low-pass filter circuit 中文意思是什麼

low-pass filter circuit 解釋
低通濾波電路
  • low : adj 1 低的;淺的,矮的。 low flight 低飛。 a low temperature 低溫。 low tide [water] 低潮。 The g...
  • pass : vi (passed passed past )1 經過,通過;穿過;越過;超過;掠過;前進。2 (時間)流逝,推移;轉化...
  • filter : n 1 濾器,濾紙,過濾用料[砂、炭等]。2 【無線電】濾波器;【物理學】濾光鏡,濾色器。vt 過濾,用過濾...
  • circuit : n 1 (某一范圍的)周邊一圈;巡迴,周遊;巡迴路線[區域];迂路。2 巡迴審判(區);巡迴律師會。3 【...
  1. Delay line oscillator is composed of broadband amprifer adjustable attenuator and saw sensor device. after output signal of delay line oscillator is smoothed, it mixes with 109mhz local oscillation signal. its differential frequency signal is smoothed by low - pass filter trimmed by shaping circuit and processed by digital processing circuit

    延遲線振蕩器由寬帶放大器、可調衰減器和聲表面波質量傳感器件構成。延遲線振蕩器輸出信號經濾波后與109mhz的本機晶體振蕩器輸出信號相混頻,通過低通濾波取其差頻,並經整形後由數字信號處理電路處理。
  2. The character of radar system is restricted by parasitical am. to restrain parasitical am, a low pass filter is used in the if circuit. the result shows that the fmcw detecting range of the radar with the filter is greater than that without

    較大的vco寄生調幅對雷達的作用距離有嚴重影響,對此,本文進行了分析,並提出了一種在中頻電路中用濾波電路進行抑制由寄生調幅帶來的于擾信號的方法。
  3. This paper mainly focuses on the noise limiting by means of the direct sequence spread spectrum ( dsss ) and the analysis of the transmission performance of the plc and some digital modulation technology. the contents of the paper is as follows : 1 ) the technical feasibility is proved after simulating noise limiting principle of dsss by means of systemview, the simulation software ; 2 ) a kind of band pass filter ( bpf ) is realized according to the requirement of filter and the principle of butterworth approximation, which satisfies the index of performance of dsss. 3 ) the low voltage plc system includes the sc1128, the specific modulation / demodulation ic, the bpf filter and other circuit components, furthermore, the control function of system is realized by means of the personal computer and the microcontroller

    本課題在對低壓電力線的傳輸特性和數字調制技術進行分析的基礎上,將通信理論中的直接序列擴頻技術( dsss )用於解決低壓電力線通信的干擾問題,主要研究內容如下: ( 1 )用通信模擬軟體systemview對dsss技術的通信和抗干擾原理進行模擬分析,分別對時域和頻域下採用dsss技術前後接收信號的頻譜進行分析,驗證dsss技術在本系統中的可行性; ( 2 )由dsss技術對濾波系統的要求,根據濾波理論分析了巴特沃思型濾波器的逼近原理並設計了合適的濾波電路; ( 3 )用調制解調晶元sc1128和自行設計的濾波器加之輔助外圍電路,構造出低壓電力線載波通信系統,並採用atmel公司的單片機設計了接收和發射電路的微控制器; ( 4 )分別對採取抗干擾措施前後輸入和輸出信號進行對比實驗,並對結果進行分析,驗證了dsss技術對干擾信號的抑制作用。
  4. Secondly the detection precision is only related to the synchronization phase but not to the amplitude of the mainline voltage because that it uses the optimized pulses synchronous with the mainline voltage as modulation signals. thirdly it decreases the requirement of the input low pass filter and eliminates the error resulting from the direct component and even harmonics of load current. the most significant merit is that it can eliminate the effect of a few low order odd harmonics and the detecting circuit is easy to be implemented

    模擬和實驗結果表明該方法的主要優點有:不需使用乘法器進行信號調制,調制信號採用與電網電壓同步的優化特定脈沖,其檢測精度只與同步相位有關,而與電網電壓幅值無關;降低了對輸入低通濾波器的通頻帶要求,直流和偶次諧波分量對檢測精度沒有影響;突出的優點是可以消除有限個低奇次諧波對檢測結果的影響。
  5. Then the paper analyzes control system of hybrid active power filter, the way of harmonic detecting and the principle of control system, digital low pass filter and the generation of pwm, on the base of which the paper designs a new parallel hybrid active power filter which is controlled by tms320lf2407, and detailedly introduces drive circuit of pwm, sampling circuit of current, voltage adjustment and protection circuit, communication circuit, liquid crystal display circuit

    分析了混合型有源濾波器的控制系統、諧波檢測方法及控制原理、數字低通濾波器和pwm信號的產生,在此基礎上設計了一種基於tms320lf2407為控制核心的並聯混合型有源電力濾波器硬體原理圖。並對pwm驅動電路、電流采樣電路、電壓調整、按鍵輸入和保護電路、通信模塊、液晶顯示模塊進行了較詳細的分析說明。
  6. The whole pwm circuit contains two subcircuit, the front - end is pwm module that make up of the counter that based on nine mosfet true - single - phase - clock d flip - flop ; the back - end is demodulated module, which is consist of a three order chebyshev low - pass filter used trans - conductor capacitor. all the subcircuits are simulated. at last, an approving simulated result of the whole circuit is given too

    在調制部分,利用九管單相時鐘d觸發器構成計數器,並由此組成了脈沖寬度調制電路,同時給出了在典型溫度下的模擬結果;在解調部分,介紹了低通濾波器從無源到有源的設計方法,設計了三階切比雪夫低通跨導電容濾波器,同樣給出了相應的模擬結果;最後,作為將脈沖寬度調制電路和濾波器作為整體電路,以脈沖調頻波為輸入進行了模擬,取得了令人滿意的結果。
  7. 4. according to the analyses of underwater acoustic channel and long - range remote control receiving system, we designed the long - range remote control receiver, including a low noise prefix - amplifier, a band pass filter and an auto - gain control circuit. finally, the analog part of the receiver is tested and the frequency response of this receiving system is obtained.

