yield test results 中文意思是什麼

yield test results 解釋
凈毛率檢驗結果
  • yield : vt 1 生出，產生（作物、報酬、利益等）。2 給與，讓與；讓渡；放棄（權利、地位等）；交出。3 承認。4 ...
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  • results : 調查結果
  1. Aimed at solving the problem that high content of unburned carbon is unfavourable for the comprehensive ultilization in scale of fly ash, the fundamental principle that separation of unburned carbon from fly ash is theoretically analyzed by wet flotation and dry electro - separation, three factors and two levels orthogonal test for flotation and two factors and three levels test for electro - separation were conducted, furthermore, the primary factors and law affecting separating efficiency in flotation and electro - separation were obtained. the results show that wet flotation can give 7. 34 % of the cleaned coal yield rate, which contains 44. 53 % of ash content and 56. 02 % of separating efficiency, while dry electro - separation can reduce the content of carbon in separated fly ash to 3. 16 % and remove 53. 12 % of carbon from fly ash

    針未燃炭含量過高不利對粉煤灰大規模綜合利用的問題，從理論上分析了粉煤灰濕法浮選和干法電選分選未燃炭的基本原理，進行了三因素二水平正交浮選試驗和二因素三水平的正交電選試驗研究，得到了影響浮選和電選分選效果的主要因素及其規律.試驗表明:採用濕法浮選法可獲得精煤產率為7 . 34 % ，灰分為44 . 53 % ，分選效率為56 . 02 %的分選效果；採用干法電選，選后粉煤灰的含碳量可降到3 . 16 % ，脫碳率達53 . 12 %
  2. Abstract : aimed at solving the problem that high content of unburned carbon is unfavourable for the comprehensive ultilization in scale of fly ash, the fundamental principle that separation of unburned carbon from fly ash is theoretically analyzed by wet flotation and dry electro - separation, three factors and two levels orthogonal test for flotation and two factors and three levels test for electro - separation were conducted, furthermore, the primary factors and law affecting separating efficiency in flotation and electro - separation were obtained. the results show that wet flotation can give 7. 34 % of the cleaned coal yield rate, which contains 44. 53 % of ash content and 56. 02 % of separating efficiency, while dry electro - separation can reduce the content of carbon in separated fly ash to 3. 16 % and remove 53. 12 % of carbon from fly ash

    文摘:針未燃炭含量過高不利對粉煤灰大規模綜合利用的問題，從理論上分析了粉煤灰濕法浮選和干法電選分選未燃炭的基本原理，進行了三因素二水平正交浮選試驗和二因素三水平的正交電選試驗研究，得到了影響浮選和電選分選效果的主要因素及其規律.試驗表明:採用濕法浮選法可獲得精煤產率為7 . 34 % ，灰分為44 . 53 % ，分選效率為56 . 02 %的分選效果；採用干法電選，選后粉煤灰的含碳量可降到3 . 16 % ，脫碳率達53 . 12 %
  3. Through comparing and analyzing of bearing capacity, development of crack and strain of reinforced, the results show that the load - deflection plots f or specimens from the finite element analysis agree well with the experimental data, and choosing the rightful stress - strain relationship, utilizing ansys program, the test process can be well simulated. at the same time, making used of the program, the traditional shear wall is analyzed. it shows that comparing with the traditional shear wall, the hollow shear wall ' s cracking load drop 16 %, yield load and failure load drop 13 %, stiffness drop 13 % ~ 22 %

    其次在試驗的基礎上，將試驗手段、有限元數值模擬方法和理論分析結合起來，利用有限元程序ansys對其中的兩片墻板進行非線性有限元分析，並對前後的承載性能，裂縫發展、鋼筋應變進行了比較和分析，結果表明有限元節點模型分析的荷載-位移曲線和試驗測得數據符合良好，選用合理的材料本構模型，利用ansys可以較好的模擬試驗過程；同時利用有限元模型對比分析了普通剪力墻和空心剪力墻，空心剪力墻與普通剪力墻對比，其開裂荷載下降16 ，屈服荷載、極限荷載下降13 ，剛度下降13 22 ，開裂至屈服、屈服至極限荷載階段的剛度衰減規律與普通剪力墻基本一致，空心剪力墻的後期剛度比較穩定。
  4. At first, the experiment carried out by tianjin university has been analysed according to the " nonlinear balance trying calculation " method, and the values of yield load and ultimate load agree with the test result better, and the curve of bending moment - curvature, bending moment - deflection can agree with the results. the second, the simplified formula for evaluation the ultimate flexural capacity of cfrp strengthened rc members is presented according to the three probable failure modes ( compression failure ; cfrp rupture ; crushing of the concrete in compression before yielding of the reinforcing steel ). it is applicable to both singly and doubly reinforced rectangular sections, as well as flanged sections

