structural resistance 中文意思是什麼
structural resistance
解釋
【航空】前面阻力。- structural : adj. 構造上的，結構上的，組織上的。adv. -ly
- resistance : n. 1. 抵抗，反抗，抗拒，抵禦；敵對，抵抗力，反抗力，阻力，【生物學】抗病性。2. 【電學】電阻；阻抗；電阻器。
-
Through the experimental research, we think : the technological capacity of fiberglass asphalt macadam if weaker than asphalt macadam, however, if use elasticized capacity to solve blending technological problem. adjust the breed of fiber silk, extend its diameter, its paving capacity is still worth exploring, asphalt - rubber macadam structure lager have good deformed - become capacity and crazed - resistance capacity, small gap rate. good water - resistance capacity, good hot - stability and simple construction technology. therefore. pitch rubber spall is a good cover material which is suitable for the second class or lower whose asphalt pavement has split open because of fatigue. and is the good structural measure of preventing half - rigidity grass - roots unit shrink - rift reflecting. pave a thin layer of pitch rubber spall between asphalt - type pavement layer and half - rigidity basic level, although the cost of building is higher than paving togongbu in the middle, the construction technology, crazing - resistance and water - resistance are better than togongbu, not only could reduce greatly the reflex of half - rigidity grass - roots unit material, long then the use lifespan of pavement, but also it is possible to reduce suitably the thickness of asphalt mixture layer, though the cast of building in the early days becomes more, in the long - term opinion, it have fully important technological and economical significance
通過試驗研究認為：玻璃纖維瀝青碎石的技術性能不如瀝青碎石好，但路用彈性性能較好，如能解決拌和工藝問題，調整纖維絲的品種，增大其直徑，其路用性能仍值得探討，瀝青橡膠碎石結構層具有變形性能和抗裂性能良好，空隙率小，防水性能好，熱穩定性較好，施工工藝簡單的特點，因此，瀝青橡膠碎石是二級及二級以下公路因疲勞而開裂的瀝青路面的良好罩面材料，也是防止半剛性基層收縮裂縫反射的良好結構措施，在瀝青類路面面層和半剛性基層之間夾鋪瀝青橡膠碎石薄層，雖然造價比夾鋪土工布高，但其施工工藝，抗裂性能和防水性能均優于土工布，不僅可以大大減少半剛性基層材料的反射裂縫，延長路面使用壽命，而且可能適當減薄瀝青混合料面層的厚度，雖然初期造價有所增加，從長遠來看，具有十分重要的技術和經濟意義。 -
Information updating based on multi - layer bayes structural resistance model
先驗抗力模型的結構信息更新 -
5. have known the goal reliability index m, the structural resistance can be back calculated ; furthermore the members can be designed
五、已知目標可靠指標_ m 、荷載模型及參數，結合動態可靠度理論可反求結構抗力，進而進行構件的截面設計。 -
To overcome the shortage, in this paper, the time parametert is introduced into the structural resistance and load model, and it makes the calculation of the dynamic reliability available. 2
本文在借鑒前人研究成果的基礎上，在結構抗力模型和荷載模型中引入了時間參數t ，提出了一個簡單、實用的動態可靠度計算方法，為後文的可靠性評定，壽命預測奠定了基礎。 -
The equation of the structural limiting state can be expressed : z = r - s, thereinto r and s respectively are structural resistance and load response expressed with stochastic variables, we ca
結構的極限狀態方程可以表示為： z = r ? s ，其中r和s分別為用隨機變量表示的結構的抗力和荷載響應，通過極限狀態方程就可以得出結構的失效概率，或者是用可靠指標表示的結構的可靠度。 -
This paper studies the reliability of structure during the construction period based existing data and the consideration of structural resistance increasing with time, and analyzed an example, the result of the analysis shows this method is available to the analysis of the structure reliability
在已有的鋼筋混凝土結構現場施工活荷載統計資料的基礎上，考慮了抗力在施工期間隨時間增長的特性，研究了結構的可靠度，分析了算例。 -
On the basis of analysis on the influences of the foundation soil in goafs on the site seismic properties and the plane layout of buildings on the performances of the structural resistance to deformation, this paper puts forward a series of basic design plans and construction measures for buildings on goafs
摘要在分析采空區地基土對場地地震屬性及建築物平面布置對結構抗變形性能影響的基礎上，提出了采空區建築物基礎設計方案及構造措施。 -
Study on the wear resistance of three carburizing structural steel after different chemico - thermal treatment
三種滲碳結構鋼經不同化學熱處理后耐磨性的研究 -
Rolling stock. recommended steels for rolling stock construction. iii : structural steels with improved atmospheric corrosion resistance. copper steels
鐵路車輛.鐵路車輛製造推薦用鋼. .提高耐氣候腐蝕的結構鋼.含銅鋼 -
Finally, a correlative equation about bearing capacity of this structural member under bending and torsion is deduced, which may provide design of such structural members a valuable reference. to imitate centrifugal concrete - filled steel tubes used in real structures, three - dimension models are built up by using finite element method. the resistance performance of this structure under complex loads is studied
利用三維有限元模擬分析方法對離心鋼管混凝土在彎扭組合作用、彎壓組合作用、壓扭組合作用下的構件彈性應力分佈進行了研究，分析了離心鋼管混凝土構件在組合作用下的工作機理和承載力的相關關系。 -
Structural use of timber - fire resistance of timber structures - recommendations for calculating fire resistance of timber stud walls and joisted floor constructions
建築用木材.第4部分:木結構耐火性.第2節:木螺栓墻和格柵地板結構耐火性計算推薦標準 -
