peak light intensity 中文意思是什麼
peak light intensity
解釋
峰值光強度-
Under visible light excitation titanic acid and titanate sodium nanotubes showed a relatively intense emission, which red shifts with the increase of excitation wavelength. under humid conditions this photoluminescence of titanic acid nanotubes was not stable. the intensity decreased, and the emission peak was at 480nm, which cannot shift with the change of excitation wavelength
鈦酸和鈦酸鈉納米管在使用可見光激發時，都能產生光致發光現象，當使用不同波長的可見光激發鈦酸和鈦酸鈉納米管時，能夠得到不同強度的發光譜帶，且發光峰的位置隨著激發光的變化發生較大范圍的移動。 -
In the egg laying industry, the bodies of laying birds often suffer from deteriorated resistance to disease, short duration of the peak period of egg laying time and low rate of egg production due to the laying houses incomplete disinfection, poor sanitation, low - intensity light and lacking ventilation
在蛋禽飼養中，由於禽舍消毒不徹底，環境衛生較差，光線不足，通風不暢等原因，導致蛋禽機體抗病能力較差，產蛋高峰期持續時間較短，產蛋率降低。 -
Effect of spherical particles relative refractive index on the most peak value of scattered light field intensity
球形粒子相對折射率對散射光場強度最大峰值分佈的影響 -
With analyzed the relation between the particles number in the oil and the contamination of t he oil, the relation between oil contamination and the weakening of transmitted light intensity, the oil contamination is monitored based on the particles scattered the light. the minimum peak value of the oil at low - loss transmission area of quartz optical fiber can be selected to monitor the oil contamination
在對油液中磨損顆粒的含量與油液污染度的關系以及油液污染度與通過油液的光通量的減弱進行分析的基礎上，利用油液中懸浮顆粒對光線的散射的特性，對油液的污染度進行監測，選擇光線在石英光纖低損耗傳輸區域和油液對光線最小吸收峰進行測量。 -
Optical microcavity arouses great interest in condensed state physics. it can change characters of spontaneous emission, such as spectral full width at half - maximum, light intensity at peak and so on
光學微腔是目前凝聚態物理的研究熱點，它能夠改變自發發射的特性（譜線寬度、發光強度等） 。 -
This modulator works with the guided - wave reflectance peak, in which the light intensity is changed by the variation of the refractive index of poled polymer due to the electro - optic effects. device performances have been theoretically and experimentally investigated. we also successfully carried out experiments of video signal transmission using the proposed modulator
該調制器工作于金屬包覆波導的衰減全反射導模吸收峰，利用極化聚合物電光材料的折射率對導模吸收的影響來實現電光調制，並對器件的性能指標進行了實驗研究，同時利用製作的反射型電光調制器進行了視頻信號良好地傳輸實驗。 -
Theoretical analysis shows : compared with oled, moled with alq3 as light - emitting layer can emit different wavelength light by modulating length of cavity, spectral full width at half - maximum of moled changes from 100nm to 10nm ~ 20nm and the light intensity at peak is increased by about 20 times, and luminous efficiency can be enhanced
理論分析表明：通過調節腔長，用alq3作發光層的moled可以發出不同中心波長的光，譜線寬度由oled的約100nm變為10 ~ 20nm ，峰值光強提高20倍左右，總發光效率也有所提高。 -
( 2 ) several samples of different structure parameters are grown by low - pressure metal - organic chemical vapor deposition ( lp - mocvd ). it is found that pl peak intensity, full width at half maximum ( fwhm ) and light output intensity are greatly dependent on number of wells. ratio of well / barrier width nearly has no effect on pl peak intensity and fwhm, but has little relation to light output intensity
通過分析pls ，可以及時獲取材料生長和結構設計的數據，對質量控制有重要的指導意義； （ 2 ）對不同結構的gainp algainp多量子阱樣品進行了光致發光及出光強度的測量，發現mqw的周期數目n對pl峰強度、半峰寬和出光強度的影響最大；阱壘寬厚度比a對pl峰強度和半峰寬的影響較小，但對發光強度的影響較大。
分享友人