maximum absorption 中文意思是什麼

maximum absorption 解釋
最大吸收量
  • maximum : n （pl maximums ma ） 極點，最大，最高，最高額，最大值；最高點；最大限度；【數學】極大（值）（opp...
  • absorption : n. 1. 吸收，合併。2. 專心，一心不亂，熱中 （in）。3. 〈口語〉飲食。
  1. The results indicated that the dimension, shape and purity of base material could meet the functional demand of solid lubricant ; the thermal decomposition temperature of ptfe resin exceeds 400 c, but organic and inorganic packing filler added in ptfe made the water absorption rate of composite material increased, melting temperature and decomposition temperature decreased, in the meanwhile oxidative decomposition reaction was accompanied ; polar groups such as c = o, c - o - c and so on in the carbon fiber surface is advantageous to increase compatibility with other components and interlayer shearing strength ; uniform design experimental method could help to find the relationship between formula and frictional property by relatively small tests. the developing trend of each formula ' s friction coefficient could be showed by fitting curve ; the friction coefficient with no copper powder or graphite in formula was relatively big. this fact showed that copper powder and graphite should be used cooperatively ; it was found that when the ratio of copper powder to graphite by weight is 15 : 60, 30 : 30 - 40 and 60 : 15 - 30 respectively, the friction coefficient was relatively small. the degree of crystallinity of pure ptfe reached maximum by air cooling and the abrasion loss also reached maximum among three ones ; at the same time, the abrasion loss of solid lubricant sample was also the biggest among three ones ; when solid lubricant matched with 45 # steel axle or gcrl5 steel axle, lubricant transfer film could be formed on metal surface, thus direct contact between the surface of metal friction pair rings was reduced. their working life was elongated extremely ; there was mainly much graphite, a little ptff, moo3, feso4, cus and so on in lubricant transfer film

    試驗結果表明：所選原料的尺寸、形狀及純度可滿足固體潤滑劑的性能要求；聚四氟乙烯樹脂熱分解溫度超過400 ，但在ptfe中加入無機填料會使復合材料吸水率提高，熔融溫度及分解溫度降低，且伴有氧化分解反應；碳纖維表面含有c = o及c - o - c等極性基團，有利於提高其與其它組分的相容性，提高層間剪切強度；均勻設計試驗方法能夠用較少的試驗次數找出配方與摩擦性能間的關系，擬合曲線基本能表示各配方的摩擦系數發展趨勢；配方中不加銅粉或不加石墨，其摩擦系數均較高，說明銅粉和石墨應該配合使用；當銅粉15份、石墨60份時，銅粉30份、石墨30 - 40份時，銅粉60 、石墨15 - 30份時，摩擦系數均具有較低值；純聚四氟乙烯樹脂在空氣冷卻時結晶度最大，磨損量也是三者中最大的；同時，固體潤滑劑試樣在空氣冷卻時的磨損量也是三者中最大的：不論是固體潤滑劑與45 #鋼軸配副或是固體潤滑劑鑲嵌入銅套后與gcr15鋼軸配副，在金屬表面均可形成潤滑轉移膜，從而減少金屬摩擦副表面間的直接接觸，大大延長其使用壽命;轉移膜中主要含有較多的石墨、少量聚四氟乙烯、 moo 。
  2. In addition, radiation absorption coefficient had a remarkable effect on maximum combustion temperature and maximum wall heat flux in the new phosphoric acid tower

    輻射吸收系數對最高燃燒溫度和壁面最大熱流影響很大，隨輻射吸收系數的增大，最高燃燒溫度和煙氣出口溫度會下降，而壁面最大熱流和平均熱流會上升。
  3. The effects of parameters on maximum combustion temperature, smog exit temperature, maximum wall heat flux, averaged wall heat flux of a new phosphoric acid tower with circular water wall were discussed, including phosphorus consumption, excess - air coefficient, wall temperature and radiation absorption coefficient, with the mathematical model developed in part

    摘要利用已建立的數學模型考察了燃磷量、過剩空氣系數、壁面溫度、輻射吸收系數對新型燃磷塔的最高燃燒溫度、煙氣排放溫度、壁面最大熱流和平均熱流的影響。
  4. Using radioactively labeled elements he demonstrated that the region of maximum absorption of water is a few centimeters behind the root tip and that quantities of minerals are absorbed passively in the transpiration stream

