uniformly distributed 中文意思是什麼
-
The arsenic atoms will be uniformly distributed throughout the crystal when the sample solidifies.
當樣品凝固時，砷原子將在整個晶體中均勻分佈。 -
Characteristic value of uniformly distributed live load
均布活標載標準值14 -
Equivalent uniformly distributed live load
等效均布活荷載14 -
Analytical solution of the bending problem of piezoelectricity cantilever beam under uniformly distributed loading
均勻分佈荷載作用下壓電懸臂梁彎曲問題解析解 -
Facilitating the configuration of protocol parameters, optimization of protocol operations, and more exact estimation of protocol performance, etc. basing on combinatorial theory and asymptotic method, we analyzed the properties of manets with nodes uniformly distributed in rectangular region. mathematical formulas of some basic properties of manets are obtained, such as the expected number of wireless links, mean node degree, the relation between network connectivity and radio range
因此本文第二章基於組合學方法和極限思想研究了矩形區域內節點均勻分佈的無線自組網的幾項基本屬性，網路中鏈路總數的期望值，網路中節點度數分佈情況，以及網路連通性與無線信號傳輸半徑的關系等，得出了其解析描述。 -
Magnetorheological fluid is an intellectual material with good prospect, usually composed of mother fluid that ca n ' t transmit magnet and uniformly distributed magnetic micro granules in it
磁流變液是一種具有發展前景的智能材料，通常由不導磁的母液和均勻散布其中的磁性微粒組成。 -
The subject of investigation in the paper could make up the deficiency of the beams under loading combined antisymmetric end moments with transverse uniformly distributed load, and supported the reference for researchers and designers in the field
本文還分析了影響受彎構件整體失穩的幾種主要因素，特別是通過大擾度理論分析了「短縮」效應對梁整體穩定的影響，這一影響因素在一般的文獻中很少提及，從而使得這方面研究更加全面。 -
It is the low wall built along one side of, or, all around the perimeter of a flat roof, where it may modify the wind flow over the roof so that the pressure on it is more uniformly distributed
它是建築在平屋頂的一邊或周邊上的矮墻，可以調整屋頂的風流以使屋頂壓力更趨均勻分佈。 -
A concept named modified or generalized simply supported edges is therefore introduced, i. e., superimposing altogether the solutions to the rectangular plate with four simply supported edges on which the uniformly distributed load locally acts, to the rectangular plate with four simply supported edges of which one of them is under the action of distributed bending moment and to the rectangular plate with various generalized simple supported edges and then taking the continuity condition of boundary, so as to let the result of superimposition satisfies all boundary conditions, an analytic solution is given to the rectangular overhanging plates on which any kinds of loads are acting
使用了變相的或廣義簡支邊的概念，將四周簡支局部作用分佈載荷矩形板的解、四周簡支一邊作用分佈彎矩矩形板的解及各種具有廣義簡支邊的矩形板的解進行疊加，並應用邊界連續性條件，令這樣的解滿足所有邊界條件，得到了任意載荷作用下矩形外伸板的解析解。 -
Abstract : in the practical engineering, the reinforcement concre te bending members with round section are often met and in current standard only the method of calculation of reinforcement uniformly distributed along circ le is adopted
文摘:實際工程中經常會用到圓形截面的鋼筋混凝土受彎構件，現行規范採用的是沿周邊均勻配置縱筋的計算方法。 -
Many recent researches have indicated that the contact pressure between tire and pavement is highly complex. it is different from the uniformly distributed vertical stress distributions traditionally used for pavement analysis
輪胎與路面間的接觸壓力具有很明顯的非均布性，並不同與傳統的路面結構分析中的圓形均布荷載。 -
Conclusion it can be concluded that the not uniformly distributed occlusal force produced from the larger axial gradient degree, the defect of dentition, and the abrasion of teeth, may be the important factors which cause wedge - shaped teeth defect
結論研究結果說明，牙軸傾度增大、牙列不完整和牙齒磨損導致的（牙合）力異常分佈，可能是楔狀缺損形成和發展的主要因素。 -
Thermally induced phase separation ( tips ) technique was utilized to fabricate biodegradable cp / plla scaffolds which are capable of applying in tissue engineering. it is a good and simple method to make 3d interconnected porous material. ideally, bone scaffold should have high porosity and uniformly distributed pores with more than 50 m better between 100 ~ 300 m to provide adequate space for cell seeding or growth while tips generally produces small pores of ~ 20 m
