low-frequency power amplifier 中文意思是什麼

low-frequency power amplifier 解釋
低頻功率放大器
  • low : adj 1 低的;淺的,矮的。 low flight 低飛。 a low temperature 低溫。 low tide [water] 低潮。 The g...
  • frequency : n. 1. 屢次,頻仍,頻繁。2. (脈搏等的)次數,出現率;頻度;【物理學】頻率,周率。
  • power : n 1 力,力量;能力;體力,精力;(生理)機能;〈常 pl 〉才能。2 勢力,權力,權限;威力;政權;權...
  • amplifier : n. 1. 【電學】擴大器;擴音器。2. 放大鏡;放大器。
  1. The experimental result expresses that the frequency doubler - power amplifier sets of ka - band can supply good local oscillation source for " millimeter - wave front - end of " lmds " ". the model has the advantages of low cost, small size and high reliability

    實驗結果表明,倍頻放大組件能夠為lmds毫米波前端提供很好的本振源,並且具有成本低、體積小、可靠性高等優點。
  2. Chapter 5 is about the design of millimeter wave solid circuit included frequency multiplier, low noise amplifier, medium power amplifier, mixer, if amplifier lastly, based on the work above, a millimeter wave t / r module is developed and the analysis of the result is also introduced

    第五章毫米波固態電路,詳細分析了毫米波倍頻器、低噪聲放大器、毫米波放大器、混頻器的理論,製作了毫米波混頻器、毫米波放大器、中頻放大器、倍頻器等有源電路。最後,在上述基礎上製作了毫米波t / r組件。
  3. As a result, an amplifier of this type may have outstanding low frequency power supply rejection, but the negative supply rejection is fundamentally limited at high frequencies

    因此,此類放大器會有傑出的低頻供電抑制,但負電壓供電會被限制在高頻
  4. Switching power amplifier is popularly used because of its virtues of low power losses, high efficiency and high frequency bandwidth

    開關型功率放大器因其損耗小、效率高、通頻帶寬等優點,廣泛取代了早期低效率的線性功放,成為目前功率放大器研究的重點。
  5. Become a kind of new electronics circuit - current - mode circuit. it is replacing the traditional design method of the voltage - mode in the high frequency high - speed signal processing realm 。 this thesis mainly discussed the modified second - generation current conveyors based on the current - mode kinds of new cuicuit components, they are stronger modified standard current - mode parts in fuctions on this foundation. mainly including the modified differential difference current conveyor ( mddccii ) 、 the fully balanced second generation current conveyor ( fbccii ) 、 ( full balances ) four - terminal floating nullor ( fbftfn ) and the current differencing buffered amplifier ( cdba ), they are all function very strong standard current - mode parts, they all can provide some circuit functions of better than general operation amplifier, because they have the voltage importation and the current importation, therefore use it since can carry out the voltage - mode signal processing circuit expediently, can also carry out the current - mode signal processing circuit expediently, and have to increase the benefit bandwidth to accumulate more widely than the voltage - mode, but have their advantages more according to the current - mode filter of the modified current conveyor, because it constitutes in brief, the filter wave function is stronger and they are better than in general use operation amplifier of many advantages, be easy to composing for example 、 high speed 、 frequency bandwidth 、 the power supply voltage requests low 、 consume small, the impedance is different from etc. advantages, otherwise they have biggish dynamic range, and flexible circuit synthesize, so they are the best active parts

