stress surface 中文意思是什麼

stress surface 解釋
受力面
  • stress : n 1 壓力，壓迫，緊迫，緊張。2 【語音】重音；重讀；【詩】揚音；語勢，著重點。3 重要（性），重點，...
  • surface : n 1 表面；地面；水面；廣場，空地。2 外觀，外表，皮毛。3 【幾】面；切口；【航空】翼面。adj 表面的...
  1. The temperature of surface concrete varies with environmental temperature, but the conductibility of inner concrete is very poor. as a result, a quick decrease of environmental temperature will lead to large temperature gradient and then tensile stress develop soon in the thick direction, which will probably occur on the entire cross - section

    混凝土表面溫度隨外界溫度波動而波動，但內部的導溫性能很差，所以在外界溫度驟降時將引起很大的溫度梯度，從而在厚度方向上拉應力發展很快，這極易引起全斷面拉應力發生。
  2. In chapter three, we negative the nonliear terms in the system of equations which include surface pressure, wind stress and coriolis force terms. the height of the storm surge and the storm current can be seen as two terms

    在第三章里，我們忽略了控制方程中的非線性項，將風暴潮潮高和風暴潮流分成氣壓效應和風應力效應的疊加。
  3. Numerical analysis of surface stress and desquamating for piston ring with chromeplating surface

    鍍鉻活塞環表面層工作應力及剝離的數值分析
  4. The luminal surface of the blood vessel and its endothelial surface are constantly exposed to hemodynamic shear stress

    血管內皮細胞作為血管的最內層，生活在血流環境中，終生受到血流的作用。
  5. Secondly, through analyzing the failure instance of electrical connectors in using and testing environment, educed contact fault was a main mode of failure of electrical connectors. on natural working conditions, the main reasons which caused fault of electrical connector were contact stress decreasing, microseism wearing and tearing and surface film growing

    而在正常的工作條件下，造成電連接器電接觸失效，即決定電連接器工作壽命的主要原因是接觸壓力減小、微動磨損和表面膜層的生長，而影響接觸壓力、微動磨損和表面膜層變化的主要因素是環境振動和溫度。
  6. When the effect of surface wave breaking is considered, mld is 50 cm deeper than that obtained without wave breaking, and with the enhancement of wind stress forcing, the deepening of mld is increased

    模擬結果表明，當考慮波浪破碎的影響時，混合層深度比無波浪影響時的結果加深了約50cm ；隨著風應力作用的增加，波浪破碎加強了混合層中的湍流混合，促使加深幅度也增加。
  7. It can give vector of stress, and break factor and direction vector of tensive crack and shearing crack in the special observation planes ( for examples, in a stratal surface which is fluctuant in depth )

    軟體可視化包括：空間應力矢量（大小和方向） 、裂縫性態（張裂縫和剪裂縫發育程度及其方向矢量）在特定觀察面（如沿起伏的地層面）上的展示。
  8. The subject for different process technology and surface treatment of crank takes tracking checkout for its internal stress, analyses relation of jumping measurement, deformation measurement, recovery measurement and stress change, finds the reason and usual law of jumping overproof of crank. through cold pressure alignment, hot pressure alignment, support aged alignment and so on methods for 42crmo steel crank, the subject checks change of stress in the process of alignment and change of tissue and property after alignment for crank, and gives comprehensive evaluation for every alignment technology, then give safe and feasible technology parameter

    本課題主要是對不同加工工藝及不同表面處理過程的曲軸，對其內應力進行跟蹤檢測，分析各工藝過程中跳動量、變形量、恢復量與應力改變的關系，找出曲軸跳動量超差的原因和一般規律。通過對42crmo鋼曲軸進行「常溫壓力校直」 、 「熱壓力校直」 、 「支撐時效校直」等方法的校直，檢測校直過程中曲軸應力的變化及校直后組織和性能的改變，進而對各校直工藝進行綜合評價，給出安全可行的工藝參數。
  9. The surface acoustic waves stress sensitive properties of piezoelectric crystal la3ga5sio14 base on stress sensitive coefficients

    基於應力敏感系數的硅酸鎵鑭晶體聲表面波應力敏感特性
  10. We call this surface the stress quadric.

    我們稱這個曲面為應力二次曲面。
  11. The small pits that form on the surface act as stress raisers.

    在表面形成的小凹坑起到應力增高源的作用。
  12. In this paper, features of decadal variability and the possible mechanism of sea - air system in the pacific are investigated by using upper - ocean temperature, heat storage and wind stress data, the main results are as follows : the most pronounce decadal sign exists at about 160 meter in depth in the western pacific. there are significant decadal abrupt changes in temperature from surface to deep in the subsurface at about 1980. with different depth in the subsurface, there exist 4 types of abrupt change modes, their generation is closely related to the decadal sign which originates from the east of north pacific and propagates along the south - west subduct ion route

    研究表明，太平洋次表層海溫最強的年代際信號在熱帶西太平洋約160m深處，此信號在1980年前後從上至下，先後經歷了一次顯著的年代際突變過程，而且隨深度的不同存在著四種不同的空間突變模態，這四種模態的形成與北太平洋海溫異常的西南潛沉路徑有著密切的聯系。
  13. The temperature effect which has been calculated is taken as " thermal load " forced on the body, then such thermal stress is settled as general elasticity mechanics question ; secondly, the thermal stress is taken as " surface force " forced on the body, and the new system stiffness is formed which include the extra stiffness matrix, then it changes the nature frequency of the structure

