paper filler 中文意思是什麼

paper filler 解釋
紙團
  • paper : n 1 紙；裱墻紙。2 報紙，報。3 收據；債券；證券；票據；匯票；鈔票（＝paper money）。4 〈pl 〉身份...
  • filler : n. 1. 裝填者，斟酒人；注入器，漏斗；填充物。2. （雜志的）補白；電影補白短片。3. 雪茄煙心；（自來水筆的）吸墨管。4. 〈pl. 〉【化學】填料。5. （計算機的）進位填充數，填充位。
  1. Ptfe has many excellent properties such as : bonzer self - lubrication ^ low fricatiom chemistry stabilization and thermal stabilization, but its wear resistance is very low to improve the wear resistance of ptfe a lot of researches have been down by means of adding fillers to it, there are still less report on nano - inorganic filler filled ptfe composites to change properties. in this paper, experimental study was made to question above problem

    Ptfe具有優異的自潤滑、低摩擦、化學穩定性和熱穩定性，但耐磨性較差，因而人們在利用不同種類的填料對ptfe進行填充改性，提高耐磨性方面作了大量研究工作，但在使用納米無機填料填充改性ptfe方面研究很少，因此本課題主要探討這一方面的問題。
  2. By analyzing the effects of some factors on the settlement of backfill behind abutment, such as module of embankment filler, module of flexible approach slab, spacing, layer nlength, the paper proposes some important design parameters. as a result, the design is optimized

    通過分析路基填料類型、柔性搭板模量、間距、層數、長度等因素對沉降的影響，得出了一些有指導意義的設計參數，從而優化了設計。
  3. A fine clay used in ceramics and refractories and as a filler or coating for paper and textiles

    高嶺土，瓷土一種細黏土，在制陶器和耐火材料時使用，也可用作紙張和紡織片的漿料或塗層。
  4. In this paper the formula, the technics, the dosage of the filler and the macromolecule coupling agent are studied which influence the technics condition, mechanical properties, structure configuration. also x - ray large angle diffraction, scan electron microscope, dta etc are used to analysis and test the properties of the pp / talc composites. conclusions as follows : 1

    本文系統地研究了復合體系配方、工藝方法、填料及偶聯劑用量對復合體系工藝條件、力學性能及結構形態的影響，同時利用廣角x射線衍射、掃描電鏡、 dta等對復合體系的性能進行了測試與分析，主要研究內容及結論如下： 1滑石粉的加入，雖然使pp的熔化時間增加，但是混煉能耗下降，有利於pp的加工；偶聯劑的加入，使pp的熔化時間增加，能耗略有降低，總體而言，對加工無不利影響。
  5. Standard test methods of qualitative examination of mineral filler and mineral coating of paper

    紙中礦物填料和礦物塗料的定性標準試驗方法
  6. In this paper, using partly neutralized acrylic as monomer and kaolin as abio - filler, poly ( sodium acrylate ) / kaolin composite superabsorbent was prepared and its properties were studied

    摘要以部分中和的丙烯酸為單體，以高嶺土為無機填充料，通過反相懸浮聚合法合成出聚丙烯酸鈉高嶺土復合高吸水性樹脂。
  7. The wear on paper manufacturing equipment, particularly machine wires, caused by filler pigments and other components of the paper furnish, which develop as the sheet is formed

    中義紙張在造紙設備上成形後由填充物或設備（特別是網面上）所造成的磨損。
  8. Test method for qualitative examination of mineral filler and mineral coating of paper

    紙和紙板中無機填料和無機塗料的定性分析試驗方法
  9. Paper and board. qualitative analysis of mineral filler and mineral coating. chemical method

    紙和紙板中無機填料和無機塗料的定性分析化學法
  10. Paper and board. qualitative analysis of mineral filler and mineral coating. sem edax method

    紙和紙板中無機填料和無機塗料的定性分析電子顯微鏡x射線能譜法
  11. The recent development of silicone rubber inhibitor ' s mechanical, antiablation and bonding properties were introduced in this paper, which showed that the diameter of the filler in silicon rubber liner had main effect on its reinforcement

