minimum resistance 中文意思是什麼

minimum resistance 解釋
取弓電阻
  • minimum : n （pl minimums ma ） 最小，最低，最少限度；【數學】極小（值）。 the irreducible minimum 無法減少...
  • resistance : n. 1. 抵抗，反抗，抗拒，抵禦；敵對，抵抗力，反抗力，阻力，【生物學】抗病性。2. 【電學】電阻；阻抗；電阻器。
  1. Our data indicate that it was possible to increase the level of this type of protein in the diet above the minimum requirement ( 12 % lah ) and thus produce augmented humoral immune responsiveness and resistance to salmonellosis

    資料顯示提高此類蛋白質補充劑的水平超過最低需求量時，可增加體液免疫反應及對沙門菌的抵抗力。
  2. Lastly, the minimum permission reliability index is offered by the method of " calibration method " which makes back calculation out of the bending resistance reliability and the compression resistance reliability of the reinforced concrete member in norm

    最後，根據「校準法」反演計算現行設計規范中鋼筋混凝土結構抗彎、抗壓可靠度指標以確定在用橋梁結構體系的最低目標可靠度指標。
  3. When sno2 wt % was controlled for 10 %, the square resistance of sn - in2o3 was minimum. through the characterization of in2o3 / sno2 nano powders, some conclusions were drawn : sno2 nano powder is rutile structure, and in2o3 and sn - in2o3 nano powders are cubic structure. in2o3 / sno2 nano powders were well dispersing with spherical uniform grain, and the mean grain was 4 - 50 nm

    通過對inzo3 / snoz納米粉體表徵，得出inzo3 / snoz納米粒子多呈球形、顆粒均勻、分散性良好、組分均勻、純度較高、平均粒徑在4一50lun左右、比表面積達67一156mz / g ; snoz納米粉為正四面體金紅石結構， inzo3和sn一inzo3納米粉為體心立方結構。
  4. If line length is half wave at a certain frequency and both the load resistance rt and source resistance rs are higher than the characteristic impedance zo, then both the voltages at input and at load are maximum at that frequency and both the voltages at input and at load are minimum at half of that frequency

    負載端電阻及電源電阻均高於傳輸線特性阻抗情況下，當線長為某頻率波長之半波，則輸入端與負載端電壓在該頻率均為最高，在該頻率之半時則電壓均為最低。
  5. If line length is half wave at a certain frequency and the load resistance rt is lower while source resistance rs is higher than the characteristic impedance zo, then both the voltages at input and at load are minimum at that frequency and both the voltages at input and at load are maximum at half of that frequency

    負載端電阻低於傳輸線特性阻抗及電源電阻高於傳輸線特性阻抗情況下，當線長為某頻率波長之半波，則輸入端與負載端電壓在該頻率均為最低，在該頻率之半時則電壓均為最高。
  6. Make using of the critical point of the arch failure transiting to the tooth failure ( which is also the point when the non - stirrup beam ' s shear bearing capacity arrives to its minimum ) which is advanced in the arch - tooth theory of beams without shear reinforcement by g. kani and the critical point of the diagonal - tension failure transiting to the shear - compression failure which is advanced in the anti - theory, the minimum shear resistance of general bea ms which is destroyed in the range of shear - compression failure is advanced

    利用g . kani提出的拱?齒理論中的無腹筋梁的拱齒破壞的分界點（也就是無腹筋粱的最小抗剪承載力點） ，再結合前述理論中所提出的梁剪壓破壞和斜拉破壞的分界點，提出了梁在延性的剪壓破壞范圍內的最小抗剪承載力，並與混凝土結構設計規范gb50010 - 2002比較，結果吻合較好。
  7. The minimum shear resistance of beams in the paper is close to the one in the code for design of concrete structures " gb50010 - 2002 '. according to the actual project, the destroy of 448 kinds of beams are analyzed by computer by taking account of the effective coefficient " " of the strength of concrete confined by hoops, the relationship with the section property of beams, the critical point of the arch - rib failure transiting to the shear - compression failure which is advanced in the anti - theory, and the contribution to the beam ' s shear resistance of the concrete in the shear - compression zone

    引用箍筋約束混凝土的有效系數，利用其與梁截面特性的關系並結合理論分析中提出的梁剪壓破壞與斜壓破壞的分界點，同時考慮了剪壓區混凝土的抗剪貢獻，從工程實際出發，編程擬算了448種梁構件的破壞情況，計算結果表明，梁發生在剪壓破壞范圍內的最大抗剪承載力值比混凝土結構設計規范gb50010 - 2002值略高。
  8. The optimum dosing amount of coagulant which make the minimum resistance is in conformity with the optimum value which remove maximum dissolved organic matter in water studied

    使膜過濾阻力最小的最佳混凝劑投加量與去除水中溶解性有機物效果最佳的投加量一致。
  9. Because the contact resistance between the metal contacts and the superconducting films has large impact on the performance of superconducting filters, we experimental techniques. after annealing the optimum temperature and, we got the minimum contact resisitivity. we also further studied the interaction between ag and ybco films after annealing at a certain temperature and attempted to give an explanation and discussion

    金屬接觸電極與超導薄膜之間的接觸電阻對超導濾波器的插入損耗有很大影響，因此，本文通過多種實驗方法，系統的研究了ag與ybco超導薄膜之間的接觸電阻問題，得到了最佳退火溫度，並對退火時ag與ybco超導薄膜之間相互作用的機理進行了研究和探討。
  10. Wall panels with god light solid firewall : minimum and most waterproofing curing and most provincial area, the best free power, the highest level of fire safety, earthquake resistance performance of the best and most noise, the maximum effectiveness, the most convenient construction, the largest span of 10 highly unparalleled advantages

    壁神輕質實心防火墻板具有：最輕、最防水防潮、最省面積、最佳吊掛力、最高防火級別、最佳抗震抗沖擊性能、最隔音、最高功效、最施工方便、最大跨度高度十項無與倫比的優點。
  11. The contact resistance reduces to the minimum level of 6. 6 10 - 6. cm2 after annealing for 1min at 900 ; the deposition of ni / au on algan is demonstrated for a good schottky contact performance, the leakage current is at a low level of 10 - 8a

    首先，極化效應是iii - n化合物異于其他iii - v化合物的最大特徵，因此對algan / gan異質結極化效應進行了分析。
  12. The conclusion showed that the oxygen always made film ' s resistivity increase. the surface sheet resistance decreases with increasing dc power of zn target, zao thin films show minimum resistivity at the power of 100w ; the conductivity get worse with further increase in dc power

    實驗證明氧氣的存在，會使得薄膜導電性降低；而隨著濺射功率的增加，薄膜的導電性變好，但當功率超過100w后，薄膜的導電性反而變差。
  13. All have straight - through ports to assure minimum turbulence, erosion, and resistance to flow

    所有流道都是直線通過流道，確保湍流、侵蝕和流動阻力降到最小程度。
  14. 2. minimum insulated resistance core - core shield 5000m. km 3

    最小絕緣電阻：芯一芯屏蔽5000m . km
  15. Entry - as your hand enters the water to full extension you want to have minimum resistance and turbulence

    入水當手掌入水時，你要想阻力和湍流最小，手掌就要完全伸直。
  16. Jedec ? the resistance between specified terminals with input conditions applied that, according to the product specification, will establish minimum resistance ( the on - state ) between those terminals

    按加到輸入端的條件的特定埠間的阻抗，根據產品技術規范，將在埠間建立最小的阻抗（導通狀態） 。
分享友人
分享到 Line

分享到臉書