leakage test 中文意思是什麼

leakage test 解釋
密封性試驗。

  • leakage : n. 1. 漏，漏出。2. 泄露。3. 漏出物，漏出量。4. 【商業】漏損率；漏損量。
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  1. There are over 80 sets test apparatus in tech - innovation centre, including : anechoic chamber, vibration tester, vibration measurement analysis, impact instrument, constant temperature and humidity facilities. salt spary test case, circle insulation withstand voltage tester, insulation resistance tester, withstand voltage tester, electric lead tester, electrical leakage tester, earth resistance tester, chassis dynamometer, chassis dynamometer control system, high stability dc resistance tester, electrical capacity tester, temperature rise test system

    中心擁有各類分析測試儀器和試驗裝置80餘臺套，包括：消音室振動臺噪聲振動測試分析系統沖擊儀恆溫恆濕實驗儀鹽霧試驗箱匝間耐壓分析儀絕緣電阻分析儀對地耐壓分析儀泄露電流測試儀對地電阻測試儀測功機測功機控制系統高精度直流電阻測試儀電參數測試儀帶電溫升測試儀復合式三坐標測量儀萬分投影儀及電功測試分析系統等。
  2. Laboratory equipment - gloves boxes - part 2 : leakage test

    實驗室設備.手套箱.第2部分:泄漏試驗
  3. Air leakage test procedure for electrical connectors

    電連接器.空氣泄漏試驗
  4. Sealed radioactive sources - leakage test methods

    密封放射源.漏泄試驗方法
  5. High speed grease leakage test rig design for carden joint

    十字萬向節油脂泄漏高速試驗臺設計
  6. Electric connectors - air leakage test

    電氣連接器.空氣滲漏試驗
  7. The heat coefficient changing of the heater and reheat ; c. the leakage test of the working substance ; d. the damage test for the heat pipes of the radiator, were taken

    分析了穩態參數，完成了：吸熱器熱負荷擾動試驗、吸熱器及回熱器換熱系數變化試驗、工質泄漏試驗、輻射器熱管損壞試驗等多個模擬實驗。
  8. Research of thermal engineering performance test facilities for refrigerated containers - the test standards and methods are deeply analyzed. airtightness test, heat leakage test and performance test ( with refrigeration unit ) are done on the developed test facilities. the process of the experiment system, used hi measuring the thermal engineering properties of refrigerated containers, is thoroughly discussed

    氣密性實驗結果顯示，箱內、外的溫度波動范圍處於15 25之間，箱內、外的壓差處於250 10pa范圍內，平均漏氣率為2 . 38 （ m / h ） ，遠遠低於極限值10 （ m / h ） ，被測試的冷藏集裝箱的氣密性符合規范要求。
  9. Fabrication and inspection method for high pressure urea equipment ammonia leakage test the method for high pressure urea equipment

    尿素高壓設備製造檢驗方法.尿素高壓設備氨滲漏試驗方法
  10. Gas leakage test for fiber optic cable

    光纜的氣體泄漏試驗
  11. Sealed radioactive sources - part 4 : leakage test methods for recurrent inspections

    密封的輻射源.第4部分:循環檢驗的泄漏試驗方法
  12. Back - leakage test

    背部泄漏試驗
  13. Method for leakage test of gas cylinders

    氣瓶氣密性試驗方法
  14. Remote leakage test comparing with on - the - spot leakage test underground in coalmines

    煤礦井下遠方與就地漏電試驗的比較
  15. Dielectric air leakage test method for trunk, feeder and distribution coaxial cable

    干線饋電和配電同軸電纜用絕緣材料漏汽試驗方法
  16. Ii heat leakage test shall be carried out to establish the heat leakage for the refrigerated container. the inner heating method only shall be used. three heating device shall be placed inside the insulated body of the container and thermal equilibrium shall be established between the power of the heating devices and associated fans, and the heat flowing out through the insulation

    機械式冷藏集裝箱的製冷性能實驗（ 2 ）是將加熱器按公式q = c u （ t - t ）的值對箱內加熱（ c為附加熱負荷q占漏熱量的比例系數） ，且計算出系數c的值為0 . 14 ，大大低於iso規定的0 . 25 ，在投入附加的熱負荷后，冷藏集裝箱仍能保持箱內設定的溫度。
  17. This test shall be carried out after all structural tests have been completed and prior to the heat leakage test. for the said refrigerated containers, the air leakage rate, expressed hi standard atmospheric conditions is 2. 38 m3 / h, not exceed 10m3 / h

    機械式冷藏集裝箱的製冷性能實驗（ 1 ）的測試結果為箱內平均溫度： - 18 . 03 ；箱外平均溫度： 38 . 02 ，試驗條件滿足規范要求。
  18. Put forward the emphasis of preparing work and trial run before a new built pet plant start - up, including working out the network plan, washing the equipment and pipe system, calibrating the plant, and making the leakage test, the linkage and feeding trial run

    摘要提出了新建聚酯裝置投產前工作準備和試車工作的要點，包括網路計劃的編制，設備及管道系統的清洗，裝置的標定，泄漏試驗，聯動試車及投料試車。
  19. Sealed radioactive sources ; leakage test methods as part of production and prototype testing

    密封放射性材料.第3部分:當作生產和原型試驗一部分的
  20. The study instructs simulating valve leakage experiment, perfects valves leakage test technology and bases theoretically for applying valve leakage test in practice. the test stand is constructed and instrumented to accept a variety of valves in order to determine which characteristics of acoustic emission change with leakage rate. the data for each valve type is generated by varying valve type and working medium

    建立模擬在用承壓閥門內漏實驗臺，研究典型閥門內漏聲源的聲學特性，確定聲發射特徵參量與泄漏率的關系，為定量評價閥門泄漏率提供實驗數據；通過對不同類型、不同規格、不同工作介質下的典型承壓閥門內漏的實驗研究，確定閥門內漏最佳檢測區域，建立在用承壓閥門內漏聲學檢測方法。
分享友人
分享到 Line

分享到臉書