three wire circuit 中文意思是什麼
three wire circuit
解釋
三線電路-
The three - phase four - wire circuit should be adopted for the outgoing cable used by user, the earth wire should be installed, and the connection wire should be stable, safe, and reliable
用戶使用的引出電纜線，應採用三相四線形式，應安裝接地線，接線應牢固，安全可靠。 -
This paper describes mainly system functions, measuring methods, circuit design, software program and errors analysis of a new type of measuring instrument. this instrument can measure and monitor electric parameters in single - phase circuits, three - phase ( three - wire or four - wire ) circuits. this system can be applied to electric devices and power plants, transformer substations with harmonic pollution. it can measure current, voltage, power, energy, frequence, power factor etc. it also can detect load quality, phase sequence, alarm, display and print results, as well as detect and dispose negative power
該儀器適用於含有諧波污染情況下的機電設備現場、發電廠、供電局、企業變電所現場，可用來測量電流、電壓、有功功率、無功功率、視在功率、有功電能、無功電能、視在電能以及頻率和功率因數等電參數，並具有負載性質（感性、容性）判別，正、逆相序判別指示功能；超限報警功能；列印記錄功能和負功檢測及處理功能。 -
This can fully consider the effect of the structure of transmission line and the selection of lighting parameter etc. by calculating and analyzing various of factor that affect the lightning tripping probability of 500kv double circuit transmission line, we can draw the conclusions : the result by intersecting method is more accord with the practicality circumstance than by existing standard methods, using unbalance high insulation and reverse sequence of wire can reduce the contemporary outage rate of double circuit line, reducing the footing resistance is one of the most efficiency method to reduce the back stroking rate of double circuit transmission line, the double back stroking rate and the single back stroking rate will fall by three ground wire, when the footing resistance is 10 ohm, the back stroking rate by three ground wire is 83 percent of by two ground wire
在分析輸電線路繞擊耐雷性能時，對線路的雷電屏蔽問題進行了分析，提出對擊距法進行改進，充分考慮了風速的影響因素，編寫了具有工程實用價值的計算線路繞擊耐雷水平的程序，此方法可以充分考慮線路結構和雷電參數等對繞擊率的影響。通過對影響500kv同桿雙回線路雷擊跳閘率的各種因素進行了計算和分析，得到以下結論：採用相交法的計算結果比定義法更符合實際運行情況。採用不平衡高絕緣方式和導線逆相序排列可以大大降低雙回同時跳閘率。 -
The fitness of four negative electrode materials such as al, fe, zn, cd, and of six membranes materials : microfiber glass mat separator, polyethylene, polypropylene, polyvinyl chloride, vinylon, soapnated cellulose acetate, and of four current collects : carbon fiber ; nickel foam ; nickel foam sthongthened by iron wire net, punched silver grid in the super - iron alkaline batteries was comparatively studied. the influence of two storaged method ( with and without electrolyte ) and two impurities ( zno, fe ( oh ) 3 ) to the experiment cell ' s self - discharge nature was also comparatively studied. at last, the nature of discharge. structure and electrochemistry of experimental cell with k2feo4 as cathode active material prepared by three different methods : high temperature reaction, hypochlorite oxidizing and electrolysis, was comparative ly studied. we can conclude : i ) the open - circuit potential and the flat of work potential and the percent of capacity of k2feo4 till 1. 0v during the discharge at constant load of experimental cells decreased by the order of al / k2feo4, zn / k2feo4, cd / k2feo4, fe / k2feo4. as for the nature of charge - discharge cycle, cd / k2feo4 fe / k2feo4 zn / k2feo4. in water solute electrolyte, although al / k2feo4 can n ' t be used as storage battery, it have great potential as primary cell or storage cell from the aspect of its discharge capacity. discharge power
採用組裝實驗電池、 x -射線衍射（ xrd ）和循環伏安（ cv ）的方法，從實驗電池的放電特性、充放電循環特性、自放電特性，不同高鐵酸鹽的結構特性和電化學特性幾個方面，對4種金屬負極材料（ al 、 fe 、 zn 、 cd ） 、 6種隔膜材料（復合玻璃纖維、幅射接枝聚乙烯、改性聚丙烯、聚氯乙烯、維尼綸無紡布、皂化再生纖維素） 、 4種集流體材料（泡沫鎳、以鐵網為加強層的泡沫鎳、切拉銀網、炭纖維編織網）在堿性高鐵電池中的適用性進行了比較研究；對2種雜質組分（ zno 、 fe （ oh ） _ 3 ）和2類不同貯存方式（干、濕）對實驗電池自放電特性的影響進行了比較研究；對3種方法（高溫固相反應、次氯酸鹽氧化、直流電解）所制k _ 2feo _ 4的實驗電池的放電特性、結構特性和電化學性能進行了比較研究。 -
They are voltage to digit data converting circuit board, current to digit data converting circuit board and digit data input / output circuit board. these circuit boards are used to acquire the main running parameter of hev experimental bed and to control the output of alarm message. in order to simplify the wire connection and signal conditioning, three piece of interface circuit boards correspondence to the three data acquisition circuit boards are equipped, and a wire connection box is also designed to contain them
本文監控系統的硬體以一臺工業控制pc機為核心並根據採集信號的性質配置了電壓-數字量轉換板、電流-數字量轉換板及數字量輸出輸出板，對hev運行系統的主要運行參數進行採集並進行報警控制；為方便接線和信號調理，配備了與採集板對應的接線和調理介面板以及接線盒。 -
Main circuit structure and control of the active power filter for three - phase four - wire system
三相四線制有源電力濾波器主電路的結構形式與控制
分享友人