residual force 中文意思是什麼

residual force 解釋
殘餘力
  • residual : adj 殘余的,剩下的;殘留的;殘渣的;未加說明的;【數學】殘數的,留數的。n 1 殘余;【數學】殘數,...
  • force : n 1 力,勢。2 體力,氣力,精力,魄力。3 暴力,壓力;兵力,武力。4 〈pl 〉 部隊,軍隊,兵力。5 勢...
  1. Residual electromotive force of potentiometer

    電位差計殘余電動勢
  2. Vibrating samples magnetometer ( vsm ) testing implied that yig were of ferrimagnetism, and cerium substitution had effects on saturation magnetization ( ms ), residual magnetization ( mr ) and coercive force ( hc )

    Vsm測試結果表明yig屬于亞鐵磁性物質, ce離子的摻雜對飽和磁化強度( ms ) 、剩餘磁化強度( mr ) 、矯頑力( hc )都有一定的影響。
  3. The real baptism is that when the residual force within us called as kundalini, when it rises and pierces the fontanelle bone area, which is a soft bone you had as a child, that time is the real baptism and this baptism was to be achieved

    真正的洗禮是指我們內在的能量,即稱為靈量kundalini昆達里尼的那個能量得到提升,穿越頭蓋骨,即那個在我們年幼時頭頂軟骨的部份,這才是真正的洗禮,這才是要發生在人類身上的。
  4. Conversion formula between the strain mode and displacement mode is induced for the cantilever beam. present residual force method is improved and the new method is better than the old one for the engineering practice

    推導出位移模態和應變模態的換算公式,改進了現有的殘餘力向量法,使之在工程實際應用中有更現實的意義。
  5. The surface morphologies of thin films were observed by using scan electron microscope ( sem ) and atomic force microscope ( afm ). based on grazing incidence x - ray diffraction ( gixrd ) equipment, we find that residual stress exist in magnetron sputtering plct film, in addition, the ferroelectric properties of plct thin films were measured by radiant premier lc type multifunctional ferroelectric properties test system

    利用廣角x射線衍射技術對不同濺射工藝下plct薄膜的相結構進行了研究;採用掃描電子顯微鏡( sem )和原子力顯微鏡( afm )分別觀察了薄膜的表面形貌;利用掠入射x射線衍射( gixrd )測量了薄膜的殘余應力。
  6. Analyzing the effects towards residual stress from different rolling loadcase, the value of cold rolling residual stress caused by different compress was gotten ; analyzing parameters stretching toward different rolling loadcase board, the effect of the residual stress elimination influenced by stretching force and stretching deformation was figured out

    通過分析不同軋制工況對殘餘應力分佈的影響,得到不同壓縮量對軋制殘餘應力的影響; ?對不同軋制工況后的板材進行參數拉伸,得到拉伸力大小、拉伸變形量大小對殘餘應力消除效果的影響值。
  7. In this paper the author describes a way of determining the residual pre - tightening force after adding elastic elements to the connecting bolt at the flange on ball mill ' s shell and therefore a formula is induced

    闡迷了球磨機筒體法蘭聯接螺栓增加彈性元件后其剩餘預緊力的確定方法,並導出了相應的計算公式。
  8. The phase structure of different cu - fe thin films were studied by using grazing incidence x - ray analysis ( gixa ). the texture and residual stress of different cu - fe thin films were measured by scan of x - ray diffraction ( xrd ) and 2 scan with different. the thicknesses of different thin films were characterized by means of small angle x - ray scattering ( saxs ) technique. by using atomic force microscope ( afm ) measured surface roughness of thin films. the component of different thin film was characterized by energy disperse spectrum ( eds ) and x - ray fluorescence ( xrf ). the magnetic properties of cu - fe thin films were measured by means of vibrating sample magnetometer ( vsm ). in addition, the giant magnetoresistance ( gmr ) effects of different films were also measured. the original resistance of the film fabricated by a direction - current magnetron sputtering system is directly affected by bias voltage

    利用掠入射x射線分析( gixa )技術對不同cu - fe薄膜的相結構進行了研究;利用xrd掃描及不同角度的2掃描對薄膜進行了結晶織構及殘余應力分析;運用小角x射線散射( saxs )技術測量了薄膜的厚度;採用原子力顯微鏡( afm )觀察了薄膜的表面形貌;運用能量損失譜( eds )及x射線熒光光譜( xrf )對薄膜進行了成分標定;使用振動樣品磁強計測量了不同cu - fe過飽和固溶體薄膜的磁性能;最後利用自製的磁阻性能測試設備測量了真空磁場熱處理前後不同薄膜的巨磁阻值。
  9. Coarse grained soil is composed of sand and gravel, stone residual, blasted stones etc., which has a characters of less cohesive force among grains and strong ability of water penetration. it is a kind of soil of loose grain structure with better utilization properties in the engineering

