lower carrier 中文意思是什麼

lower carrier 解釋
底部承載板
  • lower : adj 〈low 的比較級〉1 較低的。2 下級的，低級的。 lower animals 下等動物。3 南部的。 in lower Manh...
  • carrier : n 1 運送人，搬夫；負荷者；使役，〈美國〉信差，郵遞員；送報人；〈英國〉運輸行，運輸業者。2 傳書鴿...
  1. This compound was firstly used as a fluorescence carrier of chemical sensors to examine the toxic p - nitroaniline. compared with conventional methods, this sensor has lower cost, wider detection range, higher sensitivity and selectivity, better reproducibility and reversibility. 4

    與傳統的檢測對硝基苯胺的方法相比，該傳感器操作簡便，製作成本低廉，在較寬的范圍內有響應，具有較高的靈敏度和選擇性，重現性好，響應迅速。
  2. Article 130 any provision tending to relieve the carrier of the liability prescribed by this law or to fix a lower limit than that which is laid down in this law shall be null and void, but the nullity of any such provision shall not involve the nullity of the whole contract of transport by air

    第一百三十條任何旨在免除本法規定的承運人責任或者降低本法規定的賠償責任限額的條款，均屬無效；但是，此種條款的無效，不影響整個航空運輸合同的效力。
  3. As compared with the pressure of carrier gas, the subatmospheric pressure is more favourable condition to atomize the hydride, so the atomization temperature was lower ( about 650 )

    由於硒化氫的原子化是在負壓下完成的，它將比常壓或載氣壓力下更有利於氫化物的原子化，因而使硒化氫原子化的最佳溫度降低。
  4. The new device consists of paint - drying box, heat carrier boiler, heating pipe, expansion tank, gas separator and oil tank, etc. the data of two applied examples shows that heat carrier paint drying method is able to make painting - drying cost drop by 88 %, compared with the conventional one, that it has some advantages such as uniform temperature field, good appearance and lower costs, compared with conventional hot air convection mode

    該裝置主要由熱載體烤漆爐、輻射加熱管，熱載體爐、膨脹器、油氣分離器和儲油槽等組成。應用實例的測試數據表明，與傳統的遠紅外電加熱鋼瓶烤漆方式相比較，鋼瓶熱載體烤漆節能和降低能耗費用十分顯著，能耗費用降幅達到88 。與熱風爐對流烤漆方式相比較，熱載體烤漆方法不僅節能，而且烤漆爐溫度場均勻穩定，同時烤漆的外觀質量也得到了明顯提高。
  5. This thesis regard internal property reorganization in the group of pangang as the research object, from chengdu seamless steel pipe limited liability company with chengdu iron and steel works inside exterior environment reorganizing in front and back commences, making use of to exceed the makel - bot with of five factors competition models and the method of factors analysis, after analyzing the reorganization of the business enterprise a profession for facing competes the situation. develop the development the business enterprise with the profession industry from the international local profession rival circumstance after analyzing the reorganization should the market position of the establishment with develop the strategy target. make use of the swot the analysis the method, to after the reorganization the development strategy of the business enterprise, from manage the angle proceeded the fixed position analyzes, for after the reorganization business enterprise development provided four kinds of developments strategy that eligibility choose : the brave development strategy, request the resources advantage, funds advantage, human resource advantage, technique advantage that new company make the most of new business enterprise in empress in reorganization, is an essential condition to increases to manage the level, quickly technique reforms, develop the high and additional worth product with new product production line, as soon as quikly change to strong and large business enterprise, realizes soon steel aircraft carrier dream ; dispersion strategy, the technology market quota with deal with produce high additional worth product, completely promote business enterprise brand image, extend high carry product of the exaltation product, is a necessary means to increases business enterprise performance, realizes business enterprise target ; defense strategy, adjusting the business enterprise organizes construction, reducing the intensive type in labor and the low additional worth product line, lower bad the property saves the deal, alleviating the business enterprise burden, attaining the casual wear go to battle, benefitting to the challenge that make frontal attack the rival ; withdraw strategy, compress the production of the high depletion and high cost product, simplify the production craft, controlling the cost of the end product in the lower level, is a valid path to increases business enterprise competition ability

    本論文以攀鋼集團內部的資產重組為研究對象，從成都無縫鋼管有限責任公司與成都鋼鐵廠重組前後的內外部環境入手，運用邁克爾?波特的五力競爭模型及因素分析法，分析了重組后的企業所面臨的行業競爭態勢。從國際國內行業競爭對手情況和本行業發展動態分析了重組后企業應確立的市場地位和發展戰略目標。運用swot分析法，對重組后企業的發展戰略，從管理角度進行了定位分析，為重組后企業發展提供了可選擇的四種發展戰略：即大膽發展戰略，要求新公司充分運用重組后新企業的資源優勢，資金優勢，人力資源優勢，技術優勢，是提高管理水平，加快技術改造，開發高附加值產品和新產品生產線，盡快立於強勢企業之林，早日實現「鋼鐵航母」夢的必要條件；分散性戰略，提高產品的科技含量和生產高附加值的產品，全面提升企業品牌形象，擴大高端產品的市場份額，是提高企業效益，實現企業目標的必要手段；防禦性戰略，調整企業組織結構，削減勞動密集型和低附加值產品生產線，降低不良資產存量，減輕企業包袱，做到輕裝上陣，有利於迎擊競爭對手的挑戰；退出性戰略，壓縮高消耗、高成本產品的生產，降低低端產品的比例，精簡生產工藝，將最終產品的成本控制在較低水平，是提高企業競爭力的有效途徑。
  6. Transmitted the same power, the way of sub - carrier selection have even better snr and lower ber than using all sub - carrier