    從第二代電流傳輸器ccii入手,重點研究了以下幾種改進型的第二代電流傳輸器:改進的差動差分電流傳輸器mddccii 、全平衡第二代電流傳輸器fbccii 、多輸出四端浮地零器ftfn 、全平衡四端浮地零器fbftfn 、電流差分緩沖放大器cdba的電路結構及其模型。然後在此基礎上系統地研究了基於這幾種改進型的第二代電流傳輸器的濾波器的設計方法,主要方法和結果如下:利用mddccii設計了差分式連續時間電流模式低通、帶通濾波器;電流模式跳耦結構考爾低通濾波器;利用fbccii設計了帶通二階節濾波器及電流模式雙二階通用濾波器;設計了基於多輸出端ftfn的電流模式二階通用濾波器電路;通過數字化開關選擇的基於fbftfn的電流模式通用濾波器;設計了基於最少個數電流緩沖放大器(兩個cdba )的多功能通用電流模式濾波器及其在非理想因素情況下分析。設計濾波器的主要方法是採用級聯設計、運算模擬(信號流圖法)和反饋設計(跳耦法) 。
  6. T / r module is a functional module for the new radar, that is active phase control array radar, and t / r nodule system - integrates high frequency switches, phase shifter, lna and power amplifier, etc. if using low cost thick film technology to manufacture t / r module, it will be benefit to accelerate the applicants and development of the active phase control array radar

    T r模塊是實現新型雷達? ?有源相控陣雷達需求的功能模塊,它系統地集成高頻開關、限幅器、移相器、 lna及功放等。利用厚膜的廉價成膜工藝技術製作t r組件模塊,則有利於加速有源相控陣雷達的應用與發展。
  7. Design of the power amplifier for ultra - low - frequency vibrator calibration system

    用於超低頻振動校準系統的低失真度功率放大器的設計
  8. To compare with transistor ( complete solid - state ) high - frequency linear power amplifier, there are some disadvantages : bad stability and reliability, low efficiency, high cost for operating, huge cabinet, heavy maintenance work load, low security for high - voltage electricity offering, and to ensure the continuance of tv program, the transmitter must be operating with main frame and spare frame

    它們與晶體管(全固態)高頻線性功率放大器相比,存在著穩定性及可靠性差、效率低、運行費用高、發射機體積大、日常維護工作量大、高壓供電不安全、必須採用主機和備機的運行方式來確保電視節目不停播等缺點。
  9. Usually the low power operational amplifier is designed with rail to rail output stage, whose signal dynamirange is small, its output driving force is not strong, here it is designed with voltage displacement stage, and the strong driving force and the low power consumption in this circuit are achieved. with 5v single power, this amplifier consumes only several a, 100khz unity - gain frequency, achieves 80db dc open gain and 55 phase margin for a 100pf load capacitance and a 1m load resistance and other advantages

    通常設計的低功耗軌對軌輸出運算放大器中,由於信號的動態范圍比較小,它的輸出驅動能力不強,這里設計的是採用電平位移電路同時實現了電路的強驅動能力與低功耗,它具有在單電源電壓5v的條件下,靜態工作電流只有幾微安,單位增益帶寬達100k ,開環增益能達80db以上,相位裕度也能達55度,輸出源沉電流達500微安以上等優點。
  10. The super - low frequency and distortion power amplifier is developed with opa512 operation amplifier produced by bb co. in america. and the analyses software of frequency spectrum based on fft is designed

    研製了超低頻、低失真功率放大器;開發了基於fft超低頻頻譜分析軟體,並對它們進行測試與分析。
  11. By the development of high frequency switch, low frequency transformer has been withdrawn from many domains. but in the domain of ups, linear power amplifier and the inverter output low frequency ac, for the purpose of isolation and change voltage, there is no choice but to use low frequency transformer

    高頻開關技術的發展,使工頻變壓器從許多領域中退了出來,但是在需要隔離的ups不間斷電源、數碼線性功率放大器、要求輸出低頻正弦波的dc ac變換器等許多領域中,為了隔離或變換電壓的需要,以至不得不保留了低頻變壓器。
  12. Pin diode used as thermo sensor and heating component in this method, low frequency pulse power amplifier is used to substitute rf power in thermo - resistance measurement, and pulse wide compensation is used in dissipation measurement, then equipment require reduced and flexible of equipment rising

    該方法以pin二極體作為感溫元件和發熱元件,採用功率脈沖源來代替射頻功率放大器對器件進行加熱進行熱阻測試,使用占空比補償法進行功耗測試,大大降低了設備要求,提高了測試設備的通用性。
分享友人