signal magnitude 中文意思是什麼
signal magnitude
解釋
信號幅度-
Second, the results of theory analysis and simulation research show that the output of one cycle controlled bridge switching power amplifier have dc offset because of the nonideal characteristic of reset signal. the magnitude of output dc offset voltage is proportional to width of reset pulse. a voltage compensation technique is used to solve this question, and the computation formula of compensation voltage is gived. the circuit compensated and not are researched through simulation and experiment, which results show that compensated circuit solve the output dc offset effectively
其次，理論分析和模擬研究結果表明，由於復位脈沖的非理想特性，單周控制的全橋開關功率放大器輸出端存在直流偏置問題，其大小與復位脈沖的寬度成正比。針對輸出直流偏置問題，提出了電壓補償的改進方案，給出了補償電壓的具體計算公式。對補償前和補償后的方案進行了對比模擬研究和實驗研究。 -
Gps is a planet wireless conductance system which is global and all - weather, gps can offer high precision time orientation information to infinite user, clock precision reachs 10 ? 6 magnitude 。 not only changes traditional time method of quartz crystal clock, but also replaces wireless shortwave and even more lowfrequency signal and tv signal whose overlay range is limited and low precision, offers advantage to geology field task, achieve automatization and high precision of seismic flow observation
利用gps授時信號全方位、全天候、連續性、實時性和高精度的特點，以gps信號為基準來校準本地時鐘（晶體振蕩時鐘或原子鐘） ，將gps接收機輸出信號的長期穩定度和恆溫晶振的短期穩定度相結合，應用大規模可編程邏輯器件，設計和實現了由pc104控制的實時在線授時系統。 -
According to the eer theory, using the amplified envelope signal as the power supply of the class - d amplifier, the envelope will modulate the magnitude of the rf signal. the modulated impulse rf signal is added to the impedance match circuit, so the amplified am signal is achieved
將放大的包絡信號作為class - d載頻放大器的電源，根據eer原理， class - d載頻放大器輸出載頻信號的幅度將受到包絡信號的線性調制，達到同時實現對載頻信號的放大和am調制的目的。 -
The affection brought up by magnitude and phase in vector signal analysis
幅相特性對矢量信號分析性能影響 -
Because the antigen ? antibody reaction is an equilibrium binding reaction, the magnitude of the signal relies on the concentration of each reactant
因為抗原抗體反應是一個平衡結合反應，所以信號量依賴于每個反應物的濃度。 -
In evaluating a read head, what really matters is not the raw magnitude of the mr effect but the head ' s signal - to - noise ratio, which depends on a number of other factors in addition to the amount of mr
評估讀取頭的性能時，真正重要的不是磁阻效應的大小，而是讀取頭的訊噪比，它除了和磁阻值有關之外，還和其他因素有關。 -
Estimates the magnitude sensitivity, magnitude valid range and probability of star capture based on signal detection and probability statistics
以信號探測和概率統計為理論基礎，對星等探測靈敏度、星等有效范圍和星探測概率進行了分析與估算。 -
The adaptive front - end has the adaptive ability for the magnitude and frequency of input signals. it can prefilter for the input signals, eliminate the useless signals, and improve the dynamic range of receiver system. it can lessen the burden of digital signal processing in the back - end of receiver, and improve the performance of receiver system
自適應接收機前端對輸入信號有自適應能力? ?頻率自適應和幅度自適應，這樣的前端就可將系統的接收中心頻率和帶寬自適應到輸入信號的頻率和帶寬，其實就是對輸入信號進行一次預分選、預濾波，剔除對接收系統毫無作用的信號;同時對大信號自動減小增益，對小信號增加增益，提高系統的動態范圍;而且可以對干擾信號進行壓制。 -
The input value of static weighing system is instant and the interference is small. nsr is high, then interference signal is ease to dispose. while dynamic weighing systems have different signal modes, yawp interference magnitude size and mode when it is in different facilities and different testing objects. in this thesis has optimum attempt in this point and find a solution which has perfect practicality
動態定量稱量技術是一項很有前景的技術，在我國發展也有很久了，但是這方面的技術還是不成熟，由於動態比靜態稱量要復雜得多，靜態稱量由於輸入值是恆定、干擾小、信噪比大，干擾信號易處理；而動態稱量系統對不同的設備、不同的測試對象產生的信號形式、噪聲干擾大小、方式均不同。 -
Compared with dcsk modulation, the fm - dcsk modulation changed the chaotic signals with random magnitude into the signal with constant magnitude and random frequency, thus the systemic noise performance is achieved
將振幅隨機變化的混沌信號變為頻率隨機變化而振幅恆定的混沌fm信號，降低了系統的誤比特率。 -
An action in which two or more signals are generated or two or more signal control elements are actuated by an input signal, each one responding consecutively with or without overlap to the magnitude of that input signal
一種作用機能操作過程，使一個輸入信號產生兩個或更多個信號，或由一個輸入信號驅動兩個或多個信號控制元件，而所產生的每個信號或所驅動的每個控制元件按其輸入信號的大小重疊或非重疊地順序響應。 -
