mechanics of materials 中文意思是什麼

mechanics of materials 解釋
材料力學
  • mechanics : n. pl. 1. 〈作單數用〉力學 〈cf. statics; kinetics; kinematics〉; 機械學。2. 〈作復數用〉結構；構成法；技巧。
  • of : OF ＝Old French 古法語。
  • materials : 版本
  1. A lot of domains are involved with, such as theory of electromagnetism, electrotechnics, electronics, measurement of electromagnetism. signal analysis, mechanics, cybernation, biomedicine, materials, technics, ect. the study of emc is very fargoing and the problem of emc is very complex

    它涉及的基礎知識面非常寬廣，直接應用和涉及的知識有電磁場理論、電工原理、電子技術、電磁測量、信號分析、機械結構、自動控制、生物醫學、材料及工藝等等。
  2. This thesis used aerodynamics equation and mechanics of materials knowledge analyzed the high pressure caused by overloading in terms of theory. by compared the increment of pressure in a not full container with the full one and combined with the igc - code, this thesis put forward a method of calculating safe loading capacity under different temperature

    本文應用了氣體力學方程和材料力學理論知識，對充裝過量導致過高的液貨艙壓力進行了理論分析，對比保留有氣枕時的液貨艙的壓力增量和充裝過量時造成滿液的壓力增量，並結合igc規則對充裝極限的規定，提出了不同溫度下的安全貨液充裝量的計算方法。
  3. This spring is a key part for ensuring normal operating of aira. stress and beforehand close quantum of helix torsion spring of rectangle section is educed by some conclusions of mechanics of materials and compute formula

    該彈簧是保證調整臂正常工作的關鍵件，本文從材料力學的結論出發，詳盡地推導了該彈簧應力及其初始預緊量的設置，並給出它們的計算公式。
  4. Most existing constitutive models do not take into account the interactions between different phases of pearlitic steel and cannot illustrate why such kind of materials has excerllent mechanical properties. it is, therefore, necessary to develop a new method, which can describe the macroscopic behavior, damage and failure of the materials and their micro structural dependence. in this paper, based on a non - classical theory of plasticity and the continuum damage mechanics, a damage evolution based on an ellipsoidal void model for mixed hardening materials is obtained

    已有的關于珠光體鋼的本構模型多難以考慮珠光體材料的微結構及其相互作用，難以解釋珠光體材料何以具有較好的綜合力學性能，因此有必要發展一種多層次的細觀力學分析方法以研究此材料在復雜加載條件下計及微結構特徵的宏觀響應特性，使材料的強度、疲勞壽命的預測與其微結構及各組成相的損傷及微觀應力應變演化規律聯系起來，進而為材料微結構的設計提供依據。
  5. Opinions about the course reform of mechanics of materials

    關于材料力學課程改革的一些看法
  6. Research and practice to teaching system reform of mechanics of materials

    材料力學課程教學體系改革研究與實踐
  7. Our strength is in the fact that based on the national standard and architectural aesthetics, the most suitably custom - made project is delivered to our customers by utilizing our professional understandings on human engineering, aesthetics, mechanics of materials and the material science, engineering mechanics, industrial design science, and graphics design

    詳細說明我們能夠從建築學和美學的角度，綜合建築特色，企業文化，地域文化，行業特徵等因素，運用人機工程學，美學，材料學，工程力學，產品設計學，平面設計等專業知識，結合相應國家標準，為客戶量身定製出最適合的產品。
  8. Major courses : theoretical mechanics, mechanics of materials, structural mechanics, mechanics of elasticity, fluid mechanics, computational mechanics, vibration mechanics, experimental mechanics, fundamentals of electrical engineering & electric technology, computer technology and program design, main specialized courses in structural engineering, main specialized courses in engineering software

    主要課程：理論力學、材料力學、結構力學、彈性力學、流體力學、計算力學、振動力學、實驗力學、電工與電子技術基礎、計算機基礎知識及程序設計、結構工程類專業課、計算機軟體類專業課。
  9. My department there was aerospace engineering and mechanics, and i also worked at my old field of mechanics, it ' s just that in terms of research, i added nanostructures, atomic movement on the surface of materials, and at this time started collaborating with people in other departments at this school

    我所在的系是航空與機械繫，我還是做我的作力學老本行，只是研究的對象又加了納米結構、材料表面上的原子活動，並在這時開始和校內其他系的人合作。
  10. Because of the former anchorage systems designed according to matching 1860mpa strength strands in the beginning of 90 ", they can not be suitable any more for the super strength strands with 2000mpa. therefore, some accidents occurred such as strands sliding and broken when tensioning. in addition, the advantages of the new materials as their high mechanics performance are not be used completely as the prestressing structures was designed as per the 1860mpa strands, which will result in the waste of materials, in view of the above - mentioned facts, by means of analyzing the development of anchorage systems home and abroad, in connection with the characteristics of the super strength strands ( 2000mpa ), this topic made a research on hvm15 anchorages by theoretical calculation and finite element analysis, and also on the manufacturing process and test

