motion equation 中文意思是什麼

motion equation 解釋
運動方程
  • motion : n 1 運動 動 移動（opp rest）。2 （天體的）運行；（車、船等的）動搖；（機器的）開動 運轉；【機械工...
  • equation : n. 1. 平衡，均衡；平均，相等。2. 【數學】方程式，等式。3. 【天文學】（時）差；均分，等分。4. 【化學】反應式。
  1. By means of the analysis on motion equation of simple pendulum, a method for testing the moment of inertia of a complex shaped rigid - body moving around a fixed axle under the condition of not knowing the barycentric position of the object was obtained

    摘要通過對單擺運動方程的分析，得到了未知物體質心位置條件下測試復雜形狀剛體繞定軸轉動慣量的方法。
  2. This paper discussed effects of ship swaying motion in waves on ship - based cannon firing in terms of ship motion equation and theory of artillery shoot, including influence on shoot distance and direction

    摘要從船舶在海浪中運動模型出發，結合炮兵射擊學原理，研究船舶搖擺導致火炮基座運動以及桿臂效應導致子慣導初始對準誤差等因素對火炮射擊的影響，主要針對船載炮射擊在距離與方向的影響進行分析。
  3. With the sample of longitudinal motion equation, calculating hydrodynamic coefficients by the potential fluid theory is introduced

    並以其縱向運動方程為例，詳細介紹了用勢流理論求解水動力系數的方法。
  4. The design undertaken mainly from the following aspects : 1, mechanism ddesign : included the base and the joints : 2, trasmission mechanism design : adopted a synchronous toothelike transmission bell ; 3, balance system design : adopted springs and a brake and a lay air cylinder ; 4, design parameter and verify alculation ; 5, established motion equation by d - h method ; 6, simulated the motion locus by matlab software ; 7 ^ mapping out the part drawing or asesembly drawing

    本設計主要是從以下幾個方面入手： 1 、機構設計：包括底座和臂關節的設計； 2 、傳動機構設計：將驅動電機安裝在底座上，利用同步齒型帶、離合器傳遞手臂的動力；利用齒輪傳動帶動底座回轉； 3 、平衡系統設計：採用了彈簧平衡系統、電磁式制動器和單向延時氣缸； 4 、設計參數和校核計算； 5 、用d ? h法建立運動學方程； 6 、利用matlab軟體對手臂的運動空間進行模擬； 7 、利用autocad2000繪圖：包括零件圖和裝配圖。
  5. A new manipulator has been developed which driven only by two motors systema - ticly and completely. a typical representative mechanism model which called r3p manipulator has been designed. the author established the motion equation by d - h method and simulated the motion locus in space by matlab software

    本文較系統、全面的設計了僅由兩臺驅動電機帶動多個關節的新型多關節機械手臂傳動機構，並具體設計了具有代表性的r ~ 3p型機械手臂的機構模型；作者對該r ~ 3p型機械手臂進行了運動學分析，用d ? h法則建立了運動學方程，並利用matlab軟體對其手臂的運動空間進行了模擬。
  6. What the fw motion equation describes is the coupling ratio of the motion speed of the model and payout

    Fw運動控制方程所描述的是絲嘴和芯模的速度耦合關系。
  7. Finally, the 2d unsteady navier - stokes flow solver is coupled with two - degree - of - freedom flutter motion equation in time domain to investigate the flutter characteristics of several supercritical airfoils

    最後，本文將二維非定常nayier - stokes方程解算器與顫振運動方程耦合，研究了超臨界翼型的跨音速顫振特性。
  8. Based on the structural feature of long blade with friction damper, pretwist beam element and space straight beam element were adopted to discrete the blade, and the numerical model of damper link element was established, then the gross finite element motion equation of the blade was obtained

    針對帶摩擦阻尼器長葉片的結構特點，採用扭曲梁與空間直梁單元模化葉片，推導葉片阻尼連接單元的力學模型，由此建立葉片總的動力特性分析方程。
  9. To deal with the optimum diameter of pipe roofs applied in underground engineering, an algorithm for the sensibility analysis of pipe roof displacement based on the incremental motion equation was developed

    摘要針對當前管棚應用范圍日益廣泛和管徑的多樣化，本文推導了基於增量運動方程的管棚位移敏感度分析方程，編制了程序。
  10. With the assumption of insignificant vibration and the results obtained in the sixth chapter, the linear solution for the motion equation of forced vibrating pipe with fixed supports in two ends in steady vibration is derived