    粗粒土是指砂礫石、砂卵石、石渣、爆破開採的石料等粗顆粒土石混合料,具有粗顆粒間粘結力小、透水性強的性質,是一種鬆散的顆粒狀結構,具有良好的工程使用性能。
  10. The mechanism of reinforcing steel bar under the press or pull is researched and the characteristics under the pull - press cyclic loading is studied in composite foundation. it shows that the stress concentrating on the reinforcing steel bar and the increasing stress can be seen with the increasing of cyclic times. residual strain always exists after unloading without considering the size of pullout force and increases slowly with the cyclic times

    探討了復合地基中抗拔鋼筋的受壓受拉機理及在拉壓循環荷載作用下的性狀,研究發現,隨拉壓循環次數的增加,應力向鋼筋集中,鋼筋承受的壓力隨著增大;無論上拔力大小,卸載后都有殘余變形,並隨著拉拔循環次數的增加而緩緩增加;抗拔碎石樁破壞性狀明顯,可明確的得到抗拔碎石樁的破壞荷載。
  11. The effect of different sizes of sections, modes and values of residual stresses are studied. through the analysis, the conclusion is arrived at that the universal slenderness ratio should be used to better correlate the stability of box section beams with the member length instead of the out - of - plane slenderness, and the stability coefficient is taken to be 1. 0 for practical used box girder. then, the elastic critical loads of box section beam - columns are obtained based on the gjelsvik theory, and the relationship between axis force p and moment m is given

    最後,運用ansys通用有限元程序的beam189單元,引入初彎曲和殘余應力的影響,用考慮幾何和材料雙重非線性的有限元求解格式求得箱形柱在不同軸力和彎矩比例作用下的彈塑性極限承載力,通過對十幾個不同截面尺寸構件在不同長細比下的承載力計算,發現在軸力p遠大於彎矩m時,構件將是平面外失穩控制,而當軸力p遠小於彎矩m時,構件則以平面內失穩為主。
  12. By the way of evaluating the stability and calculating the residual slip force of lin jia ya slide iii, this paper presents three comprehensive treatment projects on the ground of analyzing the cause and contrasts them through three several aspects of construction, treatment effect and engineering cost

    本文通過對林家崖號滑坡的穩定性分析、評價和剩餘下滑力的計算,在綜合分析滑坡成因的基礎上,提出三種可行的綜合治理方案從施工、治理效果和工程費用等幾方面進行多方案對比優化。
  13. In this article, a program about the weighted residual method is compiled by using matlab mathematics software to solve this problem. the program has broad applicability, which can analyze the displacement fields and the internal force fields of moderate - thick plates on two - parameter elastic foundation with arbitrary boundary and arbitrary loading con - ditions ( contains uniform line load, concentrated load or combined loads on arbitrary position of plates )

    計算中本文應用matlab數學軟體編制出求解該問題的加權殘值演算法程序,程序適用性較強,可以求解雙參數彈性地基上任意邊界條件組合下任意豎向荷載(包括板面上任意位置的均布荷載、集中荷載以及兩者的組合)作用下的中厚板內任意點的位移場、內力場。
  14. Based on the assumption of periodic rubbing force in rotor system, the rubbing forces onto each node of rotor system are estimated by modal expansion technique and the sub - harmonic decomposition of residual matrix between faulty and faulty - free vibration signals of rotor system through fft ( fast fourier transformation )

    基於轉子系統碰摩力的周期性假設,利用模態擴展方法,對故障和健康轉子系統振動信號的殘差矩陣進行傅立葉級數的分頻諧波近似,估算得到轉子軸承各節點的碰摩力。
  15. According to study on magnetic parameters of the bounded ndfeb magnets : coercive force ( hc ), residual magnetism intensity ( br ), ( bh ) max. the residual magnetism intensity ( br ) and ( bh ) max of the bounded ndfeb magnets have not been evidently changed between that of cladded and non - cladded ndfeb magnetic powders

    能夠改善ndfeb磁體的導電性能的目的。浙江工業大學碩士學位論文包覆前後的粘接ndfeb磁體的矯頑力有不同程度地降低;而最大磁能積和剩餘磁感應強度卻變化不大。
  16. Being the base of great city, they provide all kinds of industrial elements. on the other hand, they connect the central districts and outskirts towns of chengdu. with good basic conditions, the towns are the very effience areas for the central districts " expanding and they may become the hearts of the rural areas, which will absorb the residual labour force

    一方面,它是大都市發展的基地,為大都市發展提供各類生產要素支撐,接受中心城區的產業擴散;另一方面,它是成都市域連接中心城區與遠郊鄉鎮的經濟紐帶,由於其基礎條件較好、優勢明顯,所以是中心城區擴展的有效區域,對遠郊區域發展仍然起集聚、擴散作用,承擔農村地區中心功能,為農村服務,接納農村剩餘勞動力。
  17. The most residual slide force of unit width is 9020kn / m ( iii - iii section ) when stability coefficient is 1. 15

    四道溝滑坡滿足設計穩定系數1 . 15時,最大單寬剩餘下滑力9020kn m ( -剖面) 。
分享友人