standing wave 中文意思是什麼

standing wave 解釋
【物理學】駐波，定波。

  • standing : adj 1 直立的；站著的。2 【林業】未伐的。3 【農業】尚未收割的。4 停佇的；停滯的，不再運轉的，不流...
  • wave : n 〈美海軍〉女志願軍人〈見 WAVES 條〉。n 1 波浪；碎浪； 〈the wave（s）〉 〈詩〉海。2 波動；波狀...
  1. After reviewing the history and recent developments of the research on thermoacoustics, and introducing the classical thermoacoustic theory, we carry out the following investigations : 1 ) thermoacoustically driven pulse tube refrigerator ( tadptr ) experiments have been done on the self - built pulse tube refrigerator driven by standing wave thermoacoustic prime mover system

    本文首先回顧了熱聲機械的歷史及現狀，詳細介紹了熱聲學理論基礎，重點研究了以下若干問題： 1駐波型熱聲驅動器驅動脈管製冷機在自行搭建的駐波型熱聲驅動脈管製冷機實驗裝置上進行了實驗研究。
  2. Some simulations with deltae has also been made to predict the performance of the system. at the end of this section, proposals and schemes are also given for the further experiments. 4 ) thermoacoustically driven puke tube refrigerator ( tadptr ) with the successful operation of the standing wave thermoacoustic prime mover, we transferred part of our efforts to the thermoacoustically driven pulse tube refrigeration, which is actually the original aim for our study on the thermoacoustic prime mover

    熱聲驅動脈管製冷機在成功研製熱聲驅動器的基礎上，對其與脈管製冷機（一種在低溫端沒有運動部件的新型的低浙江大學博士學位論文金滔：熱聲驅動器及其驅動的脈管製冷研究2001年5月溫製冷機）的聯接進行了匹配分析，並搭建了熱聲驅動脈管製冷機的實驗臺，進行了系統的實驗研究。
  3. Physical design of 2 mev standing wave accelerating tube

    駐波加速管物理設計
  4. Standing wave representations such as these are called atomic orbitals.

    這種駐波示意圖叫做原子軌道。
  5. There is no finite velocity of propagation, and we speak of a standing wave.

    波沒有有限的傳播速度，因而我們稱之為駐波。
  6. Particles suspension in a standing wave tube and its analysis

    駐波管中的顆粒懸浮現象及其分析
  7. Non - standing wave type ultrasonic generator

    非駐波型超音波產生器
  8. Swr standing wave ratio test procedure for electrical connectors and sockets

    電連接器和插座的駐波比
  9. Standing wave ratio test procedure for electrical connectors and sockets

    電連接器及插孔的駐波比試驗程序
  10. Standing wave protection ciruit

    駐波保護電路
  11. In tins paper, a new type of standing - wave linear usm with square - ring vibrator was presented, which had two contact surfaces and a support structure with four flexure hinges for the power output

    摘要利用有限元分析軟體對方環形直線駐波超聲波電動機的振子進行了動態設計，提出了一種環梁式雙接觸面的振子結構，該振子採用柔性鉸鏈與支撐結構連接，實現力的輸出。
  12. Abstract : it is observed that the sommerfeld ' s formula for a progressive spherical wave is not covariant with respectro the rotation of the coordinate system. it contains complex partial waves that are not physical. the standing wave representation of the same formula is shown to be covariant and physical. it is applied to solve the boundary value problem of fiber optics. the radiation modes as well as the guided normal modes are obtained in closed forms. the intensity distribution in various modes is obtained. it is remarked that the mode of critical refraction is missing

    文摘:說明了球面行波的索末菲公式在坐標轉動下不協變.證明了球面波的駐波表示是協變的，因而是一個物理的關系式，故適用於圓柱坐標中各類波動方程的定解問題.作為一個例，應用於光纖光學，導出了受導簡正模和輻射模的表達式，以及各模式的強度分佈
  13. An experimental setup has been designed and built up through a collaboration program between cryogenics laboratory in zhejiang university and limsi - cnrs ( france ). the system employs the inherently reversible stirling cycle, and then its thermodynamic efficiency can easily surpass that of standing - wave system and is even comparable to that of the traditional internal combustion engines

    在充分理解工作機理的基礎上，與法國國家科研中心limsi實驗室合作，設計並建成一臺行波型熱聲驅動器實驗裝置，進行了初步實驗，以氨氣和氮氣為工質，成功地獲得了頻率分別為66hz和23hz的熱聲振蕩。
  14. The influences of stator ' s teeth on vibrating modal of the linear standing wave usm are discussed in this paper, in which eigenfrequency and wave - shape are analyzed while the position and geometry dimension of stator ' s teeth are changed, and it can give some advice on design for standing wave linear ultrasonic motor

