measured point 中文意思是什麼

measured point 解釋
檢測點
  • measured : adj. 1. 量過的，合標準的；適度的。 2. 慎重的，仔細想[考慮]過的（話等）。3. 整齊的（步調等）。adv. -ly
  • point : n 1 尖頭，尖端；尖頭器具；〈美國〉筆尖；接種針，雕刻針，編織針；小岬，小地角；【拳擊】下巴。2 【...
  1. The sound level produced from your booth shall be limited to no more than 80 phons, as measured at a point 2 meters away from the border line of the booth

    自己展間的產生音量規定值為：從離開展間邊界線2 m的地方進行測量，測定值在80phon以下。
  2. By means of bending tests of three - point and four - point, complex fracture experiments were made for cast iron material with crack. the stress intensity factor and breaking direction angle of cast iron material were measured and compared with theoretical values. based on the research some useful conclusions are given for engineering design and application

    通過3點彎曲和4點彎曲實驗方法，對含有裂紋的鑄鐵材料進行復合型斷裂實驗研究，測試鑄鐵材料的應力強度因子、斷裂方向角，將實驗結果與理論值進行分析、比較，找出兩者之間的異同點，得到一些對工程設計及應用具有實際意義的結論。
  3. At first, in the process of experiments, it were measured that dry plate pressures drop and point pressures in the flow fields around the single fixed - valve and double fixed - valves under different velocities by using of pitot tube. after that point pressure was transformed to point velocity, two dimensions flow plane of flow fields around fixed - valve were plotted to observe the difference between of the fixed - valve tray with fold edges and the common rectangular fixed - valve tray on the distributions of flow fields and pressures, to provide comparisons and refer - rence for cfd simulation

    在實驗中，利用測速管等儀器對在不同速度下的單閥和雙閥固定閥周圍的流場進行了點壓力測量，然後把點壓力轉化為點速度后繪出固定閥周圍流場的二維流線圖，同時測定了塔板的干板壓降，來考察新型固定閥帶折邊后對流場分佈和壓降的影響，為隨后的數值模擬提供對比和依據。
  4. Afterwards, the remnant lactic acid in lactide was measured by non - aqueous titration with sodium methoxide and the remnant water was surveyed by karl - fisher method. the melting point was investigated by thiele tube and the characteristics of lactide were analyzed by ir, uv spectrum, tg and dsc respectively

    然後，用甲醇鈉非水滴定法測定丙交酯中殘存乳酸，卡爾-費休法測定丙交酯中殘存水的含量，用提勒管測定精製丙交酯熔點，用紅外吸收光譜、紫外光譜、差熱分析對合成的丙交酯以及回收的丙交酯進行表徵。
  5. The modified traveling wave monopole model is employed in simulating the electron beam in crt of computer vdu. meanwhile acceleration fields of the electron beam are studied in details and its expression given for the first time with measured results. a novel analyzing method is proposed to study the spectrum of electromagnetic information leakage based on the viewpoint of field point, which has been verified effective by experiments

    採用經修正的行波單極子模型模擬計算機陰極射線管顯示器電子束，並詳細研究了電子束的加速場，首次給出了其計算公式和實驗測試結果；還提出了一種新的從場點出發的信息電磁泄漏頻譜分析方法，實驗證明了其有效性； 3
  6. The ecliptic coordinate system is defined as one which uses the ecliptic and the vernal equinox as the zero point. the ecliptic longitude of a body is the angular distance from 0 to 360 from the vernal equinox, measured eastwards along the ecliptic to the intersection of the body s circle of longitude

    黃道是太陽在天球運行的軌道黃道座標系統是以黃道為基礎的座標系統：黃道經度是以春分點為零度的大圓圈，向東起計共360度，而天體的黃道經度是天體的經圈與春分點的角距離。
  7. Angular distance is the distance between two objects measured as an angle from a given point

    角距離，是由一定點到兩物體之間所量度的夾角。
  8. Therefore, the power department and users are concerned aboui harmonic and reactive compensation. the power department usually manage compute and measure the electric net " s harmonic condition and connected or new - connected harmonic load. and need to measure the harmonic vol tage current in some electric net " point. then, by manual making an in - depth analysis and statistics on measured - data, it can reduce harmonic harm on public not to take some effective measures

    電力部門通常在實際中，需要對電網的諧波狀況、已接入和新接入系統的諧波源負荷進行管理、計算及測量，需要對電力網路各點的諧波電壓、電流實際水平進行測試，然後對測試數據進行人工分析統計，並以此採取相應措施降低或減少諧波對電網的危害。
  9. If you ' re holding a charge and you spend another point, the effects don ' t stack, but the maximum time you can hold the charge is measured from the time you spent the extra point