    隨著預應力技術的發展和冶金工業冶煉技術的不斷進步，預應力鋼絞線的強度不斷提高，由原來1470mpa提高到1860mpa ， 90年代末期已出現了2000mpa超高強鋼絞線，而原來的是在90年代初期按抗拉強度為1860mpa的鋼絞線標準設計的，因此，原有的錨具已不能適應現有超高強度2000mpa的鋼絞線強度要求，在工程中出現了斷絲滑移現象，同時，在使用和設計時仍按1860mpa鋼絞線的指標進行設計應用，沒能充分發揮材料的力學性能，造成材料浪費。
  11. This paper introduces the principle of instrumented impact test method and its application in production and scientific research. emphasis is laid on achievements obtained in the field of developing measurement technique of fracture mechanics, analyzing characteristic parameter of impact curves as well as studying fracture mechanism of materials. in addition, the application and developing trends in the near future are also discussed in the paper

    介紹了儀器化沖擊試驗方法的基本原理及其在生產和科研中的應用，重點闡述了儀器化沖擊試驗方法在動態斷裂力學測試技術中的開發、沖擊曲線參數分析、材料斷裂機理研究等領域所取得的成果，並展望了這一方法未來的應用和發展趨勢。
  12. It is importance of the experiment about measuring principal stress combined bending with torsion in mechanics of materials. this paper points out shortcomings in the traditional experimental devices combined bending with torsion and establishes theory and principles for designing superminiaturizational experimental device combined bending with torsion through analyses of stress and strain state at the measured point a ( b ). it also designs the superminiaturizational experimental device, which has smaller space and more precision and has more reasonable structure measurements in this paper

    彎扭組合主應力測定實驗在材料力學實驗中佔有重要的地位，作者指出了老式彎扭組合實驗設備的缺點，通過對所測點a （ b ）處應力應變狀態分析，確立了設計超小型化彎扭組合實驗裝置的理論基礎、設計原則，設計出了體積小，加載簡單，結構尺寸合理，精度高的超小型化彎扭組合實驗裝置。
  13. Depending on the tenth five - year plan by china, the workability, physical mechanics property, durabilities of concrete were systematic studied. combining with micro - structure test and applying the laws between the composition, structure, qualitiy of materials and considering the production cost of engineering, the principle of the design and technique route of mamufacturing low - cost high performance concrete ( lc - hpc ) was put forward. the important theoretical and technological support for the design, application of lc - hpc is provided

    本文以「十五攻關」課題為依託，對混凝土的工作性、物理力學性能、耐久性能進行了系統實驗研究，通過與微觀結構測試相結合，應用材料組成、結構與性能的規律，考慮生產成本並結合工程應用，提出低成本高性能混凝土（ lc - hpc ）配製的設計原則與技術路線，為lc - hpc的設計、應用提供了重要的理論與技術支撐。
  14. A ferromagnetism rod is chosen as sample which is often used in the experiment of materials mechanics, was placed in the earth magnetic field and was under the application of stress

    本論文以材料力學實驗中常用的鐵磁性桿件作為研究對象，將其放置於地磁場中，受到應力的作用。
  15. According to the relationship between material fatigue performance curve and concerned parameters in fracture mechanics, the relationship between fatigue life and crack half length is obtained, that is equivalent crack length of fatigue life. the function relationships between these two aspects are constructed. the experiment data show that this method can express the same character of fatigue life of all kinds of materials and experiment data acquired from different materials can be used each other

    通過材料力學疲勞性能曲線和斷裂力學之間有關參量間的演變關系，得到了疲勞壽命與裂紋半長的關系，即疲勞壽命的折算裂紋長度，建立了兩者之間的函數關系並利用這個函數關系說明了疲勞壽命的切線模量因子法，能反映各種材料疲勞壽命的共同變化規律，試驗數據可在不同材料之間互相參考使用，具有重大意義。
  16. The electroelastic interaction of dislocation, inhomogeneity and interior defects is a greatly significative subject in the fields of solid mechanics and materials science

    復合材料中位錯與夾雜及內部缺陷之間的電彈干涉效應問題，是當前固體力學與材料科學研究領域的前沿熱點課題。
  17. This article, which unravels the principle of mechanics of materials, and clarifies hooke ' s law, and its condition found by zheng xuan, narrates points differing from yi degang ' s and discusses the problem of history of mechanics

    摘要從材料力學的原理出發，解讀和闡明鄭玄的發現，證明鄭玄和胡克的表述是等價的，但都有些不足，並認為鄭玄具備發現彈性定律的條件，從而否定了儀德剛等人的觀點。
  18. Probing into teaching reform and bringing about new ideas of mechanics of materials

    淺議材料力學課程教學改革與創新
  19. The second discusses the curvature model as a theoretical method of the damage from the knowledge of mechanics of materials the curvature and the moment shared a linear relationship

    第二部分提出曲率模態作為結構檢測的理論依據。根據材料力學知識可知，結構的曲率與彎矩存在著線性關系。
  20. During the investigation, a mechanical model of the novel drive mechanism was established based on the large deformation theory in the mechanics of materials, and the maximum transmission force of the mechanism was formulated and calculated

    基於材料力學大變形理論，建立了微小彈性嚙合輪傳動機構的力學模型，推導了最大傳動力的表達式，應用該表達式計算了所設計機構的最大傳動力。
分享友人
分享到 Line

分享到臉書