operating test 中文意思是什麼

operating test 解釋
操作試驗
  • operating : adj 1 運行的；操作的；工作的。2 關于業務的；營業上的；關于收支的。operating expenses 業務開支；營...
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  1. These character based on sichuan power network ' s practice operation experience, in allusion to the config of the carrier wave protection in bypass breaker operating, through the study of protection ' s typical config : one side lfp - 902a, one side csl - 101a, proceeded comprehensive act module test, noted plenty of first hand test data and wave picture, proceeded detailed theory analyses, plenitude demonstration atresic type carrier wave distance protection when twain side atresic type logic is not completely same, basically can fill power network ' s requirement to relay of reliability selectivity speedly and sensitively

    本文結合四川電網的實際運行經驗，針對旁路開關代路運行時的保護配置情況，通過對旁路代路時保護典型配對組合：一側lfp - 902a ，一側csl - 101a的保護配置情況的深入研究，做了全面的動模試驗，記錄了大量的第一手試驗數據和波形，進行了詳細的原理分析，充分驗證了高頻閉鎖式距離零序保護在兩側閉鎖式邏輯不盡一致的情況下，基本能夠滿足電網對繼電保護的可靠性、選擇性、快速性以及靈敏性的要求。
  2. Domestic furniture. seating. test method for the determination of the durability of reclining and or tilting mechanisms and operating mechanisms for convertible sofa beds

    傢具.座椅.活動沙發床向後靠和或微傾機構以及操作機構的耐用性測定的試驗方法
  3. Domestic furniture - seating - test method for the determination of the durability of reclining and or tilting mechanisms and operating mechanisms for convertible sofa beds

    傢具.座椅.活動沙發床斜靠和或微傾機構以及操作機構的耐用性能測定的試驗方法
  4. Domestic furniture - seating - test methods for the determination of the durability of reclining and or tilting mechanisms and operating mechanisms for convertible sofa beds ; german version env 13759 : 2000

    傢具.座椅.測定活動沙發床斜靠力和或微傾力以及操作
  5. Starting with the application of power plant simulator, and for purpose of solving the practical problems of discommodious ness 、 subjective test result in the test of simulator training, summarizing the experience in the research and apply of the scoring system software of the test of simulator training, a operating skill model is built and a design for universal scoring system for the test of simulator training is brought forward based on the operating knowledge of power plant equipment and simulator and the theory of expert system. and the scoring system is realized by programming

    本文從電站模擬機的實際應用出發，以解決當前模擬機培訓考核中考核不方便、考核結果有失客觀性等實際問題為目的，總結目前關于模擬機培訓考核成績評定系統軟體的研究和應用的經驗，以電站設備和模擬機的各種運行知識為基礎，並結合專家系統的理論，建立一個評價模擬機學員操作水平的模型，提出了一種模擬機培訓自動評分系統的設計方法，並通過編程實現了這個成績評定系統。
  6. In order to look for the key factors governing fluidization characteristics in the dense phase pulverized powder feeder, the effects of the different operating conditions and the geometrical variables on the mass ratio of powder and gas and the stable conveying time of the system were investigated in the self - developed special dense phase powder conveying test - bed

    摘要為了尋找影響濃相粉體給料器流化特性的關鍵因素，在自行設計的專用小型濃相粉體輸送試驗臺上，考察了不同操作參數和結構參數對輸送固氣質量比和穩定給粉時間的影響，總結了各因素對流化質量的影響規律。
  7. The plexiglass model test is carried out by two selective shape, the stress of each test operating loads was obtained in order to validate the correctness of the finite element modeling. in this paper, a regularity of shear lag effect of main sections in two kinds of box girder is given. as the foresight project of double - level - driveway continuous box girder, this research fully utilizes the space of box girder structure and flexural and torsional properties of high - depth box girder, which have innovative significance and applied foregroundin engineering

    對所選擇的結構形式進行縮尺有機玻璃模型試驗，得到實腹連續箱梁和空腹箱梁在各種試驗工況荷載下的應力，通過換算分析，驗證了本文所建立的有限元模型的準確性，由此得到兩種箱梁各主要斷面剪力滯效應的變化規律。
  8. The lifting - line and lifting - surface design method, the harmonic analysis method based on the panel method, new section design ways, the effective operating curves are integrated into a whole design system of the unsteady propeller, the design system is effective and reliable by the design example, the model test and the application to the full scale ship

    本文把升力線和升力面設計方法、基於面元法預報螺旋槳非定常性能的諧調分析方法，新剖面設計方法、有效運轉曲線計算方法組合為一套完整的非均勻流場中螺旋槳設計計算系統，經實例設計和模型試驗及實船的應用，該設計系統是可靠且有效的。
  9. Abstract : based or the basic operating condition of road stimulation, this paper discusses the intensifying test technology and brings up the basic method and principle of intensifying test, it also gives the busic translating function of equiualent mileage and the primary design of intensifying test

    文摘:該文從路面對車輛激勵的最基本工況研究出發，對強化試驗技術進行較深入的探討，提出了強化試驗的基本方法和思路及當量里程換算的基本公式，最後提出了開展車輛強化試驗研究的一些初步設想。
  10. The following conclusions are gained : ( 1 ) the located shear band prongs the ligament near the top crack tip and the structure may occur shear - mode fracture at the angle of 155 ? to crack when load is 87. 92mpa ; the mode of fracture of the flange joint structure is not possible to be void - mode ; ( 2 ) it is proved that loading and then unloading repeatedly can not increase the possibility of invalidation of the structure when the times of loading and unloading are not too more when load is operating pressure ; the structure is safe when the vessel is operating ; ( 3 ) in the fe model of the thesis, not considering the influence of water pressure test which is in the process of fabrication of vessel in fe results in larger deviation in analysi

