low-voltage coil 中文意思是什麼
low-voltage coil
解釋
低電壓線圈-
The second, at the high frequency primary coil, when switch turn on with control signal ( the spwm pulse is modulated ), in the positive or negative semi - period of low frequency modulation signal, transformer coil with same direction voltage. the magnetic flux of transformer core will increase step by step. at the end, it leads to magnetic flux saturation
二、在高頻變壓器原邊，當開關管接收控制信號脈沖列（經調制的spwm波列）導通時，在低頻調制信號的正半周或負半周內，施加在變壓器繞組上的是同一方向的電壓，變壓器磁芯中的磁通可能將級進地逐漸增加，導致磁芯飽和，造成磁偏或單向磁化，導致低頻電信號放大失真或由於很大的磁化電流而無法正常工作。 -
The key parts of barretter are made of irf840 field - effect transistor, the magnetic ring and high frequency choking coil which adopting negative temperature index. such components can provide barretters a wide applicable voltage 160v - 250v. low power consumption, minor temperature rise, stable functions, long life - span
鎮流器核心元件採用irf840場效應三極體，磁環及高頻扼流圈採用負溫系數，這樣的元件選擇使整流器適用電壓范圍寬160v - 250v ，功耗低，溫升小，性能十分穩定，確保其擁有很長的壽命。 -
The problem about neutral - point - grounding mode is an all - around technical problem which associated with not only power system reliability ， insulation coordination ， electromagnetic interference ， but assault safety 。 in china ， the neutral grounding modes of the 10kv net involved of none grounding, grounding by arc suppressing coils, resistance grounding or reactance grounding in the past 。 with the development of civic power network ， low resistance grounding mode was used to restrain the over voltage, particularly in guangzhou, shanghai ， beijing ， and zhuhai etc. it was reported that the over - voltage level of low resistance grounding mode is lower than that of arc suppressing coil mode, but the operation carried out the other way 。 at substations in guangzhou and shanghai it was found that the low resistance grounding mode is successful 。 but in some areas ， such as zhuhai ， substations grounding with low resistance revealed some problems ， including power supply reliability rapidly dropping ， transmitting line often tripping ； and person safety being threatened 。 so interiorly the grounding mode selection of the 10kv network was disputed, which mainly focused on the fault form of 10kv net grounding, the apply area of suppressing arcing coil grounding mode, power supply reliability level of the two modes, person safety, communication interfere and the workload of maintenance
爭議點主要是在10kv電網接地故障的形式、消弧線圈接地的應用范圍、兩種運行方式供電可靠性的高低、人身安全、通訊干擾和運行維護工作量等諸多方面。 11 17本論文就是針對以電纜為主的城區10kv電網中性點接地方式的選擇問題進行研究。論文首先對10kv電網的中性點運行各種方式進行分析，比較各方式的特點，然後以重慶儲奇門變電站10kv電網的實際參數來建立數值計算模型，在考慮了電網接地電容電流變化、中性點電阻取值大小、接地點接地電阻值變化等多種影響因素的情況下，對中性點經消弧線圈接地和經小電阻接地方式下電網的過電壓水平和接地點短路電流大小進行了數值計算，其計算結果與電科院所作現場試驗進行了比較。 -
The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement
偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。 -
Dexterous control due to the low consumption & wide voltage range dc coil inside, while electronic thermal overload relay provides precise protection against all kinds of fault
低功耗、寬電壓范圍接觸器線圈，寬范圍整定電流（ 4倍）電子式熱繼電器，控制保護精準無誤； -
Four methods have been taken to decrease the total heat quantity generated by the solenoid coil. the four methods are to reduce the duration of the high voltage, to reduce the amplitude of the high voltage, to reduce the duration of the control signal, and to reduce the amplitude of the low voltage. it was found that the four methods did have some effect on temperature
研究發現，以減小電磁閥的總發熱量為目的而採用的縮短高電壓作用時間、降低電磁閥高低壓驅動的高電壓幅值、縮短控制信號持續時間和降低維持電壓的四種方法，對減小電磁閥的發熱都是有效的，但效果都不特別顯著。 -
Also, the lack of coil heating, which minimizes contact potential, makes latching relays useful in very low voltage applications
此外，由於線圈不會發熱，從而使接觸電勢最小化，使得閉鎖型繼電器被廣泛用於電壓非常低的應用中。 -
We use rogowski coil as the sensor that mounted on high voltage power line. after converting rogowski coil ' s analog signal to digital signal, we transmit the digital signal to low voltage part through pof where we resume the analog signal and finish the tasks of measurement
採用rogowski線圈作為高壓電力線上的傳感頭，將rogowski線圈的輸出數字化后，通過光纖傳送到低壓端恢復成原來的模擬信號，實現對高壓電力母線電流的測量。
分享友人