nano composite materials 中文意思是什麼
nano composite materials
解釋
納米復合材料-
On the basics of briefly summarizing the research and application presents of building coatings and nano - composite building coatings in domestic and overseas, presented a creative approach of modified exterior building latex coatings applying inorganic nano - powders and its " compound. systematically studied the effect of factors such as nano - materials " category, additive capacity, dispersing method on the behavior of exterior building coatings " weathering resistance, scratch resistance, water resistance and alkaline resistance etc. studying on uv - vis optical property of nano - powder materials and its " compounds turned up that nano - tio2, nano - sio2, nano - zno have excellent characteristics to uv shielding ; dispersing system of polybasic nano - composite materials owned higher uv shielding capability than single disperse system
本文在簡要敘述國內外建築塗料和納米復合建築塗料的應用研究現狀的基礎上，提出了使用無機納米粉體及其復合材料改性建築外墻乳膠漆的創新思路，系統地研究了納米粉體材料的種類、添加量、分散方式等因素對外墻乳膠漆耐候性、耐洗刷性以及耐水、耐堿性等性能的影響，成功地開發了納米改性建築外墻乳膠漆產品，並完成了外墻乳膠漆用納米助劑的初步開發工作。 -
This work aimed at the problems of phase change materials ( pcms ) exudation and low content of pcms, prepared temperature self - operating units ( tsous ) by the packaging method of organic / inorganic nano composite materials. optimization of experimental parameters was carried out and the evaluation method of properties was studied to acquire tsous with the maximum pcm content and high stablity
本文針對國內外現有自調溫材料容易滲出相變工質材料、相變工質材料含量低等問題，採用有機無機納米復合法包覆相變工質材料制備自調溫單元，研究優化制備工藝及性能評價方法。 -
Recently, anodic aluminum oxide ( aao ) membranes with a regular porous structure have been prepared by electrochemical methods and have widely been used to produce various nanostructured materials within highly ordered channels in the aao membrane in which the diameters and lengths of the inserted nanowire can be well controlled. in this dissertation, after reviewing the latest development in research of the novel system of nano - array composite by using template method, reports my research work of fabricating metal / aao nano - array composite and their novel optical properties in the past few years. different metal / aao composites ranging in volume fraction of the metal showed unusual size - dependent optical properties, some important results obtained are as following : 1
接著論文全面總結了作者近幾年以金屬aao納米有序陣列復合結構光學特性為選題的研究工作：進一步優化了制備金屬aao納米有序陣列復合結構的工藝參數，較系統地考察了分別由幾種不同金屬（ co 、 ni 、 ag 、 cu ）植入aao模板后，合成的納米有序陣列復合結構樣品的光反射、透射和吸收等一般光學特性，還專門研究了各系列結構樣品吸收邊的頻移、金屬納米粒子表面等離子激元共振吸收特性，以及特殊的半導體光學特性等。 -
Preparation process of titania - mica composite nano - materials
白雲母納米復合材料工藝的研究 -
The objective of this paper is to obtain metal - ceramic composite materials with better complex properties by the way of preparing nano - composite powders of metal and ceramic. in our thought, firstly we should prepare nano - ceramic powders coated with metal, and then during the period of sintering, the film of metal could prevent the nano ceramics powder from dumpling and keep the powders to be nano - sized
這樣，在隨后制備塊材的燒結過程中，由於復合粉體復合充分，相容性提高，結合力高，另外金屬表面層可抑制納米陶瓷粉體的融合長大，使粉體在燒結后保持納米尺寸，從而發揮納米顆粒的作用；同時通過引入均勻分佈的韌性金屬相，進一步改善陶瓷的脆性。 -
According to the microstructure, the tsous are consist of two sections : the adsorbent of micropore inorganic materials and pcms. tsous with the maximum pcm content and high stability may be prepared by making good use of the nano effect and surface effect of organic / inorganic nano composite materials. according to the microstructure, the saturated adsorption amount of micropore inorganic material is 73. 47 %
應用該模型制備自調溫單元，可利用材料的納米尺寸效應和表面效應，在納米孔道的內壁上形成吸附力的疊加，使微孔內部具有強的吸附勢，可得到相變工質材料含量最大且性能穩定的自調溫單元；該模型中微孔無機材料對相變工質材料的理論飽和吸附量為73 . 47 。 -
The inserting method and properties of the composite materials in consist of omt and poly ( styrene - butyl acrylate ) had been researched ; the ultra - fine organic rigid particles crosslinked polystyrene ( xps ) has been synthesized by emulsion polymerization, the effect of the synthesis process on the size of organic rigid particles was discussed. the cause of the increasing mechanical properties of pp composite materials, which were strengthened and toughened with organic rigid particles and elastomer, had been investigated. the results of studying viscosity and precipitate height of sio2 nano - particles suspension showed that the sio2 nano - particles are very good dispersed by dp270 or cat 639w dispersant
