residual velocity 中文意思是什麼
residual velocity
解釋
剩餘速度-
The clues and techniques to improve the resolution of data processing are 1 ) removing the affection of near surface factors on data acquisition, including static correction and noise eliminating technique etc, 2 ) broadening the frequency band of pre - stack seismic data, including amplitude compensation and pre - stack deconvolution etc, 3 ) improving s / n ratio of high frequency and weak reflection signals through multiple coverage with high precision velocity analysis, residual static correction and high - order nmo, raising " dead line of high frequency reflection ", and 4 ) identifying post stack effective reflection frequency band, enhancing dominant frequency and so on
主要包括：消除近地表因素對資料採集的影響，包括靜校正和噪音壓制技術等；疊前拓寬地震資料領帶，包括振幅補償和疊前反褶積技術等；藉助高精度速度分析、剩餘靜校正和高次項nmo技術，通過多次覆蓋疊加，消除資料中隨機噪聲干擾、提高資料信噪比，尤其是高頻端反射信息的信噪比，改善高頻反射和弱反射信號信噪比，提高「高頻反射死亡線」 ；疊後有限反射頗帶識別、抬高優勢頻率等。 -
In view of characteristics of seismic data of gobi - sand dune areas, this paper, through various data - processing means such as quality control, high - pass filltering, dip angle filltering, field static correction, surface consistency deconvolution, precise velocity analysis, denoising before stack, multiple iterative operation of residual static correction, denoising after stack and modification after shift, has raised the data quality of seismic profiles in low signal - to - noise ratio areas and managed to form the seismic data - processing technique for such complex areas as gobi, foreland and dune
摘要針對戈壁、沙丘地區地震資料的特點，通過對原始資料進行質量控制、高通濾波、傾角濾波、野外靜校正、地表一致性反褶積、精細速度分析、疊前去噪、剩餘靜校正多次迭代、疊後去噪和偏後修飾等處理，提高了低信噪比地區地震剖面的資料質量，摸索出了一套戈壁、山前、沙丘等復雜地區地震資料處理技術。 -
At the same time, calculate corrosion velocity by actual thickness data and residual lifetime
同時，根據實測的省煤器管壁數據得到腐蝕速率，計算省煤器管的剩餘壽命。 -
The tidal current characteristics, velocity ' s elliptic distribution of each layer, distribution of mean velocity of tidal current and characteristics of the residual current at the station are analyzed
分析了該站位的潮流特徵、各層潮流流速的橢圓分佈、潮平均流速分佈及其餘流特徵。 -
Based on the simple understanding of normal seismic processing, this paper has carried out deep research on the problems of deep prospecting in seismic data processing, such as s / n ( signal to noise ratio ), velocity analysis and residual nmo of unsymmetrical hyperbola, stacking and imaging of complex rays and migration arc. until now tens of accomplishments have been achieved
在簡單了解地震資料常規處理的基礎上，本文針對當前深層資料的問題，緊緊圍繞著深層地震數據處理技術研究需要解決的重點問題，即信噪比問題、非對稱雙曲線的速度分析與剩餘動校正時差問題、復雜射線的迭加及偏移成像問題和偏移畫弧問題等，進行了深入的研究工作，目前已完成十多個成果。 -
Abstract : the relationships between the residual strength of the tunnellining damage due to high temperature and ultrasonic velocity were studied on the basis of the experiments on the concrete and members of the tunnel the tunnel damaged by fire were discussed
文摘:在對隧道襯砌混凝土和構件進行實際燒損試驗基礎上，探討了襯砌在高溫作用后殘余強度與超聲波速之間的關系，以及超聲檢測技術用於測試隧道火災損傷的適用性和和可靠性。 -
This paper, as for the contradiction happened in design, construction, acceptance check when the quality of the project was needed and the building speed is different in every section of the road, the residual settlement a h is needed to be less than the standard value, launches the project - - - - - - the analysis on the settling velocity o f high earth fill sub - grade and the study of stability
本文主要是針對近幾年來在設計、施工、竣工驗收在工程質量評定中所出現的矛盾? ?一條公路少至幾公里至幾十公里，甚至上百公里，由於各個標段完工速度不一致，其剩餘沉降值（即竣工驗收時） h要求小於「評定標準」 （即垂直變形3cm ） ；而進行的《高填方路基沉降速度分析與穩定性研究》課題研究。 -
In this paper, we present a new migration velocity analysis method - synthetic source record interactive residual migration velocity analysis method based on controlled illumination
摘要提出了一種新的偏移速度分析方法基於控制照明的合成震源記錄交互剩餘偏移速度分析方法。 -
The melt velocity far from the gate was found to be higher than that near the gate during the compression stage contrary to that of conventional injection molding ( cim ) resulting in different part residual stress and melt temperature distribution
在壓縮階段離膠口較遠的熔膠速度會比離膠口較近的熔膠速度來的快，這種現象與傳統射出成型是相反的，也因此導致殘餘應力與熔膠溫度的分佈與傳統不同。 -
With respect to the gas status recovery in the spark gap, the conduction and convection of hot gas are simulated numerically. the decay of residual charge particles is analyzed and simulated also. the main factors affecting the insulation recovery velocity of gas are analyzed and discussed
對電極間隙內氣體狀態的恢復，數值模擬了炙熱氣體的傳導和對流過程，分階段的討論和模擬了帶電粒子的消逝過程，分析了影響電極間隙內氣體狀態恢復的主要因素。 -
The constitutive equation is a euler form to a reference which has initial stresses ( or residual stresses ), the constitutive equation also refers to a motion of constant velocity along a straight line
該本構方程是參考具有初始應力場（或殘余應力場）的直線勻速運動狀態而建立的空間描寫形式。
分享友人