    摘要介紹了近年來硅橡膠包覆層的力學性能、耐燒蝕性能、粘接性能方面的研究情況以及取得的進展。
  12. Our production of magnesium hydroxide modified surface treatment products, high purity, particle size uniform dispersion of good, strong affinity, are halogen - free, smoke - free, no drops, non - toxic, the safety of flame retardants, rubber, plastics, rubber, engineering, electrical appliances, wires, cable, cable sheathing, thermoplastic materials, insulators, surge arresters, synthetic textiles, fire retardant paint, ink, paper, conveyors, mine ventilation duct, electronic appliances equipment, tarpaulins, tents, military, aerospace, shipbuilding, automobiles, steel products, such as the glass industry ideal fuel filler - type resistance

    我公司研發生產的改性表面處理氫氧化鎂系列產品，純度高、粒徑均勻、分散性好、親和力強，屬于無鹵、無煙、無滴、無毒性、安全性的阻燃劑，是橡膠、塑料、橡塑、工程塑料、電器、電線、電纜料、電纜護套、熱縮材料、絕緣子、避雷器、化纖紡織、防火塗料、油墨、造紙、運輸帶、煤礦風筒、電子電器器材、蓬布、帳篷、軍事、航空航天、造船、汽車、玻璃鋼製品等各行業理想的填料型阻燃料。
  13. In this paper, reversibly nonlinear transport in both dc response and ac response and relatively electrical conduction mechanism of polymer / conducting filler composites were reviewed, and the potential applications of polymer / conducting filler composites is outlooked

    文中闡述聚合物導電填料復合材料在直流電、交流電作用下的可逆非線性導電行為，以及其相關導電機理，並展望非線性導電特性的應用前景。
  14. Used for the manufacturing the raw material, manufacturing of the every kind of barium compound, rubber, paper, machine the slice the filler for with varnishing wall also used to the building to project the room to construct to have the to attach the x to shoot the lined

    用於製造各種鋇化合物的原料，製造顏料橡膠紙張剎機片和油漆的填料。也用作建築物放射室修築具有吸附x射線的墻壁。
  15. The dynamic mechanical behavior of the polymer composites, dynamic storage modulus ( g ' dynamic loss modulus ( g " ) and loss tangents ( tans ), have been studied in this paper. for different ceramic, the higher structure of the ceramic filler is, the high value of tan8 is

    研究了壓電陶瓷/聚合物復合體系的動態力學，發現壓電陶瓷在聚合物中的分散狀況和與聚合物間的相互作用，直接影響復合體系內耗（ tan6 ）和動態模量（ g ， ， g ? ）的大小。
  16. In this paper, mechanism and construction practice of construction and demolition waste as pile filler in mollisol ground strengthening are explained, and eight examples of engineering application introduced

    闡述了建築垃圾作復合載體夯擴樁填料加固軟士地基的機理和施工工藝，並列舉了8個工程應用實例，為建築垃圾找到一條合理的利用途徑。
  17. Abstract : in the present paper the progress was reviewed in the active filler metals with different temperatures for ceramic to metal brazing and related brazing technique of reducing joining - gap residual stress. it was recommended that the key developing field for our country should be the high temperature active filler with heat - and oxidation - resisting properties. the brazing techniques to reduce joining - gap residual stress and the principles to select transition layers for the joining gap were also introduced

    文摘:闡述了陶瓷/金屬釬焊用不同溫度的活性釬料及以降低焊縫殘余應力為中心的釬焊工藝進展；指出：在我國耐高溫、抗氧化性優良的高溫耐熱型活性釬料是重點發展方向；介紹了降低焊縫殘余應力的釬焊工藝和焊縫中間添加過渡層的選擇原則。
  18. In order of make integral use of construction and demolition wastes, in this paper, mechanism and construction practice for construction and demolition waste as pile filler in mollisol ground strengthening are described, and five examples of engineering application are listed

    為了促進國內建築垃圾的綜合利用，闡述了建築垃圾作建築渣土樁填料加固軟土地基的機理和施工工藝，並列舉了5個工程應用實例。
  19. Testing methods of filler and coatings clay for paper

    紙張填料和塗層的試驗方法
  20. In this paper, polypropylene was modified by composite technologies of nano - meter filling, crosslinking and crystal transformation, taking nano - meter calcium carbonate as the optimum filler

    摘要採用納米填充、交聯和轉晶的復合技術對聚丙烯進行了改性，優選了納米碳酸鈣為填料。
分享友人
分享到 Line

分享到臉書