傳質過程 的英文怎麼說

中文拼音 [zhuànzhíguòchéng]
傳質過程 英文
mass transfer process
  • 傳 : 傳名詞1 （解釋經文的著作） commentaries on classics 2 （傳記） biography 3 （敘述歷史故事的作品）...
  • 質 : Ⅰ名詞1 （性質; 本質） nature; character; essence 2 （質量） quality 3 （物質） matter; substance;...
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 過程 : process; procedure; transversion; plication; course
  1. By comparing the dry plate pressures drop and distributions of velocities simulated on single valve with those of double valves, it was found that there was intense turbulence in the flow fields around fixed - valve, there were eddy areas between valve side orifices and tray wall, there were eddies above the valves too, these led to the complex behaviors of gas perforating valve, these had a great effect on the gas - liquid mass transfer process. at the same time, in order to prevent the disadvantageous effect of gas between one valve with another on the gas - liquid mass transfer, it was very effective to change the fields of gas perforating valve by folding the edges of valve

    通過對數值模擬得出的單閥和雙閥塔板的干板壓降及流場速度分佈分析對比后發現，固定閥周圍流場存在較強的湍動，閥側孔與塔板壁面區域以及閥體的上方空間存在明顯的渦流區，使氣體穿閥后的行為變得復雜，並對氣液傳質過程產生重大影響；模擬結果表明，為防止和削弱固定閥間的對沖造成的「死區」對傳質帶來的不利影響，通過折邊來改變氣體的氣路是非常有效的，模擬值與實驗值基本得到吻合。
  2. In general, ba stars belong to binary system, and their heavy - element overabundances are due to the accreting material from the companions ( the former tp - agb stars and the present white dwarfs ). carrying out a series of monte - carlo simulations, the changes of orbital elements of binaries are recalculated for wind accretion scenario of the total angular momentum conservation

    研究表明，鋇星應該屬于雙星系統，其重元素超豐來自雙星吸積，它的伴星已經經歷了s -過程核合成，而且由在以前發生的同其伴星（以前是agb星，現已演化為白矮星）的質量傳輸過程中，從伴星那裡獲得了富含重元素的物質，這樣造成了鋇星的重元素超豐。
  3. Numerical simulation of mass transfer in the cathode of a proton exchange membrane fuel cell with interdigitated gas distributors

    交指型電極的質子交換膜燃料電池陰極內傳質過程的數值模擬
  4. The quasi - steady two - dimension model of brick - drying is established by the analysis of heat and mass transfer of brick - drying

    摘要通過對磚坯乾燥傳熱傳質過程的分析，建立了磚坯乾燥的準穩態二維數學模型。
  5. The carbonization pressure influenced the mass transfer process of pyrolysis products and promoted the secondary reactions, while the activation pressure changed the adsorption equilibriums and reaction rates of the activation reaction

    加壓炭化影響了熱解產物的傳質過程，提高了發生二次反應的機會，而加壓活化能夠影響活化反應的吸附平衡和反應速率。
  6. The first successful industrial application of absorption heat transformer ( aht ) has been put into practice in yanshan petrochemical corporation in china. on the background of this engineering, the thesis sets up the methods of absorber ' s enhanced heat and mass transfer, process simulation and finite time thermodynamics analysis. the main research work is followed as : 1

    本論文以北京燕山石化公司上的國內第一套吸收式熱變換器（ aht ）系統為工程背景和研究對象，建立了包括吸收器強化傳熱傳質、過程模擬和有限時間熱力學在內的分析手段，並在此基礎上開發出了模擬優化軟體ass ，最後利用工廠的實測數據對軟體的計算結果進行了測試和對比，具體工作： 1
  7. In this article, on the basis of evaporation & condensation principle, a research on the heat and mass transfer of liquid dehumidification and seawater desalination was developed

    本文對液體除濕和海水淡化中蒸發冷凝傳熱傳質過程展開了研究。
  8. Abstract : a continuity wave model is put forward for the dispersion processof liquid - liquid two - phase system, by coupling mass and momentum conservation equations of two - fluid model. the conditions that result in a dispersion choke and the weak instability of a dispersion process are derived from the model. the phenomena of catastrophic inversion and transitional inversion are explained. the effect of drop size distribution on the maximum volume concentration of a emulsion is predicted using the model. according to the theory herein, emulsion inversion is the regime transition of liquid - liquid system due to the instablity of a dispersion process. the effect of drop size distribution on the maximum volume concentration of a liquid - liquid emulsion only occurs in a certain range of weber numbers