該方法較其他制備多孔材料的特點是可以得到三維連通的材料，工藝較為簡單，但相分離法一般得到的多孔材料的孔徑較小（ 20 m左右） ，而骨組織工程用的多孔支架材料需要的孔徑在50 m以上，最好在100 300 m之間。 -
Firstly the method of rayleigh - ritz and galerkin were adopted to analyze the beams under loading combined antisymmetric end moments with transverse uniformly distributed load theoretically, and the results were compared with that offered by kirby, p. a and nethercot, d. a, it showed that result was approximate and even lower and so to some extent the approach used in the paper is practice. secondly several principal factors that affect the beam stability were analyzed respectively, especially the shortening effect was mentioned scarely in some literature so far. at last, the author adopted the matlab to program the finite element software to analyze numerically, the results derived from it were agreed well with it
本文分別採用了rayleigh - ritz法和galerkin法從理論上分析了反對稱端彎矩及橫向均布載共同作用下樑的等效彎矩系數，並與kirby ， p . a和nethercot ， d . a分析結果進行對比，結果表明本文採用的方法得出的等效彎矩系數與其得出結果比較，在均布荷載與端彎矩比例相差不大時基本接近或偏小，說明此方法是可行的，而當均布荷載與端彎矩比例較大時，應根據均布荷載作用進行彎矩等效方法來計算。 -
During this paper, definition of the measure enter - cover - probability is given, andthree - dimension detection space are transformed to level detection circles on differentheights. aiming at the most normal situation of symmetric line, cross - to line and cross - awayline taken by the carrier, probablely - enter - cover - target - distribution are analysed in relativemovement method on the premise that targets fly perpendicular to the flying direction of thecarrier. mont - cario method is used to simulate uniformly - distributed - targets situation and getthe measure, and results are used to analyse the influence of line - landscape - orientation - ratio, line - portrait - ratio, and speed - ratio on the measure. for further research, influences of height and blind space are also discussed on base ofradar level detection range, and situations of non - uniformly - distributed targets are alsoresearched
為了分析主動探測空間動態性能，本文首先提出以「目標進入雷達覆蓋區概率」 （簡稱為「覆蓋率」 ）作為評價指標;然後將三維探測空間轉換為不同高度層對應的水平探測圓，針對載機採用雙平行航線、交叉相向航線和交叉同向航線的最一般情形，採用相對運動的方法，分析目標垂直入侵時可能進入雷達覆蓋區的目標分佈情況;再運用蒙特卡洛法進行模擬計算，分析並比較目標服從均勻分佈時航線橫比、航線縱比及速度比對性能的影響。 -
Firstly, with uniaxial symmetrical rectangle cross section, the warping displacement function and tangential displacement function under anti - symmetrical load are supposed. then taking shear deformation into account and with potential principle, the governing differential equation for distortion angle subjected to uniformly distributed distortion load is established
首先，以單軸對稱矩形截面薄壁桿件為研究對象，假設其在反對稱荷載作用下翹曲位移和切向位移的分佈函數，考慮剪切變形的影響，利用最小勢能原理建立單位均布畸變荷載作用下的畸變角微分方程。 -
Based on the initial parameters format of the distortion theory in this paper, the element stiffness matrix and the corresponding equivalent nodal force vector subjected to uniformly distributed load is developed
在初參數格式的基礎上，本文又推導出考慮剪切變形的畸變分析的剛度矩陣及等效節點載荷列陣，獲得便於實際應用的畸變分析剛度法。 -
Based on the theories of nonlinear finite element monte - carlo stimulation techniques, mathematical methods for generating uniformly distributed n ( 0, 1 ) random numbers are described. a comprehensive evaluation method for uniformly distributed random number is presented. some good seeds have been selected out that can be used to generate uniformly distributed random sequences with better performance
本文以非線性有限元理論和蒙特卡洛隨機模擬理論為基礎，描述了均勻分佈的n （ 0 ， 1 ）隨機數產生的數學方法，並編制了計算機程序，對由軟體產生的均勻分佈序列的隨機數性能進行各種檢驗，檢驗成果是良好的，可用於產生各種概率分佈的隨機變量值。 -
As the rise of a spherical shell with uniform thickness is 6052 times of its thickness, upper critical load of the shell subjected to uniformly distributed load was investigated, and the convergent result was still derived
在均布荷載作用下，等厚度球殼的矢高為其厚度的6052倍時，對上臨界荷載的計算仍取得了收斂的數值結果。 -
Stress distribution at cross section of transverse uniformly distributed load and non - uniformly distributed load applied to concrete cylinder by finite element method is analyzed
摘要採用有限元的方法計算分析了混凝土圓柱體在受橫向均勻線荷載和非均勻線荷載時其橫截面上的應力狀況。
分享友人