    首先，在微小橫振動假設前提下，利用第六章的計算結果，用線性化方法推得了兩端固支水下輸液管道在穩態繞流條件下的強迫振動方程的解。
  11. Numerical results show that the bubble concentration distribution can be predicted by using the two - way coupling of the fluid and the bubble motion, and adding the wall lift force into the bubble motion equation, and the fluid velocity, turbulence intensity and shear stresses modified by the bubble motions can also be revealed

    數值模擬結果表明，通過加入壁面升力和採用雙向耦合方法，可以較準確地預測氣泡濃度分佈和揭示氣泡流動對流體湍流結構的影響。
  12. Angular motion equation

    角運動方程
  13. Motion equation of single particle in flow field of turbomachines

    渦輪機械流場中單顆粒的運動方程
  14. Prestack migration method, based on wave motion equation, is also developed for receiver function, and compared with ray method. both p - to - s conversion wave and direct p phase contained in receiver function are migrated and imaged by reverse - time migration for data gather including all receiver functions recorded in all seismological stations for one event, and imaging profile is finally obtained by stacking for all events

    本文還在接收函數射線反投影疊加成像的基礎上，提出了一種基於波動方程的接收函數疊前偏移成像方法，將同一事件接收函數中的轉換波和直達p波震相以各自的速度向深度方向逆時延拓成像，並通過不同慢度接收函數的疊加，得到最終的偏移成像結果。
  15. The mathematical model of non - linear transient magnetic field excited by voltage source is established in this paper. it coupled with electric circuit equation and mechanical motion equation, could solve the transient problem excited by voltage source, and the effect of the eddy currents, non - linearity in magnetic materials and mechanical motion of medium is taken into account

    文中建立了電壓源激磁下的非線性瞬態磁場的數學模型，通過把瞬態磁場方程、電路方程及機械運動方程耦合在一起，得出求解電壓源激磁下，考慮鐵磁材料的非線性、導電媒質的渦流及媒質機械運動等條件下的瞬態過程問題。
  16. The magneto - elastic motion equation and the electrodynamic equation of the thin strip conductive plate in a leaning magnetic field are derived on the basis of the principle magneto - elastic theory, and the characteristic equations of the vibration of the plate supported along two long sides are obtained as well

    摘要以磁彈性基本假設為出發點，給出了傾斜磁場中無限長條形薄板的磁彈性運動方程及電動力學方程，並推得了兩長邊簡支薄板的磁彈性振動特徵方程式。
  17. This dissertation has studied the structural model and model predictive control ( mpc ) algorithm that was first implemented for the structural vibration control of the tall building under earthquake excitation. based on analyzing structural motion equation and the state space form equation of the earthquake - excited structural model of the tall building, predictive model and control objective functions are defined and the mpc system of the tall building is set up

    本文主要研究高層建築結構振動控制的結構模型和預測控制演算法，首次將預測控制應用到高層建築結構地震反應控制中，在分析受地震波激勵的高層建築結構模型的運動方程及其狀態空間形式方程的基礎上，確定預測模型和控制目標函數，建立高層建築結構預測控制系統，從理論上對預測控制在高層建築結構振動控制中的應用進行研究。
  18. The motion equation with time delay is presented. the time delay effects on the performance of active control system for platforms are investigated

    建立了包含時間滯后的海洋平臺-主動控制裝置的振動控制方程，分析了時間滯后對主動控制所產生的不利影響。
  19. The results indicate that the curve is concave when the velocity is very low. 2. motion equation of every kind of flow pattern in porous media is derived by simulated theory

    實驗結果表明，在低速滲流階段，滲流曲線為上凹型，到一定流速后，滲流曲線為線型，但不過原點。
  20. Application of the cauchy ' y law of continua, the motion equation of the tetrahedral element is concluded, and discretization the analysis zone, applying the finite difference method, all tetrahedral differential equations of motion are converted into the nodal finite difference equation

    快速拉格朗日分析程序運用連續介質的柯西定律，推導出四面體單元運動偏微分方程，並離散化分析區域，用有限差分計算方法，把所有的四面體單元運動偏微分方程等效成節點有限差分方程。
分享友人
分享到 Line

分享到臉書