    保持充能時再花1點靈能點不會使效果累計，但保持蓄能的最長時間從支付額外靈能點時開始計算。
  10. Inversion analysis of measured displacements is used extensively in geotechnical engineering, structural engineering, information construction, and trauma diagnosis, etc. in this dissertation, parameters identification of original geostress and medium physical property in cavern, slope, tunnel and dam are taken as a cut - in point. macroscale inversion analysis of displacements and numerical solutions of inverse problems of mechanics are researched profoundly. scientific theories of multiscale problems are connected with numerical inversion approaches

    本文以地下洞室、邊坡工程、隧道工程與大壩等領域的初始地應力參數和介質物性參數識別為切入點，對宏觀尺度位移反演分析和力學反演問題數值求解方法進行了比較深入的研究，並將多尺度問題科學理論和反演數值方法聯系起來，初步探討了結構性承載材料（如巖石、骨材料等）的多尺度力學模型及其反演方法。
  11. Combined frame modeling method and surface modeling method build up the topological relations of spacial point, line and surface on condition that the points on the surface of measured object is considered as known points after compared with other several modeling method

    在比較了已有的幾種三維建模方法后，結合線框建模和表面建模的方法，將近景攝影測量所測物體表面點作為已知點，構建空間點、線、面的拓撲關系。
  12. Originating airport name, metar speci issue time, wind direction speed gust, wind direction variation, visibility, runway visual range, weather during time of observation, cloud, air temperature dew - point, qnh pressure measured at airport with adjustment made to suit aeronautical use, weather during the past hour but not at time of observation, wind shear information, trend - type landing forecast

    發出資料的機場名稱發出metar speci的時間風向風速陣風風向轉變能見度跑道視程觀測時的天氣雲層氣溫露點qnh在機場錄得的氣壓，經調整以配合航空用途過去一小時但非觀測時的天氣風切變資料飛機降落用的趨勢預測。
  13. Originating airport name, metarspeci issue time, wind directionspeedgust, wind direction variation, visibility, runway visual range, weather during time of observation, cloud, air temperaturedew - point, qnh ( pressure measured at airport with adjustment made to suit aeronautical use ), weather during the past hour but not at time of observation, wind shear information, trend - type landing forecast

    Metarspeci電碼包含趨勢預測，即預測未來兩小時內天氣的轉變，而且更利用特別標號（視乎情況，標號可以是ttttt = becmg或tempo ）又或是nosig ，來指明轉變。 （ becmg意指逐漸轉變； tempo意指間中； nosig意指並無顯著轉變。 ）
  14. Here p pressure stress of measured point medium density

    其中: p被測點的壓力壓強介質密度
  15. H height from measured point to liquid surface

    H被測點到液面的高度
  16. Here p pressure stress of measured point

    其中p被測點的壓力壓強
  17. It is importance of the experiment about measuring principal stress combined bending with torsion in mechanics of materials. this paper points out shortcomings in the traditional experimental devices combined bending with torsion and establishes theory and principles for designing superminiaturizational experimental device combined bending with torsion through analyses of stress and strain state at the measured point a ( b ). it also designs the superminiaturizational experimental device, which has smaller space and more precision and has more reasonable structure measurements in this paper

    彎扭組合主應力測定實驗在材料力學實驗中佔有重要的地位，作者指出了老式彎扭組合實驗設備的缺點，通過對所測點a （ b ）處應力應變狀態分析，確立了設計超小型化彎扭組合實驗裝置的理論基礎、設計原則，設計出了體積小，加載簡單，結構尺寸合理，精度高的超小型化彎扭組合實驗裝置。
  18. For has determined measured medium and the place, g is constant, so variation of position change from measured point to liquid surface is only associated with measured pressure

    對已確定的被測介質及地點， g為常數，故被測點到液面的位置的變化只與被測的壓力壓強有關。
  19. This thesis analyses the vibration signals of measured point 1 of 2 # set in a generating plant, by applying the method of analyzing sin signal which uses " sym8 " wavelet packet, eight level and " shannon " entropy to de - noise

    對汽輪發電機組的振動信號運用分析sin信號的方法進行了降噪處理，效果較好。本文對某發電廠正在運行的1 #和2 #汽輪發電機組進行了振動測試，採集到了可靠的振動信號。
  20. For has determined measured medium and the place, g is constant, so variation of position from measured point to liquid surface is only associated with measured pressure stress

    對已確定的被測介質及地點， g為常數，故被測點到液面的位置的變化只與被測的壓力壓強有關。
分享友人
分享到 Line

分享到臉書