peak temperature 中文意思是什麼

peak temperature 解釋
峰溫度
  • peak : vi 1 瘦弱；消瘦，憔悴。2 減少，縮小 （out）。n 1 山峰，山頂；孤山。2 （胡須等的）尖兒；尖端。3 最...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. With the increasing salt concentration, milk - clotting activity became higher and higher, then reached its peak, and then decreased gradually ; in the early extraction, the speed was quick, the milk - clotting activity was increased obviously. after it amounted to the maximum, the activity became steadily lower steadily ; the increasing temperature in extracting could improve the extraction activity, but too high temperature could result in the denaturation and inactivation ; the greater the ratio of abomasums and butter and was, the quicker speed was when the enzymes was drawn out, and after extracting for twice, most of the enzymes in the abomasums could be drawn out

    隨著食鹽濃度增大，凝乳活性逐漸提高，當達到一定濃度后，凝乳活性又逐漸降低；在提取初期，提取速度較快，凝乳活性明顯提高，當提取達到最大值后，凝乳活性又逐漸下降；隨著提取溫度的升高，凝乳活性逐漸增大，但溫度過高時，會導致酶變性失活；隨著提取液與皺胃比例的增大，酶溶出速度加快，提取次數越多，皺胃中酶提取越充分，提取2次后，皺胃中絕大部分酶被提出。
  2. The peak of temperature is more high with metal powder, as a result of absorptivity is more high

    添加金屬粉末時，材料表面對激光的吸收率增強，同一測量點的峰值溫度升高。
  3. 08. 02 test method for gel time and peak exothermic temperature of reacting thermosetting resins

    活性熱固樹脂膠凝時間和最大放熱溫度測試方法
  4. Soil eoc1 under broad - leaved stand increased gradually with temperature and reached the maximun in july and september. a more flat curve of soil eoc1 was observed in masson pine stand with a peak in july

    從0一20厘米至60一80厘米，整個剖面上各層土壤水溶性有機碳占土壤總有機碳比率均是杉木林最高，闊葉林次之，馬尾松林最低。
  5. The hot spring of the yellow mountains of nationwide fame, was discovered and tapped more than a thousand years ago. gushing forth from the foot of purple cloud peak, it has never run dry during the most severe droughts nor overflooded during excessive rain. it is of a high - temperature carbonate type, with therapeutic effects for metabolic disorder, cardiovascular disease and malfunctions of digestive, nervous and motorial systems. its clear waters remain at 42c all the year round and can be used for drinking and bathing. baths and swimming pools have been built around the spring

    黃山擁有無數從過去留下來的石刻，這些石刻不僅僅是優美書法的樣本，也是黃山風景的形象描述： 「百態雲」 「奇美」 「刺天峰」 「巧奪天工」 「宏偉」 「壯麗山河」 「石獅咆哮」 「且聽吟」 「臥雲」 「迷人」 「永恆」 「醉石」等等。
  6. Temperature rises when reaching highest peak, reaching is oviposit period is gotten on for ; when dropping to the nadir, temperature drops is menses

    體溫上升及達到最高峰時就是排卵期快到了；體溫下降跌到最低點時就是月經期了！
  7. The welding technology of francis turbine runners is optimized from the view of subsection welding and local heating by numerical simulation. the result shows that welding residual tensile stress appears in the weld and its area nearby, and peak stress appears in the dangerous area of blades after practising quondam welding technology ; welding residual tensile peak stress in the dangerous area of blades can be decreased by welding both ends earlier and then welding middle section later during subsection welding, and decreasing effect on welding residual stress of the subsection welding is related to the weld length of blade outlets and welding direction of each subsection ; decreasing effect on residual stress of the local heating is direct proportional to heating time, heating temperature, heating area, and inversely proportional to cooling area, and welding residual tensile peak stress in the dangerous area is decreasing trend earlier, and then increasing trend later with heated location increased

    本文利用數值模擬手段對轉輪的焊接工藝從分段焊和局部加熱兩個方面進行了優化，結果表明:採用普通工藝焊接時，葉片焊后殘余拉應力出現在焊縫及其附近區域，並且在葉片出水邊的熔合線附近（危險區域）出現了峰值;在採用優化的分段焊時，先焊兩端后焊中間的方法可以降低葉片危險區域的焊接殘余拉應力峰值，降低效果與葉片出水邊焊段長度、焊縫各段的焊接方向有關;局部加熱法降低轉輪危險區域殘余應力的效果主要與加熱時間、加熱溫度以及加熱面積成正比，與冷卻面積成反比，並且危險區域的殘余應力隨加熱區域的增大呈先降低后升高的趨勢。
  8. The following results were found, i. e., the water ratio affects obviously the acoustic wave velocity of rock sample ; the wave velocity is higher in saturated rock samples than in unsaturated ones ; and it decreases gradually with the strain of samples during uniaxial compression ; and also with the lengthening holding time at 160 ; when heating the samples the acoustic wave velocity increases slightly in initial stage and comes to the peak value at 60, then decreases gradually with increasing temperature ; meantime, there is a certain temperature effect on rock samples size