    摘要本文對一類直線型駐波超聲電機振子的振動模態進行了系統的分析，討論了定子齒的位置、幾何尺寸對直線型超聲電機的固有頻率、振型的影響，為該類駐波型直線超聲電機的設計提供了理論依據。
  15. The detail study on the interaction between the electron beam and standing wave of complex cavity gyrotron with gradual transition and gyroklystron has been done in this dissertation, supported by the pre - study important items " the study on 8mm third harmonic gyrotron with a permanent magnet system " and " the study on 8mm high power gyroklystron ". the main works of this dissertation are listed as following : 1. the study on the rf distribution of the complex cavity with gradual transition is presented, in which the multi - modes coupling are taken into account

    本論文就是結合該課題組的「九?五」重點項目「 8mm三次諧波永磁包裝迴旋管技術的研究」及「十?五」重點項目「 8mm高功率迴旋速調管技術的研究」 ，對以諧振腔為互作用高頻系統的迴旋脈塞器件中兩種典型的器件? ?迴旋振蕩管及迴旋速調管中電子注與駐波場的互作用進行了深入細致的探討和研究，其中迴旋振蕩管採用的是漸變復合腔。
  16. Design considerations of the high power s - band rka are described, by using electron beams of voltage - 600kv, current - 5000a, and the numerical simulations for three kinds of the rka output structures are given. the three kinds of the output strctures are single - gap standing - wave ( sw ) cavity, traveling - wave ( tw ) output structure, and two output structures ( single - gap + traveling - wave structure ). under conditions of using two output structures, the results show that the instantaneous peak power obtained from sw output cavity and tw output structure is respectively 2. 4gw and 2. 1gw, the both power average of 0. 96gw and 0. 93gw, i. e. the s - band rka of two output structures generates peak output power of 1. 89gw at a frequency of 2. 85ghz

    從數值模擬中得到雙輸出結構的微波功率輸出結果為:駐波輸出的瞬時功率為2 . 4gw （周期平均為0 . 96gw ） ;行波輸出結構輸出瞬時功率為2 . 1gw （周期平均0 . 93gw ） ，就獲得了頻率為2 . 85ghz的微波輸出。本文簡要的描述了電磁軟體（ magic ）對速調管輸出腔體進行了模擬，並對相應的模擬方法進行了評述。
  17. Theory and regulation on the main vibrator of standing - wave accelerator

    駐波加速器主振蕩器的工作原理及調整方法
  18. 2 ) hysteretic loop emphasis has also been focused on the onset and damping behavior of the thermoacoustic oscillation. based on the acute review and analysis on the non - steady processes with hysteresis, a hysteretic loop is proposed and experimentally verified for the first time in the standing wave thermoacoustic prime mover

    熱聲振蕩滯后迴路在系統地考察其它非穩態過程特性的基礎上，首次提出並實驗驗證了熱聲起振和消振過程中存在「滯后迴路」 ，並對滯后迴路的影響因素進行了研究。
  19. After a detailed review on the historical developments of the research on thermoacoustics, as well as the latest advances in this field, prospective applications, and a survey of theoretical fundamentals, the present work focuses on the following sections : 1 ) standing wave thermoacoustic prime mover an experimental setup of standing wave thermoacoustic prime mover has been built up with brass matrix as the thermoacoustic stack

    本文首先回顧了熱聲熱機的發展歷史及最新成就，在詳細介紹熱聲學理論基礎以及熱聲機械設計原則之後，重點研究了以下若干問題： 1駐波型熱聲驅動器建立了我國第一臺實用駐波型熱聲驅動器試驗臺，並進行了實驗研究。
  20. This dissertation is mainly about the transit radiation of the electron beam passing through the gap with the random standing wave electric field. in order to satisfy the requirement of the task, the feasibility of generation of more than 1 gw high power microwave in x - band using the transit radiation oscillator based on the transit effect is studied

    研究了二維柱坐標系網格劃分演算法，並用此演算法對五腔開放腔進行網格劃分，採用時域有限差分與快速傅里葉變換相結合的方法計算了五腔開放腔/ 6 、 2 / 6 、 3 / 6 、 4 / 6 、 5 / 6模這五個模式的頻率和場分佈。
分享友人
分享到 Line

分享到臉書