Judging by the different magnitude and direction of the wavelet packet coefficient modular maximum, we can select the single phase - to - earth line. the method using wavelet singularity detection theory to extract the fault time is discussed. a fault distance measurement algorithm combining wavelet analysis used for separating the character from the transient fault signal with artificial neural networks used for the nonlinear approximation from the transient character to fault distance is presented
論文提出利用各個出線零序電流在頻帶上小波包系數模極大值的方向和大小的不同來實現故障選線，討論了利用小波分析的奇異性來判斷故障啟動時刻，提出將小波分析和人工神經網路結合，利用人工神經網路的非線性逼近能力，實現故障暫態量到故障距離的非線性映射，完成測距。 -
Operator on prpd mode of pd signal, mode - classifying implements based on bpnn and sart are compiled. the artificial neural networks designed are applied to recognize measured signals. conclusions are made : recognition rate of bpnn is 95 %, and it is respect to magnitude of discharging signal and increases while signal magnitude increasing ; the recognition rate of sart neural network is 98 %, higher than that of bpnn, recognition rate increasing with the number of signal group
論文用設計的人工網路模式識別程序識別測量信號：以prpd信號模式的放電次數為輸入時， bp網路識別率為88 ，識別率和發生局放的強弱程度有關，局放信號越強，識別率越高；以prpd信號模式的統計運算元為輸入時， bp網路識別率為95 ；以prpd信號模式的統計運算元為輸入時， sart網路識別率為98 ，識別率隨著樣本量的增加而提高。 -
When a smoothing function ' s first derivative is adopted as wavelet function, the local maxima of wavelet transform modulus detect the location of signal ' s singularities, in this thesis, these characters are not only applied to measure the magnitude of dead angles of the dissymmetry inrush but also the symmetry inrush in three - phase transformer
當小波函數取光滑函數的一階導數時，信號小波變換的模在信號突變點將取得局部極大值。本文利用這些性質不僅對三相變壓器的非對稱性涌流間斷角的大小進行測量，同時還測量了對稱性涌流的間斷角，測量精度有一定的改善。 -
Some methods for overcoming these disadvantages are investigated as follows : first, using shield and magnetic circuit to shorten the sensor length and enhance the signal magnitude ; second, improving the data acquisition system to intensify the capability of fine defect detection ; at last, adopting digital signal processing technology such as homomorphic filter, wavelet transform and error correction to ensure detecting reliability
本文結合有限元模擬和實驗方法，研究了改進遠場渦流技術性能的幾種方法，即：採用電磁屏蔽、磁路進行傳感器優化設計以縮短探頭長度、增大信號強度；改進信號調理電路以提高細微缺陷檢出能力；利用同態濾波、小波變換以及誤差修正等數字信號處理技術確保檢測結果的可靠性。 -
This method takes the second generation wavelet transformation as a base, using the interrelation between transformation sample and adjacent sample to detect partial feature of the signal, and according to the magnitude of related coefficient to define the optimal pre detector and re - newer of every sample in every dimension, so as to let the wavelet be able to suit fairly the partial feature of the signal
該方法以第二代小波變換為基礎，用變換樣本與相鄰樣本之間的相關性，來檢測信號的局部特徵，並根據相關系數的大小，來確定每一尺度上的每個樣本的最佳預測器和更新器，使小波能夠較好地適應信號的局部特徵。 -
The results showed that the magnitude and shape of mfl vary with the change of wire rope tension. with the stress increment, the peak to peak values of broken wires reduce obviously and the total strength of mfl signal becomes weak and the ripple of mfl signal curve appears
試驗研究發現，漏磁密度的大小及形態都隨鋼絲繩張力的變化而改變，隨張力增加，斷絲峰峰值明顯減小，漏磁信號的總體波動強度減弱，漏磁曲線上有應力波紋出現。 -
The butterworth wavelet filter with good magnitude - frequency characteristics is adopted to process the vortex flow signal, and the fundamental frequency of signal is estimated effectively. the algorithm is implemented in a digital signal processing system based on a tms320vc5409 dsp chip, and its effectiveness is proved
採用幅頻特性較好的iir型butterworth小波濾波器，處理渦街流量信號，估計基頻，並在以tms320vc5409為核心的渦街流量計數字信號處理系統上實現，證明其方法的有效性。 -
The small - signal model in main circuit are built by using average circuit model. the relationship of each small signal and efficiency duty cycle are described completely. magnitude - frequency characteristics and phase - frequency characteristics of each main transfer function are got
本文分析了全橋移相zvspwmdc - dc變換器的基本原理，運用平均等效電路法建立了主電路小信號模型，並詳細分析了各小信號變量與有效占空比之間的關系，得到了各主要傳遞函數的幅度和相位頻率特性。 -
Then the paper presents two important concepts on wavelet transform : multi - resolution analysis and wavelet package analysis. last, the paper introduces the application of wavelet transform on power quality analysis, especially on the research of voltage flicker. we can get the magnitude and frequency of the embed signal by mra
最後介紹了小波變換在電能質量分析中的應用，重點討論了電壓閃變問題，用小波多解析度分解和子帶濾波方法對電壓閃變的包絡信號進行分解，檢測出包絡信號中的各個頻率分量及其幅度。
分享友人