normal weld 中文意思是什麼
normal weld
解釋
標準焊縫-
Abstract : with the aids of computer ' s hardware, executive mechanism of weld arc length automatic controller of all - position pipe welder and additional software, an automatic system for arc striking has been developed, in which touch - starting method using tiny current is introduced. utilizing this method, the ablation ratio of tungsten electrode and tungsten inclusion ratio of welded seam is far smaller than normal touch - starting method. and the successful ratio of arc striking is high
文摘:用全位置自動焊管機弧長自動控制系統的計算機硬體和執行機構，僅增加部分程序，設計了採用小電流接觸引弧法的自動引弧系統，鎢極燒損和焊縫夾鎢遠小於普通的接觸引弧方式，引弧成功率很高。 -
This paper takes advantage of numeric simulation technology to investigate the weld - line movement and formability of twb with the same property and different thickness, analyzes the weld - line movement in three different drawing ways with the same drawing depth, and shows the normal rule of weld - line movement in different drawing ways, and the relationship between the weld - line movement and formability of twb of different thickness
摘要本文利用數值模擬技術對相同材質差厚拼焊板的沖壓成形性和焊縫移動進行研究，分析了相同拉延深度、不同拉延方式下焊縫移動情況，揭示了不同拉延方式下焊縫移動的一般規律和焊縫移動量與差厚拼焊板成形性之間的關系。 -
These rules consist of the total fit, the mathematics and fatigue physics, and the safety in tail predictions. an analysis of the test s - n data of 16mn steel weld joints reveals that the four models are reasonable if only considering the total fit as the conventional method did. but if by the present three rules, the appropriate models should be the normal or the extreme maximum value
根據先前提出的有限數據下良好假設分佈的確定方法，包括三個原則，即假設分佈形狀與誤差數據真實分佈形狀的一致性、預測的總體擬合效果、與疲勞失效機制的一致性和尾部預測的安全性，通過對線性均值s - n曲線擬合16mn鋼焊接頭s - n數據誤差的統計分析，說明應用一般推斷方法， 4種分佈都可合理地作為數據的統計模型，綜合考慮三原則后，極大值和正態分佈是可能的良好假設分佈。
分享友人