rate of water injection 中文意思是什麼
rate of water injection
解釋
注水速率-
Based on the development feature analysis, this paper studies thoroughly the reservoir flood feature and remaining oil distribution through the microstructure, sendimentary phase, reservoir heterogeneity and well control, and proposes the comprehensive adjustment based on the injection and development well net structure and improvement the result of the research is obvious with the production degression rate from 9. 14 % of 1997 to present - 1. 46 %, and water rate from original 0. 33 % to present 0. 16 %. in summary, the research idea, method and new achievement of the thesis provide a scientific geological basis for the oilfield development improvement
在對本區開發歷程和開采特徵分析的基礎上，從微構造、沉積微相、儲層非均質性、井網控制等方面深入地分析了油藏水淹特徵及剩餘油分佈規律，提出了以完善注采井網、調整注采結構為目的的綜合調整措施，已見到了明顯的效果：油田遞減由1997年的9 . 14降至目前的- 1 . 46 ，綜合含水上升率由原來的0 . 33降至目前的0 . 16 。 -
Based on physical simulation and numerical simulation, the conversion of hot water slug flooding with nitrogen foam is presented and some injection indices are optimized, including foam concentration, gas - liquid ratio, injection rate, temperature of water, slug length. from reservoir research and oilfield development, studying disadvantageous factors, the paper will have guilding value for heavy oil reservoir development of leng 43 block
對熱水+氮氣泡沫段塞驅的關鍵技術指標，包括泡沫劑濃度、氣液比、注入速度、注水溫度和段塞長度等重要參數進行了優選，提出了注水速度80 100t d 、氣液比1 ： 1 、注水溫度95 100 、溶劑濃度0 . 5的推薦方案。 -
Measurement of water flow rate in closed conduits. tracer methods. part iii : constant rate injection method using radioactive tracers
密封管道中水流速的測定.示蹤法.第3部分：放射性示蹤器恆流速噴射法 -
Measurement of water flow in closed conduits. tracer methods part ii : constant rate injection method using non - radioactive tracers
密封管道中水流量的測定.示蹤法.第2部分：使用非放射性示蹤物的恆速率噴射法 -
The proper injection allocation rate of well can effectively relieve the contradictions of plane, interlayer and inherent layers, and improve the effects of oilfield exploitation by waterflood or water drive process
合理的單井配置注量，可以有效緩解平面矛盾、層間矛盾、層內矛盾和提高水驅油田開發效果、水驅採收率。 -
After synthetically analyses and researches of the existing methods for injection allocation rate, this article takes the group of water - injecting wells in waterflood oilfield as the research unit, the multiple regression method to decide the injection allocation rate is applied, by which and its regression coefficient and partial correlation coefficient, the multivariate regression models of model and model are developed
在對目前存在的配注方法的綜合分析和研究之後，提出以水驅油田注水井井組為研究單元，採用多無回歸方法來確定注水井井組配注量，並基於多元回歸方法的回歸系數和偏相關系數，分別建立了多元回歸模型、 。 -
Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced
通過分析溫度、氮氣對原油粘度的影響，對比不同注氮量、不同注入方式等對蒸汽驅油效果的影響，弄清了氮氣輔助蒸汽增產的機理主要表現在：氮氣輔助后增加攜熱能力，降低殘余油飽和度，氮氣的壓縮膨脹作用分散和改變了原油流動形態，增強了原油流動性；擴大蒸汽的波及體積，補充地層能量，提高回採水率，強化蒸汽蒸餾效應。 -
A method for determining the reasonable rate of water - injection stations in a large - scale system
大型注水系統注水站合理排量的確定方法
分享友人