、大口徑激光器和激光器系統分別進行了優化；對二氧化碳激光器諧振腔和氣壓參量分別進行了優化，介紹了優化二氧化碳激光器諧振腔的實驗以及實驗所獲得的結果
  18. We firstly summarize the development of yb - doped fiber lasers, pumping methods and the applications of high - power fiber lasers. 2. considering the scattering loss, we deduce the relationships between laser performances of yb - doped double - clad fiber laser and parameters of laser cavity from the steady state rate equations, numerically analysis the changes of laser performances, such as laser power with the parameters of laser cavity, including output mirror reflectivity, optimum length of double clad fiber

    研究主要內容包括如下幾個方面:一、首先對摻鐿光纖及摻鐿光纖激光器的發展狀況、包層泵浦技術和高功率光纖激光器的應用等進行了綜述;二、在前人對高功率雙包層光纖激光器的理論基礎上，在考慮了光纖散射損耗因子的情況對光纖激光器理論進行了推導，給出了準解析解，進一步完善了理論分析。
  19. This paper gives a description of discharge tube, mirror, laser head and laser power supply of an air cooling argon laser which output is over 1w, and shows its properties

    介紹輸出功率超過1w的風冷氬離子激光器的放電管、反射鏡、激光器頭部和激光電源的設計考慮，給出了它的性能。
  20. At the risk of oversimplification we present an argument that predicts the proper dependence of the average laser power.

    我們冒著過于簡單化的風險而提出一種論點，這種論點能預示出激光功率的適當的內在聯系。
分享友人
分享到 Line

分享到臉書