time-out value 中文意思是什麼
time-out value
解釋
逾時值-
If the time - out value for a session is too short for the regular responsiveness of either partner, false failures can occur
如果會話的超時值太短而不能使任一夥伴做出正常響應,則會產生錯誤故障。 -
You also can provide a time - out value for the event rule action
還可以提供事件規則操作的超時值。 -
The time - out value for a manual test is infinite
手動測試的超時值為「無限」 。 -
You cannot override the test - run time - out value
不能重寫測試運行的超時值。 -
Gets and sets the request time - out value in seconds
獲取和設置請求超時值(以秒計) 。 -
If you receive time - out errors when attempting to upgrade an instance of notification services, set a longer time - out value
如果在試圖升級notification services實例時收到超時錯誤,請設置更長的超時值。 -
The test - run time - out value is unaffected
測試運行超時值不受影響。 -
If you do not specify a time - out value, the default is used
如果未指定超時值,則使用默認值。 -
To change the time - out value high - safety mode only use the
若要更改超時值,請使用alter database -
The read time - out value is less than or equal to zero and not equal to
讀取的超時值小於零且不等於 -
A zero value indicates no time - out value
零值表示無超時值。 -
This overload allows you to specify a time - out value for the operation and control fragmentation and time - to - live values for the icmp packet
此重載允許您指定操作的超時值,並控制icmp數據包的碎片和生存時間值。 -
This overload allows you to specify a time - out value for the operation and control fragmentation and time - to - live values for the icmp echo message packet
此重載允許您指定操作的超時值,並控制icmp回顯消息數據包的碎片和生存時間值。 -
If you do not specify a transaction time - out value, the computer s system wide time - out value is used
如果不指定事務超時值,則使用計算機的整個系統范圍的超時值。 -
This event occurs only in situations where the lock time - out value is greater than zero
僅在鎖超時值大於零的情況下才會發生此類事件。 -
Structure might expect to set the time - out value to zero to suppress time - outs. to suppress time - outs with the
此值可以設置為0以立即從寫入操作返回,或設置為任意正值,也可以設置為默認的 -
Gets the minimum retransmission time - out value for transmission control protocol segments
獲取傳輸控制協議( tcp )段的最小重新傳輸超時值。 -
Gets the maximum retransmission time - out value for transmission control protocol segments
獲取傳輸控制協議( tcp )段的最大重新傳輸超時值。 -
Method will block until data is available, unless a time - out value was set by using
方法將一直處于阻止狀態,直到數據可用,除非使用 -
The actual time out value may vary from the specified
開關指定的值時,才報告嚴重級別。
分享友人