介質損耗角 的英文怎麼說

中文拼音 [jièzhísǔnhàojiǎo]
介質損耗角 英文
dielectric loss angle
  • 質 : Ⅰ名詞1 （性質; 本質） nature; character; essence 2 （質量） quality 3 （物質） matter; substance;...
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 角 : 角Ⅰ名詞1 （牛、羊、 鹿等頭上長出的堅硬的東西） horn 2 （古時軍中吹的樂器） bugle; horn 3 （形狀像...
  • 損耗 : 1. （損失消耗） loss; wear and tear; deterioration; waste 2. [商業] wastage; spoilage
  1. The measurement of on - line hv capacitive type equipments " tgd can get accurate information of insulation in time, and how to improve the accurate degree of on - line tg is still not solve by efficiency ways at present

    測量介質損耗角tg可以準確反映高壓電容型設備的絕緣變化情況，如何有效提高tg值在線監測的測量準確程度還有待進一步解決。
  2. Test method for dielectric tangent of loss angle of pyroelectric material

    熱釋電材料介質損耗角正切tan的測試方法
  3. Vulcanized rubber - test method for hf dielectric constant and dielectric loss angular tangent

    硫化橡膠高頻介電常數和介質損耗角正切值的測定方法
  4. Vulcanized rubber - determination of dielectric constant and dielectric loss angular tangent value

    硫化橡膠工頻介電常數和介質損耗角正切值的測定方法
  5. Vulcanized rubber - test method for hf dielectric constant and dielectric loss angular tangent value

    硫化橡膠高頻介電常數和介質損耗角正切值的測定方法
  6. Test method for dielectric loss angle tangent and dielectric canstant of organic film for use in capacitors

    電容器用有機薄膜介質損耗角正切值和介電常數試驗方法
  7. Vulcanized rubber - determination for industrial frequency dielectric constant and dielectric loss angular tangent

    硫化橡膠工頻介電常數和介質損耗角正切值的測定方法
  8. Of a dielectric, the product of dielectric constant and the tangent of its dielectric loss angle ; a measure of the heating effect which occurs in dielectrics

    對于電介質來說，它是介電常數和介質損耗角的正切的乘積，這是對出現在電介質中的熱效應的量度。
  9. The product is characteristic of low dielectric largent at high frequency and is self fluxing it ' s suitable to be used as elements and coils of high frequency equipment

    該產品具有在高頻下漆膜的介質損耗角正切小的特性，並且有直焊性，適應高頻電器儀表繞圈和元件。
  10. Based on the rate - equation theory of four - level system, the expressions of threshold pump power, output power and slope efficiency are given. the influence of space distribution of pump light ( the position of focusing point, dimension of pumping light and divergence angle ) to the output characteristics are also discussed. then, by investigating the effects of thermal effect of laser crystal on the size of laser cavity mode, we obtain the mode - matching principle of high power laser diode end - pumped solid - state lasers

    其中，在泵浦光的空間分佈變量中我們分別考慮了泵浦光聚焦后的腰斑大小、聚焦腰斑在增益介質中的位置以及泵浦光在介質中發散角的影響；然後我們研究了在高泵浦功率下激光晶體因吸收泵浦光而產生的熱效應所導致的熱透鏡效應以及熱致衍射損耗，通過分析它們對振蕩激光腔模尺寸的影響，得到了高功率半導體激光二極體端面泵浦固體激光器模式匹配的要求，為高功率連續單頻nd ： yvo _ 4激光器的優化設計提供了理論依據。
  11. Under the condition of rated voltage and 20, the tangent of the loss angle of film - paper capacitor is less than 0. 0008, and that of film dielectric capacitor is less than 0. 0005

    5 .在額定電壓下，溫度20時電容器的損耗角正切值，膜紙復合介質tg0 . 0008全膜介質tg0 . 0005 。
  12. The dielectric constants of silica - rich, alumina - rich, and stoichiometric mullite ceramics are 5. 5, 6. 0 and 6. 3 respectively. the dielectric constant of mullite - si / c / n composites is related with the sintering parameters. with the increase of the sintering temperature and dwelling time, the " " and tg of mullite - si / c / n composites are decreased, this phenomenon is related with the change of the microstructure and phase composition of nano si / c / n powders

    莫來石- si c n復合材料的介電常數與熱壓燒結工藝有很大的關系，隨熱壓燒結溫度（ 1450 1600之間）的升高，燒結時間（燒結溫度為1550 ）的增長，莫來石- si c n復合材料的介電常數實部、虛部及介電損耗角正切均明顯下降，這與吸收劑的性質隨溫度和時間的變化有關。
  13. Test methods for properties of structure ceramic used in electronic components - test method for dielectric loss angle tangent value

    電子元器件結構陶瓷材料性能測試方法介質損耗角正切值的測試方法
  14. Based on detailed analysis about dielectric loss measuring methods, the spectrum analysis method is selected

    在對介質損耗角正切值多種在線監測方法進行詳細分析的基礎上，選中頻域分析法。
分享友人
分享到 Line

分享到臉書