vibration of beam 中文意思是什麼

vibration of beam 解釋
梁的振動
  • vibration : n. 1. 振動,顫動;擺動;【物理學】振動。2. (心的)震顫。3. (思想情緒的)激動。4. 猶豫。adj. -al
  • of : OF =Old French 古法語。
  • beam : n 1 梁,棟梁,桁條;(船的)橫梁。2 船幅;(動物、人的)體幅。3 (秤)桿,杠桿,(織機的)卷軸,...
  1. Across the rigid - flexible coupling dynamic analysis, we acquired the coupled effects between the three - dimensional attitude motion of the satellite and the flexible vibration of the antenna ' s supporting beam, and got the dynamic behaviors of the system. and we found the change pattern of the antenna ' s structure parameters, which decide the system ' s connatural characteristic and its dynamic response

    通過對衛星?天線形成的剛柔耦合系統進行動力學分析,獲得了衛星的剛體運動與天線的彈性振動之間的耦合影響規律及其真實的動力學行為,得到了天線結構參數對衛星?天線系統的固有特性及其動力學響應的影響規律,為衛星姿態控制和天線結構優化設計奠定了基礎。
  2. Part 2 analyses beam landing shifts made by thermal deformations of a shadow mask and vibration of a new type of shadow mask - aperture grille. an automatic measurement system for cpt decolorization and a vibration measurement system for aperture grille are established. part 3 analyses the difference of perception and discrimination to color between the human eyes and ccd system, and develops a new method based on ccd technology to evaluate the screen white - balance

    主要內容分為三部分: ( 1 )分析著屏電子束分佈與電子槍、偏轉系統及蔭罩之間的關系,研製自動測試裝置,為設計和改進相關結構提供依據; ( 2 )分析蔭罩熱變形和振動對顯示屏色純度影響,建立了色純漂移自動測試裝置和張緊式蔭罩振動測試系統; ( 3 )分析了人眼與ccd對彩色刺激的不同響應,建立了基於ccd的顯示器全屏色純均勻性測試方法。
  3. The main beam of type 4sw - 40 potato digger easily engenders crack or breaking damage in the practical application. therefore, by means of modern test technology, the paper does some research on the vibration of the separating sieve and its influence on dynamic load of the main beam under the condition of laboratory

    4sw ? 40型馬鈴薯挖掘機在實際生產中主粱易出現裂紋或斷裂破壞。為此,本文提出在實驗室條件下,利用現代測試技術,就分離篩的振動及其對主梁的動載作用作研究。
  4. In this paper, at the cut - in spot of beam active vibration control and use the pzt material as the drive component, the main research works can be summarized as follows : 1 ) using the finite element theory, a general finite element formulation of piezoelectric media is derived, the direct and converse piezoelectric effects are considered in the formulation

    本文從梁的振動主動控制研究為切入點,利用了pzt材料作為驅動元件,作了如下幾個方面的研究: 1 )利用有限元理論,考慮壓電材料的正、逆壓電效應的影響,導出了機電耦合壓電元件的有限元方程。
  5. The beam - on - dynamic - winkler - foundation ( bdwf ) model was utilized to determine the lateral dynamic response of a pile with finite length in a viscoelastic soil. an analytical solution was obtained in the time domain for the vibration of a pile under a laterally cyclic force applied at the pile head. based on the solution, the transient response of the pile loaded by semi - sine force was acquired with superposition principle

    首先,基於動力winkler模型( bdwf )對粘彈性地基中有限長樁的水平動力響應問題進行求解,得到了單樁在樁頂受水平簡諧荷載作用下的時域解析解,並在此基礎上通過疊加原理得到了半正弦激振條件下的瞬態解析解。
  6. M. a. heckl. investigation on the vibration of grillages and other simple beam structure. journal of the acoustical societ of america 36, 1964 : 1335 - 1343

    陳正翔,江松青,張維衡.無限長輸液管中結構振動波的傳播.華中理工大學學報, 1997 ( 11 )
  7. 2 ) the value of base frequency, which is the first order vertical - bending vibration, is bigger in box girder bridges than those of t - beams. it shows that the vibration performance of box girder bridge is better than t - beams. 3 ) when considering the shear deformation of beam, the vibration frequency calculated by is bigger than those not considering the shear deformation

    T型梁的基頻為橫向振動,而整體箱梁的基頻為豎向彎曲振動;整體箱梁的一階豎彎振動的頻率比t型梁得到了提高;整體箱梁的動力性能優于t型梁;考慮剪切變形后,梁的自振頻率降低,對于整體箱梁其降低值接近於5 ,在分析時不應忽略。
  8. Vibration analysis of beam using continuous element methods

    梁結構振動分析的連續單元法
  9. Fabrication of the box beam is divided into such parts as reinforcement, formwork, concreting, prestressing, moving and storing of beam, pipe grouting under pressure, end sealing of the beam, water - proof layer on the bridge surface system, protective coating etc. the paper makes description of effective box beam construction technology and workmanship which can be adopted in other projects, such technologies as : manufacturing and fixing of reinforcement, steel reinforcement fixing baseplate, web plate and top plate respectively and lifting the steel skeleton into form, requirements of design and manufacturing and way of utilization for dismantling - erection type formwork and hydraulic formwork, optimization of concrete ratio, concrete pouring process of two ends of beam in priority over the middle, in sequence of first baseplate followed by web plate and top plate at last, concrete pouring in inclined section and in horizontal layer, concrete vibration mainly by external vibrator in assistance with internal vibrator, methods and regulation for steam curing of concrete, dual controls over stress and strain to ensure quality of prestressing workmanship, construction method of effective beam moving by heavy - weight special moving facility, some regulations and key notes about construction of grouting under pressure, beam ends sealing, water - proof layer on the bridge surface system, protective coating