    首先利用鋼筋混凝土非線性平衡試演算法對天津大學試驗進行了理論分析，所得分析值與試驗結果相比，加固梁的屈服荷載、極限荷載能夠很好地吻合，彎矩曲率關系曲線及彎矩撓度關系曲線較為吻合；其次，為了滿足實際工程的需要，根據碳纖維布加固構件可能發生的三種破壞形態（壓區混凝土壓碎破壞、碳纖維布拉斷破壞以及受拉鋼筋尚未屈服時壓區混凝土已壓碎破壞） ，區別三種鋼筋混凝土構件截面形式（單筋矩形截面、雙筋矩形截面、 t形截面） ，分別給出了碳纖維布加固混凝土構件抗彎承載力的簡化計算公式和適用條件，並進一步探討了這三種截面形式下進行加固設計和復核的步驟。
  5. The results showed that the most of the test varieties had high yield, which was 55. 6 %, but in which they had poor stability so that there was only three varieties as tie93 - 115, 95 fenxuan 3 and chenggu 8 with high and stable yield ability, which was 16. 7 %

    結果表明，參試品種多數產量較高，佔55 . 5 % ，但其中產量穩定性較差的佔多數，高產穩產的品種較少，僅有鐵93 - 115 、 95汾選3和承谷8號，佔16 . 7 % ，其餘的均為低產穩產和低而不穩的類型，各佔22 . 2 % 。
  6. Table 6. describes that the relationship between soil phosphorus and rice yield according to the biometrical results for test of soil phosphorus and their corresponding determination of yield

    表6根據土壤磷及其確定產量試驗的生物統計結果描述了土壤磷和水稻產量之間的關系。
  7. According to the test results of localization and shear bands formation under the consolidated undrained plane strain compression tests on soft clay in shanghai, it was found that the deviator stress of shear band beginning to form was very close to its yield point in clay soils

    摘要根據上海軟土在固結不排水平面應變壓縮試驗條件下應變局部化和剪切帶形成的實測研究結果，發現粘性土剪切帶開始形成的偏應力為其屈服點。
  8. According to the results of wheat variety regional test in huhei province and the fertilizer experiment conducted in wuhan, suizhou and xiangfan, this article reports yield components, population structure, methodology of fertilizing nitrogen and key cultivation techniques of wheat variety zhengmai 9023 in hubei province

    摘要在總結鄭麥9023在湖北省小麥區域試驗及肥料試驗的基礎上，對其產量表現、施肥效果等指標進行統計分析，提出了湖北麥區高產栽培條件下鄭麥9023的產量結構、群體結構及關鍵栽培技術。
  9. On the basis of expounding the effects of plastic deformation behavior and forming limit on the analysis of sheet metal forming, this paper overviews the research progress on yield criterion, hardening model, forming limit and effects of complex loading paths, and obtains that establishing the test method of complex loading paths according with sheet forming characteristics, verifying the accuracy and applicability of theoretical results, and determining the analytic description and practical criterion under complex loading paths, are main research directions in sheet metal forming

    摘要本文在闡述塑性變形行為與成形極限對于解析板料成形過程的作用與意義的基礎上，針對板料屈服準則、強化模型、成形極限及復雜加載路徑的影響規律的研究進展進行了綜述與分析，得出：建立符合實際板料成形特點的復雜加載路徑的實驗方法，驗證理論研究結果的準確程度及適用范圍，確定復雜加載路徑下的解析描述及實用判據，是目前該領域主要的研究方向。
  10. Qtl mapping for the 9 yield traits was carried out using qtlmapper version 1. 0. the main results are as follows : using the combined test of the four environments, 39 qtls of additive effects distributing on 14 chromosomes were detected. the range of general contribution rate of additive effect qtls for different traits is 1. 83 ~ 27. 24 %, and the range of contribution rate of different single qtl is 1. 06 - 8. 93 %

    利用qtlmapperversion1 . 0作圖軟體進行了產量性狀的qtls作圖，主要結果如下：在各環境聯合分析下，共檢測到9個性狀的39個加性效應qtls ，涉及14條染色體，各個性狀的總貢獻率變化范圍為1 . 83 27 . 24 ，單個qtl貢獻率變化范圍為1 . 06 8 . 93 ；共檢測到9個性狀的41對qtls互作位點，涉及用於分析的全部18條染色體，各個性狀的總貢獻率變化范圍為1 . 26 36 . 15 ，單今互作效應的貢獻率變化范圍為1 . 20 13 . 30 。
  11. Applying viscoelastoplastic theory, the modified nishihara model was extended into three dimension, the yield criterion and flow vectors fitting for computing were attained. according finite element theory, the computing method and step of nishihara rheological model was given, numerical simulating of three point bending creep test was performed and the results were coincided with that of test

    運用粘彈塑性基本理論，對改進后的西原流變模型時空離散並拓展到三維空間，給出了適合數值計算的屈服準則和流動矢量求解方法；給出了西原流變模型數值計算基本方法和步驟。
分享友人
分享到 Line

分享到臉書