    利用放射性標記元素證明了水分吸收的主要部位在根尖以上幾厘米，礦物質隨蒸騰作用被動的吸收入植物體內。
  5. The calculation method of technical parameters of maximum output power, the short time power and continued power ( equivalent heating ) in electric braking are derived from analyzing the relationship of maximum regenerative power with resistance value of ground absorption equipment, model of traction power supply, train circuit and network voltage drop while performing electric braking

    通過分析列車電制動時的最大再生功率與電阻吸收裝置的電阻值、電制動時刻牽引供電系統的模型、列車電流、網壓降之間的關系，導出了列車電制動時最大輸出功率、地面電阻吸收裝置的短時功率和持續（等效發熱）功率等技術參數的計算方法。
  6. Some conclusions have been made in the following. that the value of toc is 0. 2 % may be regarded the low evaluation value of marine carbonate souce rock at the stage of high to over mature. according to the content of bitumen in source rock and reservoir, gas generation quantity, the maximum absorption gas quantity and geology analogy

    通過對儲層和烴源巖中瀝青定量統計分析、烴源巖生氣熱模擬、最大吸附氣實驗測定及地質類比法等綜合研究認為在鄂爾多斯盆地有機碳為0 . 2可作為高?過成熟的海相碳酸鹽巖有機碳下限標準。
  7. For maximum absorption, use at least 30 minutes before or after putting anything in your mouth other than water

    除了飲水之外，請在食用其它任何食物半小時之前或半小時之後再使用順勢產品，以使產品可以被最大化吸收。
  8. An optimization process of a thin - walled structure was performed by the response surface method, which took the maximum absorption energy from an impacting process as objective, the properties of the thin - walled structure as variables, and the impacting axial force as constraint

    摘要運用響應面法，以碰撞吸收能量最大為目標，薄壁結構幾何尺寸為設計變量，碰撞作用力為約束，對薄壁結構進行結構優化。
  9. The effect of different additives on the properties of water and oil absorption as well as the maximum load of wheat flour tableware was studied by using liquid paraffin and stearic acid as waterproof agents, sodium alginate and carboxymethyl cellulose sodium ( cmc - na ) as intensifier

    摘要以液態石蠟和硬脂酸作為防水劑，以海藻酸鈉和羧甲基纖維素鈉作為補強劑，研究不同添加劑對小麥粉餐具的吸水性、吸油性和最大承載等使用性能的影響。
  10. It is discovered, from the analysis of the seismic reaction of the piled jetties with rubber shock absorption seats, that the use of shock absorption seats will help improve the seismic resistance of piled jetties and the use of shock absorption seats will may reduce the maximum bending moment of the fixed end on a pile head to one third of that before the method for reduction of seismic hazards is adopted

    通過對現有高樁碼頭結構導入減震橡膠支座后的地震反應分析發現，減震支座的導入將有利於提高高樁碼頭的抗震能力，使樁上部固定端處的最大彎矩減小到未減震前的1 / 3 。
  11. As is shown in this paper, when the length of liquid - core optical fiber full of liquid of carbon disulfide disulphide is four meters, the maximum raman spectrum can be received, compared it with optical spectrum measured by absorption cell, it is enhanced by more than one hundred times

    採用此聯用技術，當液芯光纖芯內樣品為二硫化碳（ cs _ 2 ） ，液芯光纖的長度為4米時獲得的喇曼光譜強度最大。此時的喇曼光譜強度比吸收池方法獲得的喇曼光譜強度提高兩個數量級以上。
  12. The force - time curves are then converted to force - displacement curves to calculate the energy associated with different impact phase. the results show that the maximum load of the composites with non plasma treatment filament is low and the absorption is also low in the initial crack phase

    通過對載荷?位移曲線進行積分，可得到不同試樣在沖擊過程中吸收的總能量、裂紋起始區吸收的引發能以及裂紋擴展區吸收的擴展能，從而分析界面粘結強度對材料能量吸收能力的影響。
分享友人
分享到 Line

分享到臉書