    實驗發現含水率對波速影響比較大，飽和巖樣的聲波傳播速度高於不飽和巖樣的聲波傳播速度；人工預制裂紋對聲波傳播速度影響不大；單軸壓縮條件下，聲波傳播速度隨應變增加逐漸降低；在同一溫度（ 160 ）下，波速隨保溫時間的增加而逐漸降低；在對巖樣逐漸加熱情況下，初始加熱階段波速略有升高，當溫度達到60時，巖樣波速達到峰值，之後隨著溫度繼續升高其波速逐漸下降；波速隨溫度變化具有一定的尺寸效應。
  9. Rufifacies, peak 16 ( unknown ) and 25 ( 11 -, 13 -, 15 - methyl - hentriacontane ) for b. peregrina and peak 3 ( unknown ), 4 ( tricosene ) and 23 ( unknown ) for p. crassipalpis. additionally, the models were developed respectively to determine the larval age of different flies accurately. 2 temperature effects of time - associated characteristic in cuticular hydrocarbons of aldrichina grahami larva highly significant correlation were observed between the relative abundance of some larval cuticular hydrocarbons associated with gas chromatographic peaks and the chronological age of al

    2溫度對巨尾阿麗蠅幼蟲表皮碳氫化合物組成時間特徵的影響及日齡推斷模型的建立巨尾阿麗蠅幼蟲表皮碳氫化合物組份色譜峰，即p30 （二十五烯a ） 、 p33 （正二十五烷） 、 p48 （二十七烯a ） 、 p49 （二十七烯b ）和p79 （正三十一烷）含量與幼蟲日齡呈極顯著相關，且在不同恆溫（ 16 、 20 、 24和28 ）下的變化趨勢基本一致。
  10. The study shows that the firing rate of a rapid - fire gun is an important factor in deciding the peak temperature of bore

    研究表明： （ 1 ）速射火炮的射頻是決定身管內膛尖峰溫度的極為重要的因素。
  11. A new calculation method for optimizing diesel engine performance, called nonlinear regression - mess method, is put forward. in this paper, 25 groups of simulated values are calculated from the diesel engine working model, specific fuel consumption, peak pressure, rate of pressure rise, nox and peak temperature are fitted into explicit function about compression ratio and fuel injection advance angle

    本文利用柴油機工作過程模型，得出25組模擬計算數據，利用非線性回歸將油耗、最大爆發壓力、壓力升高率、 no _ x濃度及最高燃燒溫度擬合成壓縮比和噴油提前角的顯函數，並用網格法進行優化，用c語言編制了優化計算程序，得出最佳的壓縮比和噴油提前角，使其優化匹配。
  12. Furthermore, for a sample there is only one temperature. the peak temperature of tp2 peak is ranked from small to great as follows : sample cooled in

    幾2峰峰的位置溫度大小依次為:空冷試樣
  13. The results shows that the addition of nucleating agents increased the onset temperature and peak temperature and improved crystallization rate of pp

    結果表明，兩種成核劑的加入均可提高聚丙烯的結晶起始溫度和結晶峰溫度，並加快結晶速度。
  14. Research points out that the three key factors, which determine the nox emissions, are maximum peak temperature, rich oxygen concentration and the duration in which combustion products stay at high temperature zone

    船舶柴油機的氮氧化物主要是山于大氣中的氮在柴油機燃燒過程中被氧化而成。研究表明高溫、富氧以及燃燒產物在高溫區的停留時間是決定氮氧化物排放量的三個決定因素。
  15. The peak of temperature of thinner base metal is more high than thick base metal, the time of attaining peak temperature is shorter than thick base metal

    同一測量點薄板的峰值溫度比厚板高，達到峰值溫度的時間比厚板短。
  16. But for the furnace cooling samples, all samples have another damping peak about at 3 00 ( called tp2 peak ). the peak is not of relaxation model, the peak temperature does not vary with frequencies

    除爐冷試樣外，其餘各熱處理態試樣均在300左右，有一內耗峰幾2峰，此內耗峰無馳豫特性。頻率變化，內耗峰的位置不變，對同一熱處理態試樣內耗峰位置不變。
  17. In the five key factors of solder ball alloy, solder paste alloy, peak temperature, the time above liquidus and soldering environment, the fore four factors are more important than soldering environment to the solder joints reliability

    在焊球合金、焊料合金、峰值溫度、液相線以上時間和焊接環境五個關鍵因素中，前四項對焊點可靠性比較重要，焊接環境對焊點可靠性的影響不很顯著。
  18. The outer surface temperature of barrel can be efficiently cooled down by adopting the outside cooling fluid method in a rapid - fire gun, but its effect on reducing barrel inner peak temperature and prolonging the life is limited

    （ 2 ）對于速射火炮，外液冷方式可以有效降低身管外壁的溫度，但對于身管內膛溫度的降低和壽命的提高作用有限。
  19. Efd recommends a peak temperature of 20 - 400c above the liquidus temperature of the alloy in use

    Efd建議峰值溫度為合金熔點溫度再加上20 - 400c 。
  20. Both initial curing temperature and final temperature of two systems moved to the peak temperature of the systems with addition of org - mmt, and the peak temperatures were kept constant

    加入有機蒙脫土后，兩個固化體系的起始固化溫度和終止固化溫度均明顯向中間靠攏，而峰頂固化溫度基本維持不變。
分享友人
分享到 Line

分享到臉書