piezoelectric material 中文意思是什麼

piezoelectric material 解釋
壓電材料
  • piezoelectric : adj. 【物理學】壓電的。
  • material : adj 1 物質的（opp spiritual）。2 身體上的，肉體上的；物慾的，追求實利的；卑俗的。3 有形的，實體的...
  1. A lot of engineering applications are carried out using our proposed method in this paper, such as thermal deformation measurement of a car lamp, analysis of the super low frequency harmonic vibration of a piezoelectric ceramic, dynamic mechanical behavior analysis of the ballistite material and so on

    在前面所提出的理論基礎之上，本文對該方法在實際工程中的應用做出了大量的工作。本文利用時間序列法實現了汽車前燈配光鏡的熱變形檢測、壓電陶瓷片的超低頻振動分析以及火箭固體燃料的動態力學特性研究。
  2. The characteristics of piezoelectric material, the design method of bionic thermostable structure and theirs applications are systematically and profoundly studied on both theory and fundamental technique

    從理論和基礎技術兩方面入手，對壓電材料的特性、仿生熱穩定構件的設計方法及其應用進行深入系統的研究。
  3. The ultrasonic motor is a kind of direct driver which is uses the converse piezoelectric effect of the piezoelectricity ceramics, by using transformation and the coupling of each kind of expansion and contraction vibration pattern enlarging the material microscopic distortion by resonate effect and transforming it to macroscopic movement of the rotor or the slide by the friction coupling

    超聲波馬達是一種利用壓電陶瓷的逆壓電效應，通過各種伸縮振動模式的轉換與耦合，將材料的微觀變形通過共振放大和摩擦耦合轉換成轉子或者滑塊宏觀運動的直接驅動器。
  4. In this paper, at the cut - in spot of beam active vibration control and use the pzt material as the drive component, the main research works can be summarized as follows : 1 ) using the finite element theory, a general finite element formulation of piezoelectric media is derived, the direct and converse piezoelectric effects are considered in the formulation

    本文從梁的振動主動控制研究為切入點，利用了pzt材料作為驅動元件，作了如下幾個方面的研究： 1 ）利用有限元理論，考慮壓電材料的正、逆壓電效應的影響，導出了機電耦合壓電元件的有限元方程。
  5. 0 - 3 pzt / pvdf piezoelectric composite is a kind of piezoelectric material, which integrates with merits of pzt and pvdf respectively and counteracts deficiencies of them. so, it is used widely in every fields of modem social life

    0 ? 3型pzt / pvdf壓電復合材料是一種綜合了鋯鈦酸鉛（ pzt ）和聚偏二氟乙烯（ pvdf ）的自身優點，彌補它們自身缺陷的一類壓電材料，因而廣泛地應用於現代社會生活中。
  6. The piezoelectric - pump driven by piezoelectric - stack is a newly development trend, it can accommodate frequency and pressure in a large scale and control the output flux in precision. this pump will widely apply to transfusion, feed oil and clean the equipment in industrial automation, and scientific research, lab, chemical preparation and cooling of cpu etc. driven theory of piezoelectric - stack because the piezoelectric - stack is the core part of the pump that we designed, we should pay more attention to driven principle of the piezo - stack so that we can using it correctly. this paper introduces piezoelectric material and interrelated parameter, output characteristic and driven principle and driving type of piezoelectric - stack

    壓電疊堆泵是一種以壓電疊堆作為驅動元件的微型泵，它是隨著mems的發展而發展起來的。本文提出利用壓電疊堆與柔性鉸鏈放大機構配合來驅動微型泵的橫隔膜，以達到泵送流體的目的。本文在查閱國內外大量文獻的基礎上，總結了國內外壓電疊堆泵的研究現狀，分析了壓電疊堆的動靜態特性，提出一種以壓電疊堆作為驅動源的壓電流體泵的構想。
  7. The procedure of the test is as follows : first, the piezoelectric stack has been examined to test the performance parameters of the piezoelectric material ; second, the 2 - x actuator has been functioned with different static voltage to test its capability ; last, function the 2 - x actuator with voltage with different frequencies to test its dynamic properties. all the output of the actuator has been measured by the laser vibration measurement

    首先對壓電堆進行試驗，驗證壓電材料的性能參數;再對推挽式雙x驅動器施加不同的靜電壓驅動它，驗證作動器的驅動能力，最後對推挽式雙x驅動器輸入不同頻率的電壓驅動，測量該驅動機構的動態特性，試驗均採用激光測試儀測量推挽式雙x驅動器的輸出特性。
  8. The design testing piezoelectric material surface acoustic during the experiment process in the paper has several merits : convenience, efficiency, no loss, fastness. and they can be realized. the design applies material piezoelectric response and anti - piezoelectric response to stimulus and receive saw, and apply the method of testing resonator frequency to calculate saw tested speed, simultaneously contrast the actual test result about different material to typical value in the paper

    在本論文的研究實驗過程中，給出了一種方便、有效、無損、快捷的檢測壓電材料表面聲速的設計與實現，該設計中運用材料的壓電效應和逆壓電效應激勵和接收saw ，並運用檢測諧振頻率的方法計算測量saw速度，同時給出了對不同材料的實際測試結果以及與資料典型值的對比。
  9. The problem this paper researches is vibration controlling with piezoelectric material as driver and sensor part

