sample resistance 中文意思是什麼

sample resistance 解釋
取樣電阻
  • sample : n 1 樣品，貨樣。2 標本；榜樣，實例。3 【統計】典型取樣，抽檢查。4 【電訊】信號瞬時值。5 【冶金】 ...
  • resistance : n. 1. 抵抗，反抗，抗拒，抵禦；敵對，抵抗力，反抗力，阻力，【生物學】抗病性。2. 【電學】電阻；阻抗；電阻器。
  1. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。
  2. The resistance of sample l # ( 44nm ) and sample 2 # ( 50nm ) rises rapidly from 25k and 45k respectively, and an inflexion appears at the temperature in the resistance - temperature curves. the same inflexion appears at 75k in the resistance - temperature curves

    晶粒尺寸為44nm和50nm的1 #和2 #樣品的電阻率分別在25k和45k附近開始隨溫度的升高快速增大，在曲線上出現拐點。
  3. Get the damping coefficient of each sample, and use it to reflect the resistance which wave energy suffers inside of breakwater 7

    6 、得出各個樣本的阻尼系數，並用其反映波能在堤心內傳播所受的阻力。
  4. We introduce the fabrication of all samples and anneal of fexcu ( 1 - x ) granular film in detail. the configuration of granule film is investigated by scanning tunneling microscope ( stm ). the matter phase is analyzed by x - ray diffraction ( xrd ). the hysteresis loop of co / al2o3 / feni magnetic tunnel junction is studied by vibrating sample magnetometer ( vsm ). we use microresistance test system ( mts ) to investigate the character of resistance, conductance, voltage and current

    用掃描電子顯微鏡（ stm ）觀察顆粒膜樣品的表面形貌；用x ?射線衍射儀（ xrd ）對顆粒膜樣品進行物相分析；用振動樣品磁強計（ vsm ）對co al _ 2o _ 3 feni隧道結的磁滯回線作了研究；用微電阻測試系統對樣品電阻、電導、電流、電壓相關特性進行詳細的研究。
  5. Four kinds of c / c composites with different preparation techniques were graphitized at 2400 - 2880. the relations between magneto - resistance and orientation ( the angle between surface of samples and magnetic field ), measure temperature, the intensity of magnetic field ( b ) were studied for each sample. the micro - structure and x - ray diffraction pattem were investigated too

    本論文在對制備工藝不同的四種碳/碳復合材料樣品進行2400 2880的石墨化處理后，應用ppms （ physicalpropertymeasurementsystem ）研究了測試位向（試樣某特定面和磁場方向夾角） 、測量溫度以及外加磁強對材料磁電阻特性的影響，同時研究了各試樣的微觀結構和x射線衍射譜圖。
  6. By contract with the resistance of cu2mg, the reason of the abnormality is not due to the portion of mgb2, but other components in our sample

    通過cu2mg樣品電阻的對照研究，發現該現象不是源於樣品中的mgb2部分，而是其他的雜相所引起的。
  7. Comparison of c - scan of entire sample and the date of local point a - scan collected and processed with the metallorgaphs of sample cross section showed that the method could be used to determine the spot size of resistance spot welding

    對接頭焊點的c掃描及對局部點的a掃描信號的採集與分析，經負際焊點橫截面的金相觀察對比，可以較準確確定點焊的焊核直徑。
  8. Statistic analysis on fatigue load effect and equivalent stress range of steel crane structures in service is carried out. the stress range distribution in whole life is deduced by the spot measurement little sample stress - time process. meanwhile the statistic analysis on the fatigue resistance process is conducted, according to fatigue data of all kinds of structural joints in domestic and overseas, which is foundation with, establish the fatigue reliability model

    2 、在大量調查的基礎上，對吊車梁所承受的疲勞荷載效應與等效等幅應力進行了統計分析，同時根據國內外有關各構造細節的疲勞資料對疲勞抗力參數進行了統計分析，為建立疲勞動態可靠性分析模式奠定基礎。
  9. To counter shortcomings such as oxidation, deform and getting an electric shock of resistance wire of traditional electric stove, this thesis developed a sealing coating for the traditional stove, including selecting material, burden and design of working technology, sample and spread sample have been prepared

    本文針對傳統電爐電阻絲容易氧化、變形、易發生觸電危險等缺陷，並從生產成本要求入手，研製了電爐用封裝塗層材料，包括塗層材料的選材、配料及加工工藝的設計，並據此制備試樣及塗覆樣品。
  10. The phase structure of different cu - fe thin films were studied by using grazing incidence x - ray analysis ( gixa ). the texture and residual stress of different cu - fe thin films were measured by scan of x - ray diffraction ( xrd ) and 2 scan with different. the thicknesses of different thin films were characterized by means of small angle x - ray scattering ( saxs ) technique. by using atomic force microscope ( afm ) measured surface roughness of thin films. the component of different thin film was characterized by energy disperse spectrum ( eds ) and x - ray fluorescence ( xrf ). the magnetic properties of cu - fe thin films were measured by means of vibrating sample magnetometer ( vsm ). in addition, the giant magnetoresistance ( gmr ) effects of different films were also measured. the original resistance of the film fabricated by a direction - current magnetron sputtering system is directly affected by bias voltage

