lna low noise amplifier 中文意思是什麼

lna low noise amplifier 解釋
低噪聲放大器
  • lna : 低噪聲放大器。接收機的第一級放大器,用來對手機接收到的微弱信號放大。若該電路出現故障,手機會出現接收差或手機不上網的故障。
  • low : adj 1 低的;淺的,矮的。 low flight 低飛。 a low temperature 低溫。 low tide [water] 低潮。 The g...
  • noise : n 1 聲音,聲響。2 叫喊;嘈雜聲,噪音;喧鬧聲;吵鬧,騷動,騷擾。3 〈古語〉謠言,風聲。4 〈美國〉...
  • amplifier : n. 1. 【電學】擴大器;擴音器。2. 放大鏡;放大器。
  1. Low noise amplifier ( lna ) is widely used in front end of a received set of mobile communication 、 wireless radio 、 blueteech technology and so on 。 the active device is the core of the circuit and has significant effects on the whole equipment, therefore, the design of the active device is vital in lna

    微波低噪聲放大器( lna )廣泛應用於移動通訊、無線電、藍牙技術等的rf前端。 lna中的有源器件是整個電路的核心,對整個放大器電路的性能有著重要的影響,因此有源器件的設計是lna的關鍵技術之一。
  2. So, we designed a fully integrated low noise amplifier ( lna ) for 2. 4ghz rf front - end receiver on satellite

    針對此,本論文完成了一個2 . 4ghz衛星射頻前端接收電路的全集成差分cmos低噪聲放大器( lownoiseamplifier )的設計。
  3. Secondly, a method which can prejudge the gain and noise figure of the low noise amplifier ( lna ) is put forward. with this method, we can prejudge the feasibility of lna design once the s - parameter and noise parameter of the device are gained. the design process is considerably simplified compared with traditional methods

    隨后對低噪聲放大器進行了探討,提出了一種可預測增益和噪聲系數的方法,只要知道器件的s參數和噪聲參數,就能對放大器設計的可行性進行預測,相對于傳統作法,設計過程得到了大大簡化。
  4. Low noise amplifier ( lna ) is a key component in the front - end of rf transceiver

    低噪聲放大器( lna )是無線收發機前端的關鍵電路之一。
  5. With lna low - noise - amplifier

    帶lna低噪聲放大器
  6. To date, most research on cmos rf circuits is focused on cmos rf front - end including some key building blocks such as low - noise amplifier ( lna ), mixer, bandpass filters, voltage control oscillators and power amplifiers. in si rf 1c, inductors need be realized on a silicon substrate along with all of the other devices in a single chip. in fact, the need for high q integrated inductors in rfics is increasing

    在無線通信技術對cmos射頻集成電路需求的大背景下,本論文在大量深入調研的基礎上,圍繞射頻集成電路中必不可少的、有多種應用的無源器件?硅集成電感及其相關的cmos射頻集成單元電路,先後在上海冶金所微電子分部工藝線上及利用上海市科委的多目標晶元項目( mpw )在無錫華晶上華半導體有限公司進行了大量的實驗研究,得到了一些新的結果。
  7. In view of the importance of rf front - end circuits in the receiver system, the paper finally is focused on the analysis and design of the rf front - end circuits, including the design of low noise amplifier ( lna ), microstrip filter and balanced mixer. all the circuits above are simulated individually using ansoft serenade, and the results are satisfying with the desired performance

    考慮到射頻前端電路性能的好壞會直接影響到整機的性能,文中還重點論述了該接收機射頻前端電路的分析和設計,主要包括低噪聲放大器、微帶濾波器和單平衡混頻器的理論分析和實際設計,並在ansoftserenade環境下進行了模擬模擬,模擬結果符合設計要求。
  8. Lna low noise amplifier

    低噪聲放大器
  9. Lna : low noise amplifier

    低噪音放大器
  10. S - band mini microstrip low noise amplifier ( lna ) is designed and discussed

    摘要對具有極低噪聲系數的超小型微帶放大器進行了設計和討論。
  11. A low noise amplifier ( lna ) and a mixer realized in standard digital cmos technology are presented in this thesis

    本文設計了基於標準的數字cmos工藝的低噪聲放大器和混頻器。
  12. The full noise and linearity analysis of the low noise amplifier ( lna ) constructed by cascode structure with source degeneration and the optimization methods of the two mosfets in this structure according to the noise and linearity performance

    I對共源共柵矚ascode )源極去耦舊ourcedegeneration )結構低噪放做了完整的噪聲和線性分析,得到該結構中兩個mosfet針對噪聲性能和線性性能的優化方法。
  13. Low noise amplifier using fet is adopted in the rf block of smart antenna both at 3. 95ghz and at 1. 9ghz. in the design process of lna, the author applies genetic algorithm in the optimization of gain and noise figure

    兩套射頻電路的低噪聲放大器電路均採用了兩級場效應管放大,在其增益及噪聲的優化過程中採用了遺傳演算法這一全局搜索性能較好的數值演算法。
  14. We decide to use seven - sections coupled - line filter after comparing the various filter circuits, and complete the quantitative analysis and optimization design by ads, hfss etc. ( 2 ) three - stages fet low noise amplifier according to the lna ’ s design theory and guide line, we decide to use ne3210s01 fet and choose the form of three - stages, thus we can achieve high stability, low noise and high gain

    通過對各種帶通濾波器電路方案進行比較,確定採用七階平行耦合微帶濾波器,並利用ads , hfss等工具進行了定量的理論分析和優化設計。 (二)三級聯低噪聲放大器根據微波lna設計原理及指標要求,我們選用ne3210s01系列低噪聲管,並採用三級放大的形式,以期獲得高穩定性,低噪聲,高增益。
  15. As a key component of rf front - end, broadband low noise amplifier ( lna ) becomes important in the sdr receiver

    寬帶低噪聲放大器作為接收機射頻前端的關鍵部件之一,在軟體無線電中起著重要的作用。
分享友人