    在發射端採用相同的功率情況下，子載波選擇的方法比採用全部載波傳輸的方法有更高的信噪比和更低的誤碼率。
  7. It is proposed that the higher dose condition creates more hot carriers but the lower sensitivity to hot carrier effect. therefore, the optimum dose for reliability is determined from the trade - off between the above two aspects. finally, a simple model is proposed and discussed

    本文還深入研究了sde區摻雜濃度對器件熱載流子可靠性的影響，指出濃度的提高雖然會產生更多的熱載流子，但由於其對熱載流子損傷的敏感度降低，因此將存在一種折衷，最後通過一個簡單的寄生電阻模型，對摻雜濃度提高后，器件對熱載流子損傷敏感度降低的現象做出了很好的解釋。
  8. 3 the carrier transportation and transition in led active layer had been analyzed. the larger number of quantum wells are in active layer, the lower carrier density will be, and the better confinement of carrier is

    ） y方向上的有效質量減小，而輕空穴則具有負的有效質量，這對器件電注入和光輻射復合是有利的。
  9. Fsk distribution automation using distribution line carrier systems - part 5 - 2 : lower layer profiles - frequency shift keying profile

    使用配電線路載供系統的自動配電.第5 - 2部分:低層分布圖.頻移鍵控
  10. Mcm distribution automation using distribution line carrier systems - lower layer profiles - multi - carrier modulation profile

    使用配線配電線路載波系統的配電自動化.低層輪廓.多載波調制
  11. Mcm distribution automation using distribution line carrier systems - part 5 - 4 : lower layer profilers - multi - carrier modulation profile

    採用配電線載波的配電自動化第5 - 4部分:低層協議集多載波調制
  12. Mcm distribution automation using distribution line carrier systems - part 5 - 4 : lower layer profiles - multi - carrier modulation profile

    使用分配線載波系統的分配自動化.第5 - 4部分:低層輪廓.多載波調制
  13. Ss - aw distribution automation using distribution line carrier systems - part 5 - 3 : lower layer profilers - spread spectrum adaptive wideband profile

    採用配電線載波的配電自動化第5 - 3部分:低層協議集自適應寬帶擴頻
  14. In testing upper frequency, lower frequency, and modulating frequency, the method of directly testing upper frequency and lower frequency then calculating carrier frequency is adopted

    在測量移頻信號的上、下邊頻及載波頻率時，採用直接測量上、下邊頻，然後由上、下邊頻求中頻載波的方法。
  15. The content of this theme is as follows : without time, without open, without stopping railway transport, and without interrupting traction current of block tested, meanwhile track circuit parameters in electrical and no electrical blocks is measured of on - line, dynamic and real - time. these parameters include voltage of fsk signal, voltage of industrial and harmonic wave interference, upper frequency, lower frequency, carrier frequency and low frequency 18 messages frequency

    本課題研究內容：在不要點，不開天窗，不中斷行車，不中斷被測區段牽引電流的情況下，在線、動態、實時測量電化區段和非電化區段的移頻信號電壓、工頻干擾電壓，移頻信號（調頻信號）的上邊頻、下邊頻、載波頻率、以及低頻18信息頻率等參數。
  16. But modern electronic counterwork technic could exactly estimate the carrier frequency, signal period, even the pseudo - random ( pn ) sequence itself of direct sequence spread spectrum ( dsss ). it is urgency to investigate a new dsss to achieve lower probability of detection ( lpd ) and higher anti - jamming

    然而現代電子對抗技術可以準確估計直接序列擴頻通信的載波頻率、符號周期甚至擴頻碼本身，為達到更低截獲率和更高抗干擾的通信目的，必須研究新的直擴通信技術。
  17. Liquids are divided into single and complex fluids according to theirs structure. complex fluids are called soft materials too. electrorhological fluids compose of high dielectric constant particles and lower dielectric constant carrier fluids

    電流變液是一種典型的軟物質，通常是由高介電常數的微小顆粒分散在低介電常數的絕緣液體中形成的懸浮體系。
  18. Ss - ffh distribution automation using distribution line carrier systems - part 5 - 5 : lower layer profilers - spread spectrum - fast frequency hopping ss - ffm profile

    採用配電線載波的配電自動化.第5 - 5部分:低層協議集.快速跳頻擴頻通信
  19. The influence of sulfidation pressure on microstructure is insignificant. the electrical resistivity is lower because the carrier concentration is very higher for the films annealed at lookpa sulfidation pressure

    硫化壓力的變化對薄膜的組織結構影響不明顯，當硫化壓力為100kpa時，薄膜具有較高的載流子濃度及較低的薄膜電阻率。
  20. Loading patterns of catalyst in carrier are discussed. two loading patterns, which cost are lower and can largely improve conversion characteristics of catalytic conyerter during warm - up period, are put forward

    探討了催化劑在載體內部的擔載模式，提出了兩種成本較低，但可大幅度改善催化裝化裝置溫升過程中催化轉化性能的催化劑擔載模式。
分享友人
分享到 Line

分享到臉書