    利用掠入射x射線分析（ gixa ）技術對不同cu - fe薄膜的相結構進行了研究;利用xrd掃描及不同角度的2掃描對薄膜進行了結晶織構及殘余應力分析;運用小角x射線散射（ saxs ）技術測量了薄膜的厚度;採用原子力顯微鏡（ afm ）觀察了薄膜的表面形貌;運用能量損失譜（ eds ）及x射線熒光光譜（ xrf ）對薄膜進行了成分標定;使用振動樣品磁強計測量了不同cu - fe過飽和固溶體薄膜的磁性能;最後利用自製的磁阻性能測試設備測量了真空磁場熱處理前後不同薄膜的巨磁阻值。
  11. Secondly, choose the sample component, as different particle match of tungsten carbide and specifically heat treatment craftworks of solution and aging manufacture test piece, watch metallurgical structure of the test piece and do the tests of hardness and tension, at last do the abrasive wear test on the dynamic load abrasive wear test machine, analyze test datum, from the test data, conclusions are arrived that the hardnees of composite - alloy can be improved and wear - resistance be better by adding cr and other elements according to a given ratio

    本文對rp中速磨煤機耐磨件進行了運行與磨損情況分析，研究、提出了制備磨輥和盤瓦復合合金成分配比；並對製作的試件進行了固溶、時效等特定的熱處理工藝，觀察試件金相組織，進行機械強度試驗，最後做磨料磨損試驗，對磨損失效機理進行了深入的研究分析，對其耐磨性能與低合金鋼、高鉻鑄鐵進行了對比。
  12. Electrical resistance in a rock sample may also vary

    巖層樣本的電阻也會改變。
  13. And the field of scientific research have been attached importance to research of subsoiling and develop of subsoiler, and gained considerable development, but subsoiling technology has not been extensive application, subsoiler has so many limitations too, and great resistance is prominent limitation. this dissertiation start with improving the status of resistance, optimizing parameter of structure, ploting structure graph of subsoiler by autocad, and constituting mathematical model of subsoiler resistance, finding out every affect factor of resistance, it is not only significant to optimize subsoiler, but to gain more precise value and parameter. and that it can detract the process of producing sample, experimentation and correcting, in addition to economizing time, saving resource and enhancing efficiency

    本文從改善深松鏟受力狀況、優化其結構參數以更好的滿足深松要求入手，利用計算機輔助設計（ autocad ）技術繪制深松鏟的結構圖形以利於其分析和設計，並通過對現存深松鏟的結構和受力分析，建立了深松鏟工作狀態的受力數學模型，找出了影響深松鏟受力的各個因素，不僅對深松鏟的優化有著重大的意義，而且可以得到更加精確的數值和參數，並減少了必須生產出樣機進行試驗、修正等煩瑣的過程，大大節省了時間，節約了資源，提高了生產效率。
  14. Testing of textiles ; determination of crease resistance of textile fabrics by measuring the angle of recovery, method of vertical fold on the wet sample

    紡織品的檢驗.第2部分:採用測量折角回復法對織物耐皺
  15. The paper through making marshall and the wheel rut test sample joining the fiber in the asphalt concrete, carries on a series of experiments and studied the asphalt concrete to mix the textile fiber by the marshall stability, the water stability, the high temperature stability, the low temperature crack resistance energy, and carries on the contrast analysis to the ordinary dense gradation asphalt concrete of the performance

    摘要通過將纖維加人瀝青混凝土中製成馬歇爾和車轍試件，進行一系列的試驗，研究瀝青混凝土摻纖維后的馬歇爾穩定度、水穩定性、高溫穩定性、低溫抗裂性能，並與普通密級配瀝青混凝土進行路用性能的對比分析。
  16. Execution standard ： the equipment is heating by intermediate frequency influence. it can test salg resistance of refractories by soaking and crucible, and test multi - sample

    製作依據：該設備採用中頻感應加熱，可用侵入法和坩堝法測試耐火材料的抗渣蝕性，並可同時做多個試樣的測試。
  17. We prepared sample l, sample 2 with single coil. and sample 3, sample 4 with two series coils. in this paper we discussed the frequency - dependence of theis inductance, resistance and quality factor ( q - value ) in a range of l00mhz - l0ghz

    本實驗中製作了單個線圈的樣品1和樣品2以及串聯的樣品3和樣品4 ，文中報告了這些薄膜電感的電感、電阻和q值在100mhz - 10ghz范圍內的頻譜特性。
  18. Therefore, we analyzed treatment results from a cross - sectional sample of patients with tb enrolled in a dots program in an area with high levels of drug resistance in uzbekistan and turkmenistan in central asia

    Dots計劃是在處于亞洲中部的烏茲別克斯坦和土庫曼蘇維埃社會主義共和國的高水平耐藥地區開展的。
分享友人
分享到 Line

分享到臉書