    首先，這篇論文介紹溫度場和熱應力場的有限元方法，建立了三維熱傳導模型計算有溫度場產生的熱應力，計算熱應力時運用了一種轉化思維：將溫度處理為「溫度載荷」 ，這樣就能用彈性力學問題的處理方法來求解熱應力。其次，將熱應力作為結構的「面內力」 ，而面內力產生附加的幾何剛度矩陣，改變了結構的剛度，影響了結構的固有頻率。
  14. An anisotropic time - dependent trinal - yield - surface model for the stress - strain - time behavior of soft clay

    軟土各向異性三屈服面流變模型
  15. In this paper, the finite - element numerical analysis calculation is applied to the foundation of high - rise and multi - floor building and the evolvement law of stress and displacement of tunnel used by urban traffic to explore the mutual influence between the wall rock of underground space and high - rise building foundation, taking account of the specific construction situation in the " sanmu garden " project in dadukou district in chongqing, from the perspective of underground space static - force structure stability analysis to open a underground tunnel with 6m in span and 7. 5m in height for track traffic 20m below the surface. this paper, taking considerations of three different states, i. e. the natural state without any artificial interference, the state of high - rise buildings on the surface, and the underground tunnel state with excavation for track traffic, and four plane lines and four vertical lines, analyzes and studies the distributing law of stress and displacement of calculation section from the following aspects : ( 1 ) the main stress vectorgraph, displacement distribution graph ( ux, uy ) and chromatogram graph of stress isoline ( 1, 2, xy ) of section under different states ; ( 2 ) the contrastive distribution curve of stress ( 1, 2, xy ) of different plane and vertical lines under the same state ; ( 3 ) the contrastive distribution curve of stress ( 1, 2, xy ) of the same plane and vertical lines under different states, wishing to provide references for underground space utilization and project designing and construction of the tunnel under high - rise buildings in the future

    本文結合重慶市大渡口區「三木花園」開發建設項目，從地下空間靜力結構穩定性分析角度出發，針對在該項目中涉及的高層和多層建築物以及在其地下20米處開挖了一個用於軌道交通的跨度6米，高7 . 5米的地下隧道這一具體工程情況，採用2d - 3d -有限元結構分析程序對高層與多層建築物的地基基礎及其與城市軌道交通使用的地下隧道圍巖的應力與位移演變規律進行了有限元數值分析計算，探索了地下空間圍巖與高層或多層建築物地基基礎之間的相互影響，通過考慮未受到任何人為擾動影響的天然狀態、地表存在多層或高層建築物狀態和地下開挖用於軌道交通的地下隧道狀態等三種不同狀態以及4個水平剖線和4個垂直剖線等不同情況，從以下幾個方面具體分析研究了計算斷面的應力與位移分佈規律： （ 1 ）在各種不同狀態下計算斷面的主應力矢量圖、位移分布圖（ ux 、 uy ）以及應力等值線色譜圖（ _ 1 、 _ 2 、 _ （ xy ） ）等； （ 2 ）相同狀態下不同水平與垂直剖線的應力_ 1 、 _ 2和_ （ xy ）對比分佈曲線； （ 3 ）不同狀態下相同水平或垂直剖線的應力_ 1 、 _ 2和_ （ xy ）的對比分佈曲線等，為今後在對地下空間的開發利用以及在高層建築物地下開挖硐室時的工程設計和工程施工提供參考依據。
  16. The fem analysis for the three structures of sling screw - thread - based, namely the circle, rectangle and that with strengthen plate, and the tensile test for sling screw - thread - based in torpedo body show, that the bonding with strengthen frp plate between load - bearing metal parts and frp hull with hatch can reduce the stress concentration and significantly decline the local stress in frp hull with hatch. this structure can also be used in the similar produces. ( 3 ) the effects of parameters for bonding process on the adhesive strength and leakproof are discussed, such as the bonding interface reduce, bonding surface treatment, match of adhesive surface, protect for adhesive seam and so on

    本文通過某型號雷體吊耳螺紋座結構的三種方案，即圓形昂耳螺紋座、長方形吊耳螺紋座、具有增強板的吊耳螺紋座的有限元分析及雷體吊耳螺紋座拉力試驗結果證明：金屬承力件與開口玻璃鋼殼體粘接採用玻璃鋼增強板補強，緩和了應力集中，使開口殼體局部應力明顯降低，類似的水下兵器用金屬承力件與開口復合材料殼體膠接均可採用此種結構形式。
  17. The newly developed cutting - type integral unit v - belt can carry heavy - load transmission. thetransmission is of multi - stress surface, therefore the belt can resist abrasion whit small slippage and high effciency and work reliably, and is suitable of heavy - load transmission

    本公司新開發切邊式聯組v帶，該帶可承載高負荷傳動，傳動受力面多、耐磨損，滑差小，效率高可靠性好，適于大負荷的傳動。
  18. The energy equilibrium equation and the relation between plastic work and the critical stress surface are given

    給出了臨界狀態下的能量平衡方程及塑性功與臨界應力面的關系。
  19. Plastic stress surface

    塑性應力面
  20. It points out that the principal strain rate is coaxial with the principal stress at critical state and is independent of the critical stress surface

    指出散粒體臨界狀態下的主應變率與主應力共軸，而與臨界應力面形狀無關。
分享友人
分享到 Line

分享到臉書