    結合對水聲通道特性和遠程遙控接收系統的分析,進行了遠程遙控接收機的設計,包括接收機低噪聲前置放大器的設計、帶通濾波器電路的設計和集成以及自動增益控制電路的設計,最後對接收機模擬電路進行了調試。
  8. The load - control apparatus adopted a single - chip microcomputer system, whose mcu was a kind of high - speed processor - ds80c320, whose a / d switched apparatus was max180, whose low - pass filter was max293, whose f / v transformed circuit was lm331, whose controlled silicon phase - shift touch - off circuit was tca785, and whose communicating interface of rs232 was max202. the watchdog of the mcu was max705 and the system used an on - off electrical source to supply power

    球磨機負荷控制儀採用了單片機系統, mcu採用ds80c320高速處理器,採用max180作為md轉換器,低通濾波器為max293 , f v轉換電路利用lm331 ,可控硅移相觸發電路使用tca785 , rs232通信介面晶元採用max202 , mcu監控電路為max705 ,系統使用開關電源供電。
  9. It can generate high - stable and linear current signal and utilize butterworth low pass filter to eliminate the noise and ripple in the signal. according to the different functions of different pins, this circuit can modulate and control the output power of the laser diode and modulate the laser signal, which makes this laser diode driver have more valuable application. in the last part of the paper, the feasibility of the theory is validated by experiment data

    其次,根據ic - wkn的內部電路和不同引腳的功能,設計了一套由d / a轉換器和單片機組成的信號調節電路,使之能夠輸出具有良好的穩定性和線性特性的電流調節信號,並選擇巴特沃茲低通濾波器來濾除信號中的紋波和干擾。
  10. Photoelectric detecting circuit is constituted of four parts, i / v conversion, lock - in amplifier, low - pass filter and operation

    光電檢測電路由四部分組成,分別是i / v轉換環節、鎖相放大環節、低通濾波環節、運算環節。
  11. In the fourth chapter, a fourth - order chebyshev low - pass filter employs new low voltage, highly linear, wide inputting range transconductor is proposed, then we presents a new circuit to tune gm value of transconductor accurately, which employs a new switched - capacitor circuit to change the bias current of transconductor, a third order elliptical function low - pass filter with accurate tunable frequency has been designed using transconductor that is not only with voltage common - mode negative feedback, but also with varying bias - triode transistors which can improve the linearity of this circuit

    第四章:提出了一種新的低電壓、高線性度、寬輸入范圍跨導,並由此設計實現了四階切比雪夫( chebyshev )低通濾波器,接著提出了一種寬輸入范圍且具有電壓共模負反饋的全差分跨導,並採用一種新的開關電容電路實現跨導值gm精確可調,從而可以設計得到高性能具有精確截止頻率的跨導-電容三階橢圓函數濾波器。
  12. Accoridng to the target and preceding analyses, we select ad9850 for dds chip, pe3236 for pll chip, and mcu pic16f874 for loading control word and realizing control function. afterward, we design and simulate the lc filter, microstrip low - pass filter and coupler, then implement the frequency synthesis. finally , the circuit is tested and the target is obtained

    根據指標的要求和上面的分析, dds晶元採用ad9850 , pll晶元採用pe3236 ,控制字的載入及控制功能的實現由單片機pic16f874來實現,並對其中的lc濾波器、微帶低通濾波器、耦合器進行了設計和模擬,最後完成了一個頻率合成器。
  13. So they are able to keep synchronous and processing concurrently. besides the high resolution ratio sensor, the tiny volt class constant power and 24 bit a / d converter which equipped microprocessor are used. the high accuracy amplifier and low - pass filter circuit were designed to deal with the signals

    為保證各傳感器檢測的信號具有足夠高的解析度,採用了微伏級高精度穩壓電電源和具有微處理器的24位a d轉換器ads1211 ,並設計了相應的高精度信號放大器和低通濾波器。
  14. The proposed driving circuit includes a low - pass filter circuit 、 feedback circuit 、 signal generated circuit 、 phase shifted circuit and power inverter circuit. a ti cooperation ' s dsp ( tms320lf2407a ) is chosen for the drive and control system based on the characteristics of usm, the interface circuit 、 each function ’ s flow chart and algorithm program are designed

    根據usm的特點,選取一款專用於電機控制的dsp晶元tms320lf2407a ,設計了硬體介面電路、各功能部分的流程圖及控制演算法程序,以ccs為編譯環境,進行電機整個控制系統的軟體編寫與調試。
  15. One is for the equipment manufacturer to design a " hard " low - pass filter at the input of the circuit to supress anything above 20khz ; very few do this

    其一,器材廠家設計一種「硬」低通濾波器,將電端輸入所有高於20khz的信號濾掉(很少有人這么做) 。
  16. In this section, the main content is about the transducer and the low - pass filter. the simulation program of wave filter circuit and the stability of wave filter and analogue signal pspice analysis are integrated in chief. these are constituted as a circulatory feedback mode, so that it speeds the process of establishing electric circuit parameters

    尤其在低通有源濾波器的分析與設計這部分內容中,將濾波器電路的程序模擬、濾波器穩定性分析和pspice分析設計有機的結合起來,組成了一個循環反饋的分析模式,加快了電路參數的確定過程,縮短了產品的研發周期。
分享友人