    得出了以下結論：在8792mpa的載荷下筒體一封頭連接結構處的集中剪切帶貫穿韌帶，可能發生沿與原裂紋線成155 「角方向剪切型斷裂；筒體一封頭連接結構不可能發生韌窩型斷裂； （ 2 ）在工作壓力下進行次數不多的反復加、卸載，結構不會破壞，也不會喪失安定性：結構在工作狀態下是安全的； m在本文的彈塑性有限元模擬計算中，對于裂紋尖端進行力學分析時，不考慮壓力容器製造過程中水壓試驗的影響，將導致計算結果出現較大的偏差； （ 4 ）筒體完全屈服時的載荷為92石3mpa ，封頭完全屈服時載荷為86
  11. Standard test methods for operating characteristics of reverse osmosis and nanofiltration devices

    反滲透裝置和毫微滲透裝置操作特性的標準試驗方法
  12. Shutters and blinds - measurement of operating force - test methods

    百頁窗和屏風.操作力測定.試驗方法
  13. Methods of test for verification of stability of industrial trucks operating in special condition of stacking with mast tilted forward

    工業用帶前傾起重桿的碼垛貨車特殊條件下工作穩定性驗證試驗方法
  14. So we ca n ' t do oil filler test when the units in operating to test the reliability of overspeed protection system. firstly, this thesis presented the theory of overspeed protection system. and pointed out the reason why the emergency stop system is often fails in stroke

    本文首先分析了該型超速保護的動作原理，指出該型危急保安器注油試驗拒動的原因；首次利用流體力學的相關理論引入射流的概念，提出了改造方案，同時對該型危急保安器注油試驗裝置改造后飛環提前動作作出了理論分析。
  15. The main contents are as follows : based on analyzing several kinds of computing models of the boiler efficiency, performance test code for utility boiler is selected as original version and a new boiler efficiency online computing model is presented, which only needing input the coal industrial analytical components and the main operating monitored parameters of the boiler can online compute the boiler efficiencies

    本文的主要工作如下:在分析了幾種鍋爐效率計算模型的基礎上，選擇我國電站鍋爐性能試驗規程作為藍本，提出了一種新的鍋爐效率在線計算模型。該模型只需要輸入鍋爐燃用煤的工業分析成分和鍋爐主要運行監控參數就可以在線計算鍋爐效率。
  16. Semiconductor devices - mechanical and climatic test methods - high temperature operating life

    半導體器件.機械和氣候試驗方法.高溫操作壽命
  17. Semiconductor devices - mechanical and climatic test methods - part 23 : high temperature operating life

    半導體器件.機械和氣候試驗方法.第23部分:高溫操作壽命
  18. Semiconductor devices - mechanical and climatic test methods - part 23 : high temperature operating life iec 60749 - 23 : 2004 ; german version en 60749 - 23 : 2004

    半導體器件.機械和氣候試驗方法.第23部分:高溫操作壽
  19. This text has analysed load balancing method of existent especially lvs cluster system and recommended the net packet and netfilter ’ s frame structures in the linux operating system ; it has compared the cooperative - type - cluster with tradictional cluster in the net packets ’ queue ways and with active cluster in the load balancing dispatcher way, which has reflected the superiority of cooperation type cluster ; the three major parts of the cooperative - type - cluster have been designed and realized in this text, which includes sync packets ’ priority service for dmcs 、 “ priority and avoid sudden load unbalance ” dispatch way at the cooperation of nodal servers and director and active nodal server which ensure cluster normally running when cluster join or rduce node server ; the cooperative - type - cluster ’ s control frame controlled by homepage has been constructed ; the mulit - services cluster system has been realized ; this text has used the existing server pressure testing tools to test the cooperative - type - cluster and lvs cluster, then has comparaed and analysed the two

    本文分析了現有服務器集群特別是lvs集群系統的負載均衡方法，介紹了linux系統下的報文和netfilter的框架結構;將所提出的合作式集群與傳統集群在報文排隊方式上進行比較，與主動式集群在負載均衡調度方式上進行比較，體現了合作式集群的優越性;設計並實現了合作式集群體系結構的三大部分:針對分散式測控系統的加權服務、負載均衡器與節點服務器合作式「加權防突」負載調度、保證集群運行不受加減節點干擾的主動性真實服務器;構建了通過網頁界面控制合作式集群的控制框架;實現了一個可運行的合作式多服務集群系統，運用現有服務器壓力測試工具對合作式集群和lvs集群進行負載測試，並對測試結果進行比較分析，同時通過壓力測試實現加權服務。
  20. Pressure seal design without live load bonnet ( no spring washers ) : the gasket bolt tightness must be rechecked after operating test pressure and temperature has been achieved

    沒有動負載閥帽的壓力密封結構（沒有彈簧墊圈） ：在工作試驗壓力和溫度達到限制值時，必須重新檢查墊圈螺栓的緊固性。
分享友人
分享到 Line

分享到臉書