temperature cross 中文意思是什麼

temperature cross 解釋
溫度曲線交叉
  • temperature : n. 1. 溫度,氣溫。2. 體溫。3. 〈口語〉發燒,高燒。
  • cross : n 1 十字架;〈the C 〉 耶穌受刑的十字架。2 〈the C 〉 基督教(教義,國家)。3 不幸,苦難;挫折,...
  1. The elasticity polyurethane joint sealing material is one kind of joint sealing materials for concrete pavement joint which can use at normal temperature. it will solidify by chemic - reaction when commix the polyurethane preploymer, cross link agent, filling, plasticizer and catalyzer

    聚氨酯彈性嵌縫料是一種由聚氨酯預聚體主劑與交聯劑、填料、增塑劑以及催化劑混合后通過化學反應交聯固化的常溫施工式水泥混凝土路面用嵌縫材料。
  2. The temperature of surface concrete varies with environmental temperature, but the conductibility of inner concrete is very poor. as a result, a quick decrease of environmental temperature will lead to large temperature gradient and then tensile stress develop soon in the thick direction, which will probably occur on the entire cross - section

    混凝土表面溫度隨外界溫度波動而波動,但內部的導溫性能很差,所以在外界溫度驟降時將引起很大的溫度梯度,從而在厚度方向上拉應力發展很快,這極易引起全斷面拉應力發生。
  3. Peroxidation of membrane lipid and calcium distribution in grape mesophyll cells during cross adaptation to temperature stresses

    溫度逆境交叉適應對葡萄葉片膜脂過氧化和細胞鈣分佈的影響
  4. Temperature measuring and study of open spandrel rigid - framed arch bridge with box cross section

    箱型截面空腹式剛架拱橋溫度場的實測與研究
  5. Simultaneously cross - linked and quaternized 4 - vp - co - nbuma was also investigated as humidity sensing materials and showed good linearity, high sensitivity, good high stability at high humidity and high temperature, and durability to organic solvent, etc. sensors based on 4vp - co - buma ( vp / buma = l / l ) with crosslinking and quaternization reaction of 17 hours exhibited a change of three orders of magnitude ( 104 ~ 107 ) in impedance over the range of 95 % rh ~ 30 % rh, showing high sensitivity, and little hysteresis was observed

    元件具有響應線性度好,靈敏度高,濕滯小、高溫高濕穩定性好、耐無水乙醇有機溶劑性能好等優點。其中,交聯季胺化17小時配料比為1 1共聚物濕敏元件,在33 rh 95 rh濕度范圍內,阻抗變化達3個數量級( 10 ~ 7 - 10 ~ 4 ) ,響應靈敏度高,幾乎無濕滯。
  6. High temperature resistant measure is taken to extend its service life significantly in comparing with the tube still hot air furnace, whereas, cross brushing of heat sink by the smoke and negative pressure smoke exhaust are used to ensure a clean heat exchanging position with stable thermal performance

    該爐採取了耐高溫措施,從而使其壽命比列管式熱風爐大大延長,並採用了煙氣縱向沖刷散熱片和負壓式排煙方式,換熱部分不積灰塵,無須清理,熱性能穩定。
  7. The magnitude of these variables increased approximately ten times. it helped the rapid releasing of instability energy. the interaction of high - level and low - level mesoscale system leads to the rainstorm. the vertical cross section analysis of potential temperature tells us that rainstorm take place in the warm - moist and instability area. usually locate in the very stiff moist isentropes and it can lead to the development of vortex

    通過對相當位溫的垂直剖面分析,可知兩場暴雨的中低層都為暖濕不穩定區,暖濕不穩定區上部冷空氣明顯擴散,暴雨產生在暖濕對流不穩定區內,通常產生在_ e陡峭和密集區中, _ e陡峭和密集區有利於渦旋發展。
  8. The performance of catalyst beds was experimentally studied. the influence on decomposition was investigated with changing the mass flux through the cross of the catalyst bed and the initial temperature of the catalyst bed. the experimental results were compared with those of the numerical simulation

    對過氧化氫催化床的催化性能進行了試驗研究,分析了催化床床載、催化床初始溫度對過氧化氫催化分解的影響,與一維情況下的數值模擬結果進行了對比。
  9. Based on the temperature field obtained by the thermal analysis, a parametric analysis is conducted to investigate the interlaminar stress at the interface between the composite and the thermal barrier in the cross - section of the inlet duct, using the commercial finite element software ansys

    在熱分析的基礎上,採用ansys有限元軟體計算了復合材料進氣道截面在假設工況下的應力場,為碳纖維纏繞復合材料進氣道熱防護方案的設計提供了實用的參考依據。
  10. Based on the review, the fluid flow and heat transfer in the curved circular and rectangular pipes have been researched by employing perturbation method and numerical simulation with a physical model under the rotational orthogonal curvilinear coordinate in a rotating curvilinear pipe with multi - parameters. we firstly analyzed the fully developed fluid flow and heat transfer, mixed convection heat transfer, the development of flow and heat transfer in the inlet in different cross section ( circular, elliptical, annular and rectangular crossection ). the variations of the secondary flow, axial velocity, distribution of temperature, the friction force on the wall, the ratio of friction factor as well as the nusselt number with different dimensionless parameters had been examined in detailed