    箱梁製造由鋼筋工程、模板工程、混凝土工程、預應力工程、移存梁工程、孔道壓漿工程、梁體封端工程、橋面防水層和保護層工程等施工環節組成。文中介紹的採用胎具製作和綁扎鋼筋,分底腹板和頂板分別綁扎並吊裝鋼筋骨架入模;拆裝式和液壓式兩種模板的設計、製作要求和使用方法;綜合考慮、優化混凝土配合比,混凝土灌注從兩端至中間、先底板、后腹板、再頂板的施工順序和斜向分段、腹板水平分層、附著式振搗為主、插入式搗固為輔的施工工藝,蒸汽養護的方法和規定;應力應變雙控制確保預應力施工質量的施工技術;採用重物移運器有效移梁的施工方法;壓漿、封端、橋面防水層和保護層施工的一些規定和注意事項等都是對箱梁製造行之有效的施工技術和施工方法,並可為以後類似施工作借鑒。
  10. Based on the perturbation riccati transfer matrix method, the calculating program are developed. the program can be used to the perturbation analysis and the sensitivity analysis of the real and complex, the single and repeated eigenvalues and eigenvectors for lateral vibration of rod and beam structures, especially suitable to the perturbation analysis and the sensitivity analysis of eigenvalues and eigenvectors for rotordynamic systems ; 2. the perturbation riccati transfer matrix method was applied to identify the parameters of the rotor for a boiler supply pump, and the accurate dynamic model of the rotor was archived

    該程序可以對桿、梁結構橫向彎曲振動的實數、復數的孤立和重頻特徵值問題進行攝動分析和靈敏度分析,特別是適合於轉子動力學系統特徵值和特徵向量問題的攝動分析和靈敏度分析; 2 、用攝動riccati傳遞矩陣方法解決了某電站鍋爐給水泵轉子的參數識別及動力模型修改的問題,並給出了該種型號的給水泵轉子的更準確的力學模型,為進一步的轉子動力學分析與設計奠定了可靠基礎; 3 、給出了攝動理論在相關領域如隨機特徵值分析、隨機振動響應分析、可靠性分析、靈敏度分析、優化設計以及參數識別中的應用公式。
  11. The method of using the tip of atomic force microscopy and beam - deflection to on - line detect the nanometer vibration of the particle in the saw is introduced, and the saw amplitude of 6. 7 nm is measured when a driving voltage of 3. 5 v is applied

    並用這種方法在激振電壓峰峰值為3 . 5v時,對壓電材料linbo _ 3表面彈性波進行了實時測量,得到表面彈性波振幅約為6 . 7nm 。
  12. Transverse vibration of an axially moving beam with fixed support by wave propagation

    波傳播法分析兩端固支軸向運動梁的橫向振動
  13. Analysis of the natural lateral vibration of beam carrying electric current in magnetic field

    載流梁在磁場中的橫向固有振動分析
  14. Piezoelectric elements were pasted on / under the cantilever beam where stress was the maximum or sub - maximum as actuators to control the vibration of the cantilever beam

    在懸臂梁振動時應力最大或次最大處的上、下表面同位元配置壓電片,作為抑制懸臂梁振動的致動器。
  15. Negative mode velocity feedback was adopted and the control voltage applied to each piezoelectric element acting as actuator was calculated to control the vibration of the beam

    採用模態速度負反饋進行回饋控制,以此計算出各個作為致動器的壓電片的控制電壓,以抑制懸臂梁的振動。
  16. Simulation results show that the vibration of the beam can be suppressed rapidly by applying voltage to the piezoelectric patches displaced in this way, and single mode vibration and multi - mode vibration can be controlled simultaneously

    通過算例進行數值模擬,結果表明,以此方法布置壓電片和輸人控制電壓,能迅速抑制懸臂梁的振動,可單獨或同時控制幾階模態振動。
  17. Study on beam - type dynamic vibration absorber for reducing vibration of a thin panel

    梁式動力吸振器用於抑制薄板振動的研究
  18. Influence of combined modes of piezoelectric ceramics on flexural vibration of a beam

    壓電陶瓷的組合結構對直梁彎曲模態的影響
  19. According to the finite element method result, the parametric vibration of cables in cable - stayed arch bridge becomes prone to be exhibited. then a model of non - linear parametric excitation vibration coupling the stayed cable and the girder, namely, the mode of cable - stayed beam, is proposed in the thesis. and the nonlinear dynamical

    3 、首先利用有限元分析方法,得出了斜拉索發生參數共振的可能,然後建立了斜拉拱橋拉索-橋面耦合參數振動模型,即索-梁組合結構模型,推導了索-梁組合結構非線性運動方程,利用多尺度方法研究斜拉索的參數共振和亞諧波共振,並對穩態解的穩定性進行了分析。
  20. Vibration of beam

    梁的振動
分享友人