normal polarity 中文意思是什麼
normal polarity
解釋
正常極性-
When a ferromagnetism items is under the application of stress, the phenomenon that the tangential component of magnetic leakage field has maximum value and that the normal component of magnetic leakage field changes polarity and acquires zero value at the stress concentration zone will take place
鐵磁性工件在受到應力作用時，在應力集中處會有漏磁場的切向分量出現最大值、同時法向分量改變符號且過零值點的現象。 -
The disease in jaw surface will be drop the bite force ; the bite force in the patient who disease in temporal jaw joint descent obviously than normal person ; serious mistake in join deformity, the acute damage in the area arthritis can also drop the bite force evidently ; compare to normal children, wenneberg fund that the bite force lower and the duration of the biggest bite force shorter in the children who fall ill of the chronic arthritis ; the bite force also be used in appraise of the recovery condition in surgical operation 、 disorder in jaw arthritis and the serious bone offset in bite lopsided etc. some materials, it will be produce polarization phenomenon inside when suffered some force in certain direction, at the same time, it produce opposite electric charge in two of the surface ; and resume to the station of on - electrification when removed the outside force ; change the direction of the outside force, the polarity of the electric charge also be changed, this kind of phenomenon is called as “ piezoelectric effect ”
本文設計了石英晶體壓電傳感器，以它作為傳感元件把咬合力信號轉變成電信號;利用ts5860型準靜態電荷放大器把傳感器的電荷信號轉變成電壓信號;選用usb7822數據採集卡，編寫該數據採集卡的驅動程序，採集該電壓信號並送到計算機里;編寫labview程序對該信號進行處理，得出咬合力值和咬合力曲線，並把測量結果以電子表格的形式保存，以便做進一步的分析和研究。通過對該測量儀的靜態標定、動態標定、溫度漂移標定以及實際測量試驗，證實了本測量儀具有較高的靈敏度、受動態力和溫度變化的影響比較小、能實時地顯示咬合力曲線和較準確地顯示咬合力值，滿足了咬合力測量的要求。 -
In the dissertation, the effects of bias voltage polarity on the measurement and the normal operation are deeply researched when the voltage polarity is positive - positive, negative - positive and negative - negative respectively. the results are compared with the ones studied by others when the voltage polarity is positive - negative. the air damping of the laterally driven microstructures is slide - film air damping
本文通過改變偏置電壓極性分別為正?正、負?正、負?負，並和偏置電壓極性為正?負配置時進行對比，深入研究了電容式傳感器在不同偏置電壓極性下，驅動信號產生的靜電力對傳感器檢測和工作性能的影響。
分享友人