    本文在總結和分析了一個世紀以來有關曲線管道流動和換熱特性的研究成果的基礎上,以旋轉正交曲線坐標系統下的多參數旋轉螺旋管道中的對流傳熱為物理模型,通過攝動方法和有限體積法,首次對各種截面(圓截面、橢圓截面、環形截面、矩形截面)旋轉曲線管道內充分發展流動的流動結構和傳熱特性(包括耦合對流傳熱特性)以及旋轉曲線管道開口段發展流動的流動結構和換熱特性進行了系統的數值模擬和理論分析,詳細討論了各種無量綱參數對管道內軸向速度分佈、二次流結構、溫度分佈、壁面摩擦力、摩擦系數比以及管道nusselt數的影響,獲得了若干創新性成果。
  11. Making sensitive material : made in non - sulfur vulcanization system with the formula : epdm 100kg, dicumylperoxide ( dcp ) 2kg as cross - linking agent, stearic acid 1kg as processing aid, oxidized zinc ( zno ) 3kg as accelerant, wax oil 10kg as lubricant ; and made in vulcanizing condition : vulcanizing temperature 170 c, vulcanizing time 15minutes, vulcanizing pressure 3 mpa, the vulcanized epdm is optimal sensitive material for petrol. the sensing head equipped with the vulcanized rubber possesses two qualities : better swelling response and better anti - interfere against temperature variation

    敏感材料的制備:用無硫硫化體系;配方為:生膠100kg , dcp2kg ,硬脂酸1kg , zno3kg ,石蠟油10kg ;硫化條件:硫化溫度170 ,硫化時間15分鐘,硫化壓力3mpa ,制備的硫化橡膠對汽油的監測較理想,用其裝備的傳感頭不僅有較好的溶脹響應性能,而且有很好的抗溫變干擾能力。
  12. Zirconium alloys are employed extensively in light water cooled reactors ( lwr ) as the cladding materials of fuel elements and other structural materials because of the low capture cross - section for thermal neutrons, good resistance to water - side corrosion at elevated temperature, adequate mechanical properties and high thermal conductivity

    由於鋯的熱中子吸收截面小,並具有優異的耐高溫水腐蝕性能、良好的綜合力學性能和理想的熱導率,因此,鋯合金被用作核電站水冷動力堆核燃料元件的包殼材料和堆芯的其它結構材料。
  13. The temperature drops to - 30 and very few people attempt to cross the pass

    溫度降到了零下30攝氏度,很少有人試圖穿越關口。
  14. On this condition, based on the experimental results gotten by the microwave absorption dielectric - spectrum measure technique, the photographic process at room temperature in agcl cubic microcrystals doped with k4fe ( cn ) 6 is simulated. through the optimization of simulating parameters, not only the cross - section and trap depth of the shallow electron trap induced by the dopant, but also the optimal doping amount is obtained

    在此基礎上,以微波吸收介電譜檢測技術的實驗結果為依據,對摻有k _ 4fe ( cn ) _ 6的agcl立方體微晶在室溫下的曝光過程進行了模擬,通過調節模擬參數,不但計算出由摻雜劑引入的淺電子陷阱的俘獲截面和陷阱深度,而且得到了這種摻雜乳劑的最佳摻雜濃度。
  15. Based on the wall temperature of hollow wire, the further calculation program has been given. it account for the complexity of the stator ' s structure and can be used in the calculation of the temperature distributions in arbitrary cross section of windings

    在空心導線壁溫分佈計算方法確立的基礎上,充分考慮到定子線棒結構的復雜性,採用有限差分的方法編制了通用性較強的線棒截面溫度分佈計算程序。
  16. Experimental study on temperature dependence of ultraviolet absorption cross - sections of sulfur dioxide

    2紫外吸收截面溫變規律實驗研究
  17. Due to the dual - fbgs differential measurement structure, the problem of temperature - strain cross - sensitivity on the pressure sensor is improved ; and furthermore, the sensitivity of the sensor is increased theoretically

    該結構的壓力傳感器採用雙光柵差動結構,在提高檢測靈敏度的同時,實現了溫度的自補償。
  18. 4 cross - sectional areas of connections and their corresponding testing current for temperature rise test is shown in table 4 ( the cross - sectional areas of connections externally wired by user should not be less than those in the table )

    溫升試驗用連接導線截面積與相應的試驗電流見表4 (用戶外接導線或銅排的截面積應不小於表中數據) 。
  19. The numerical results show that the nature frequencies of the structure are affected by the temperature effect, boundary conditions and the number or orientations of layers ; the proper orientations can change the nature frequencies ; the effect degree on the nature frequencies of cross - ply laminated cylindrical shell is different from that of the antisymmetric one

    結果表明,溫度效應、邊界約束、鋪層層數顯著影響結構的固有頻率,適當的鋪層角度會改變結構的固有頻率,不同的鋪層方式對結構固有頻率影響程度不同。
  20. Chapter four studies the cross sensitivity of strain and temperature effect, and introduces the current temperature and strain separation methods. two methods are put forward and experimented, showing that both two methods could be used under engineering conditions

    本文的第四章研究了光纖布拉格光柵的應變和溫度交叉敏感特性,討論了常用的應變/溫度分離方法,並分析了這些方法中存在的問題,提出了相應的解決思路。
分享友人