Standard test method for resistance to deformation under static loading for structural wood laminating adhesives used under exterior wet use exposure conditions
室外潮濕條件下結構木材用膠粘劑在靜負荷下抗變形性的標準試驗方法 -
The method is described as follows : the velocity of the moving part and the gas chamber pressure were measured with a dynamic test measurement system ; a dynamic model was built on force analysis of the moving part ; the total kinetic resistance replaced the horizontal friction and water resistance ; then the resistance - velocity relation curves at moving stages were obtained ; with the empirical formula of the gas chamber pressure and the resistance - velocity relation curves, the preliminary dynamic characteristics were analyzed and the structural form and key parameters of an underwater assault rifle were determined
具體方法為：由動力學測量系統測得活動件速度和氣室壓力；分析活動件的受力，建立動力學模型；以運動總阻力代替水平方向上的摩擦阻力和水阻力，獲得各運動階段的阻力速度關系曲線；利用氣室壓力經驗公式和阻力速度關系曲線，對水下突擊步槍進行初步的動力學分析，確定其構造型式及主要參數。 -
The main contents that are researched in the thesis are : asphalt mixture low temperature crazing principle, the influencing factor of asphalt mixtures low temperature crazing, asphalt - rubber macadam, the pressure - resistance intensity, the crazing high temperature, the smooth - resistance and construction technology, the technological economical compare and so on, exploring the new - type structural combinations of asphalt pavement
本文研究的主要內容是：瀝青混合料低溫開裂機理，瀝青混合料低溫開裂影響因素，瀝青橡膠碎石，玻璃纖維瀝青碎石的高溫抗壓強度，低溫劈裂強度，抗滑性能及其施工工藝，技術與經濟比較等，探索新型的瀝青路面結構組合。 -
It has good fight impact and certain heat resistance, it is mainly apply to make insulation structural of low voltage of electrical equipment as well as daily use utensil accessory etc. product appearance submits granular
也適用於傳遞成型或壓製成型。具有一定的抗沖擊性和良好的耐熱性，適用於製造低壓電器絕緣結構件以及日用器皿配件等。產品形狀呈粒狀。 -
It is applied in manufacturing the automatic structural parts, especially higher environment protective auto inner parts ; low - volt electric insulation parts which need higher impact strength higher wearable properties better heat - resistance colorful and must be made from thermosetting plastic ; low - volt electric structural parts which need no corrosion to free ammonia and formaldehyde mainly preventing the insulation material to corrode the silver electrode ; accessory of dishware and kitchenware which need functionality demand including no melting no dissolving and affording high temperature, and ornamental demand which has colorful performance. the appearance of the product submits granular shape
本產品適用於製造汽車零件，特別是有環保要求的高級轎車的內飾件低壓電器的絕緣結構件，尤其是要求沖擊性能較高耐磨性好耐熱性好和顏色鮮艷的又必須是由熱固性塑料製造的低壓電器絕緣結構件，也適用於對游離氨和游離甲醛含量主要是防止絕緣材料對銀觸頭的腐蝕有要求的低壓電器絕緣結構件餐具和廚房用具等日用品配件，特別是既有不熔化不溶解經得起高溫烘烤的功能性要求，又有色澤艷麗的裝飾性要求的高檔日用品。 -
By the use of gelation - flow - casting method, the troubles caused by the structural characteristics of pvf resins were resolved, and the produced films met a bright foreground of application with super properties such as uv resistance, mechanical strength and light transmittance
該工藝克服了聚氟乙烯自身結構特性給成型帶來的困難，得到的薄膜產品具有耐候性強、強度高、透光率大等優點，並有很好的應用前景。 -
Carbon and high - strength electric resistance forge - welded steel structural shapes
碳和高強度電阻鍛焊鋼結構型材 -
Zirconium alloys are employed extensively in light water cooled reactors ( lwr ) as the cladding materials of fuel elements and other structural materials because of the low capture cross - section for thermal neutrons, good resistance to water - side corrosion at elevated temperature, adequate mechanical properties and high thermal conductivity
由於鋯的熱中子吸收截面小，並具有優異的耐高溫水腐蝕性能、良好的綜合力學性能和理想的熱導率，因此，鋯合金被用作核電站水冷動力堆核燃料元件的包殼材料和堆芯的其它結構材料。 -
It ' s an ideal structural system and has multi - earthquake resistance ability because of a great deal of slabs removed in floors above the transfer - story amended the lateral stiffness of the stories near the transfer - story. based on the available references, the five - spring line element, the three - spring line element and the multiple vertical - line - element model are introduced to model special column, beam and shear - wall, the relevant stiffness matrixes are deduced and the restoring - force models are gaven to deep into the elasto - plastic seismic characteristics of the structure. acording to the results of shaking table test and elastic finite element analysis, a new making model melhod is presented in which uses the linear and the nonlinear element and the assumption that the floor is infinitely rigid in different areas
為進一步研究這種復雜高層建築結構的彈塑性性能，本文在國內外現有研究的基礎上，提出利用五彈簧桿元、三彈簧桿元及多豎線單元模型分別模擬空間柱、梁和剪力墻，推導了相應的剛度矩陣並給出了恢復力模型；結合試驗研究和精細有限元分析的結論，提出線性和非線性單元相結合，剛性樓板假定和彈性樓板相結合的建模方法，較好地解決了空間結構彈塑性分析中佔用計算機資源較多的問題；接力大型有限元分析程序? ? ansys ，在上述建模思路的指導下建立了結構的空間非線性分析模型，進行了空間三維彈塑性時程分析。
分享友人