    本課題所研究的問題就是以壓電材料作為傳感、驅動元件的懸臂梁的主振動控制。
  10. The proposed control system includes the attitude controller acting on the rigid hub, designed by using pulse - width pulse - frequency ( pwpf ) modulation integrated with command shaping technique based on csvs method, and the piezoelectric material elements as sensors / actuators bonded on the surface of the beam appendages, designed by the optimal positive position feedback ( oppf ) control technique, in which the selection of ppf gains is determined via introducing a cost function to be minimized by feedback gains which are subject to the stability criterion at the

    設計的控制器僅利用輸出信息，從而避免設計撓性模態狀態觀測器以及引入狀態觀測器誤差;在此基礎上，採用分力合成方法設計命令成形控制器來抑制撓性附件的振動，設計的優化命令成形控制信號在理論上可以對系統的各階撓性模態完全抑制。但考慮到模型不確定性和外部擾動，在內迴路又設計了最優正位置反饋（ oppf ）補償器以增加撓性結構的阻尼，使撓性結構的振動能夠很快衰減。
  11. This article main content includes : 1 ) the principle knowledge of piezoelectric material and its extensive using prospect ; 2 ) using the software of the finite element analysis, ansys, we make an analysys of the modal analysis for the experimental subject, cantilever beam ; 3 ) we give the circuit graph using in the control by the 89c51 single chip computer, the simulink result and the final result of controlling vibration

    本文的主要內容包括： 1 ）簡單介紹了壓電材料的基本知識及其廣闊的應用前景； 2 ）使用了有限元分析軟體ansys對實驗品- -懸臂梁進行了模態分析； 3 ）給出了用89c51單片機進行控制時所用的電路圖以及模擬結果和抑制振動的最終控制結果。
  12. When the radian of rigid line reaches extensive magnitude, the presence of interfacial rigid line inclusion can change not only attraction force on dislocation arisen by soft inhomogeneity into repulsion force, but also the interaction effects between screw dislocation and soft matrix. soft inhomogeneity can repel screw dislocation in piezoelectric material due to their intrinsic electromechanical coupling behavior

    當界面裂紋達到一定弧度時，可以將硬夾雜對位錯的排斥作用改變為吸引；當剛性線夾雜達到一定弧度時，不但可以將軟夾雜對位錯的吸引改變為排斥，也可以改變軟基體對位錯的作用性質。
  13. Also, for material showing pyroelectric properties, electric charges will appear under the effect of temperature. according to these proprieties, a piezoelectric element is an electromechanical transducer ( energy converter ). at present, most of the piezoelectric material is film or ceramic cylinder

    聚偏氟乙烯（ pvdf ）作為一種壓電材料，具有很強的壓電效應和熱釋電效應，也是目前在壓電高分子材料中研究的較為系統、應用最廣泛的高聚物。
  14. Piezoelectric material for saw devices is the decision factor affecting saw device characteristic

    壓電材料是saw器件基本材料，該基片材料是影響saw器件性能的一個決定性因素。
  15. In the beginning of this thesis, types and characteristics of intelligent material elements have been introduced. and the basic equations of piezoelectric material have been given. then according to hamilton principle, both the static and dynamic finite element equations for the intelligent structure are formulated with isoparametric element of bending plate or bending beam

    在本論文的開始，簡要介紹了智能材料元件的種類和性質，並給出了壓電材料的本構方程，然後根據hamilton原理，採用任意等參四邊形板梁彎曲單元，導出了智能梁的靜態、動態有限元方程；對于復雜幾何形狀或邊界條件的一般結構，根據三維有限元模型，導出三維動態有限元方程。
  16. Solutions of an antiplane edge - crack in a rectangular piezoelectric material

    含不可滲透邊裂紋壓電材料反平面問題的解
  17. The material characteristic and principle of piezoelectric material ( pzt ) and macro - fiber composite ( mfc ) is analyzed. cada - x structural dynamics analytic software is used to carry on the experimental modeling and mode analysis of the vertical tail. consequently, the disposal scheme of sensor and actuator is confirmed

    本文的主要研究內容為:一、分析了壓電陶瓷和壓電纖維復合材料的特性及工作原理，採用比利時lms公司的cada - x結構動力學分析軟體對尾翼模型進行實驗建模與模態分析，根據模態實驗結果，確定了傳感/驅動元件的布置方案。
  18. When piezoelectric material is put on outside force, it will cause the translocation of positive and negative electricity inside piezoelectric material. then piezoelectric material will generate polarization and shape tied electricity on the surface of the piezoelectric material that is proportional to the outside force

    對壓電材料施加外力時，會引起壓電材料內部的正、負電荷發生位移，並產生極化，從而在壓電材料的表面形成與外力成比例的束縛電荷，稱為正壓電效應。
  19. Accordingly, selecting piezoelectric material to control vibration is a good method

    因此選用壓電材料來控制振動也是一種很好的辦法。
  20. Currently, it is a hotspot to use piezoelectric material as drivers and sensors in intelligent material

    使用壓電材料作為傳感器和驅動器是當前智能材料的一個熱點。
分享友人
分享到 Line

分享到臉書