通過粘度法和沉降法測定結果的一致性，說明分散劑dp270和cat639w對sio _ 2納米粒子有較好的分散性， dp270的最佳用量為0 . 2時懸浮液粘度從35 . 1mpa ? s降為23 . 3mpa ? s ， cat639w最佳用量為0 . 4時懸浮液的粘度從35 . 1mpa ? s降為23 . 1mpa ? s ；通過研究分散劑存在下納米粒子的苯丙乳液聚合動力學，發現納米粒子的存在對乳液聚合有一定的緩聚作用，並討論了乳化體系、溫度、引發劑、表面處理劑以及納米粒子用量對聚合的影響。 -
It ' s well known that nano - materials have good ductility, and the composite powders have the better consistency properties. on the other hand, because the metal phase was evenly distributed, the ductility of the ceramic composites could be promoted further
因此，本文的研究內容設定為用化學鍍的方法在納米級的al _ 2o _ 3陶瓷粉體上包覆金屬銅，制備納米的金屬包覆型陶瓷復合粉體。 -
This paper focuses on recent progress of preparation of crystal alloy, nano - crystal alloy, amorphous alloy and composite electrode materials by the electrochemical method, and the mechanism of catalytic activity of hydrogen evolution reaction ( her ) is reviewed
介紹了採用電化學方法制備晶態合金、納米晶合金、非晶態合金及復合金屬等析氫電極材料的研究進展，並對電極催化析氫機理進行了概述。 -
The configuration, compound mechanism of inorganic nano - particles, resent research advances in preparation of composite materials by filling inorganic nano - particles into epoxy resin and the theory of action were discribed
介紹了無機納米粒子的結構，復合機理，用其填充改性環氧樹脂復合材料的制備方法，作用機理及研究進展。 -
Preparation and characterization of leather polyurethane sio2 nano - composite materials
2納米復合材料的制備與物性研究 -
Numerical simulation of equivalent elastic modulus for metal matrix nano - composite materials using homogenization method
金屬基納米復合材料等效彈性模量的均勻化方法數值模擬 -
In this thesis, the structure, preparation method and basic properties of embedded nano - composite materials and photo luminescence of nanocrystalline silicon have been summarized. research of photoelectric devices using several kinds of silicon - based nano - materials has also been presented
本論文全面介紹了納米材料，特別是納米鑲嵌復合材料的結構特徵、性能特性及由此產生的基本性質的變化、常用的制備方法以及硅基納米復合材料在制備和發光機理方面的研究，並對硅基納米復合材料在光電器件中的應用和發展做了概述。 -
In this thesis, the history, structure. preparation method and basic properties of nano - composite materials and photoluminescence of nanocrystalline silicon have been summarized. research of the novel antireflecting energy saving coating glass has also been presented. the si / sic composite films are prepared with siht and ? 2 ^ 4 as the source gas by atmosphere pressure chemical vapor deposition ( apcvd )
本論文全面介紹了納米材料，特別是納米鑲嵌復合材料的發展概況、特性、常用的制備方法、常見的幾種硅系納米材料以及有關納米硅材料的發光，並對新型無光污染節能鍍膜玻璃的研製和發展作了概述。 -
The adsorption theory of micropore inorganic materials was studied to direct the preparation of tsous by organic / inorganic nano composite materials. the microstructure of tsous was established based on the theory that the micropore is filled during the process of micropore materials adsorption
研究了微孔無機材料的吸附理論，提出微孔材料的吸附過程相當于工質材料對微孔的充填，其孔體積均為吸附空間。 -
Preparation and characterization of nano - hydroxyapatite chitosan - chondroitin sulfate composite materials
硫酸軟骨素復合材料的制備及其性能研究 -
Hydriding properties of mg x mm nicomnal 5 nano - amorphous composite materials prepared by ball milling
5復合儲氫材料吸放氫性能研究 -
In this study, two types of nano particle sulfur composite materials were designed and prepared, that is, conductive - polymer / sulfur composites and active - carbon / sulfur composites, which can be used as advanced cathode materials for rechargeable lithium batteries. sulfur / conductive - polymer composites were prepared simply by thermal treatment of a mixture of elemental sulfur and polymer
在一定溫度下，單質硫與有機聚合物發生反應，使有機聚合物脫氫硫化並形成導電聚合物硫復合材料，所採用的有機聚合物包括pvc 、 pe 、 pan 、 pp等多種常見的塑料。 -
The nano - composite coatings can be manufactured by selecting appropriate nano - materials and polymer. the high abrasion resistant transparent coatings can apply for furniture floor and resin lens or eyeglass and other similarities. the coating has very important applied value
選擇合適的納米材料與合適的高分子材料制備納米復合塗料，來獲得高耐磨高透明性的塗料，使其應用於傢具地板、樹脂鏡片及其它需要提供耐磨性和透明性的領域具有十分重要的應用價值。 -
When quantity of nano - zno increased, the rubber composite materials appeared good effect on enhancing the anti - aging ability and wear - resistance but less on mechanic properties. nano - zno modified by coupling agent was applied to reinforcement of hope. mechanic properties of nano - zno / hdpe composites were investigated and compared with nano - zno without surface treatment
結果表明：納米氧化鋅具有更高的反應活性， 」非o米村料川量較少時，體系的硫化時問有延遲現象，們隨納米氧化鋅粒徑的減小和用量的增加，橡膠的硫化時間不斷縮短。
分享友人