    文摘:以雙流體模型為基礎，通過質量守恆方程和動量守恆方程的耦合，提出了液-液兩相系中彌散傳質的連續波模型.由該模型得到彌散傳質過程阻塞和彌散傳質過程弱不穩定性產生的條件，計算了液滴尺寸及其分佈對乳化液極大堆砌分數的影響，解釋了劇變型乳化逆變和漸變型乳化逆變現象.研究結果表明，乳化逆變是由於彌散傳質過程的不穩定性而引起的懸浮體型態的改變，隨液滴尺寸多分散性的增大，極大堆砌分數增大；隨液滴平均尺寸的增大，多分散性對極大堆砌分數的影響減弱；當韋伯數足夠大時，液滴尺寸及其分佈對乳化液極大堆砌分數無影響
  9. Presents the study on the cross - effect of heat and mass transfer of capillary porous media a. b. luikov set up on the irreversible thermodynamics principle with the theoretical solution of unsteady drying process given and its validity verified though experiments, and analyses using the mathematical model the influence of all factors on temperature and moisture distribution and the cross - effect of heat and mass transfer during drying processes

    針對雷柯夫建立在不可逆過程熱力學原理上的傳熱與傳質方程組，著重研究毛細多孔介質內傳熱與傳質過程中的交叉效應.得出了非穩態乾燥過程的理論解，並通過實驗驗證了其正確性，利用該模型分析了乾燥過程中各因素對內部溫度場和濕度場的影響以及交叉效應在乾燥過程中的作用
  10. One of the main aspects of research on distillation column with trays is the fluid field and mass transfer on the trays by the method of computational fluid dynamics ( cfd )

    =在蒸餾設備中，板式塔研究的一個重要方面就是應用計算流體力學對塔板上流體流動狀況及傳質過程的研究。
  11. As we all know, the heat transfer of geothermal heat exchanger ( ghe ) is affected by a lot of factors, where groundwater advection has a comparatively great impact indicated by experimental data. while almost all the design tools for ghe are based on principles of heat conduction and rely on some estimate of the ground thermal conductivity and volumetric specific heat. however, the large part of vertical u - type pipe lies in the saturated soil, especially in zones along the coast or with plentiful groundwater, which will be affected by groundwater advection greatly

    但是對於垂直u型埋管來說，管段大部分位於土壤飽和區內，實際上其穿透的地層中總是存在著地下水的滲流，尤其是在沿海（河、湖泊）地區或地下水豐富的地區，埋管的傳熱性能大部分都受到地下水滲流的影響，此時土壤內發生的是熱傳導和地下水滲流共同作用下的復雜的、非穩定的傳熱傳質過程（簡稱熱滲耦合傳熱過程） 。
  12. These theoretical conclusions summarized by the author can provide some referable guides to the reasonable applications of the vertical tube, also thoughtfulness and method could be made use of during studies on the process of multi - component vapor partial film condensation

    本文對雙組分部分膜狀冷凝傳熱傳質過程的結論，可以為垂直管的合理使用提供一定的參考依據，也可以為多組分部分膜狀冷凝過程的研究提供可借鑒的思路和方法。
  13. Based on the analysis of the mass transfer of hydrogen ion, it was proved that the agitation operation was negative as to the improvement of sensitivity of the biosensor

    本文還對h +的傳質過程進行了分析，結果表明攪拌過程會導致傳感器檢測靈敏度的降低。
  14. In this paper, the influence of ultrasound on the solid - liquid extraction and the adsorption phase equilibrium were investigated by using the effective component - geniposide of the mature gardenia fruit as the experimental object

    本文以梔子果實中有效成分梔子甙為實驗對象，研究超聲波對固-液浸取、吸附相平衡、傳質過程的影響。
  15. The finite volume method and the star - cd software are used to compute the fluid flow process and mass transfer process of one tray and for the first time of the whole distillation column ( 10 trays ) under the total reflux. the computed results are as follows : 1. since the previous research did not show the comparison between the computational results and the measured values of 3d fluid field on a distillation tray, attention is paid to present work in this paper

    本文採用有限體積法及計算流體力學軟體「 star - cd 」對單塊板以及首次對全迴流下的全塔（十塊板）流體流動、傳質過程進行了計算，計算結果如下： 1 .泡沫工況下單塊板的流場計算值與solari及bell （ 77 （的實測值吻合較好。
  16. Analysis and enhancement of the heat and mass transfer process in the adsorber of the solid adsorption refrigeration system

    固體吸附式製冷系統中吸附床內的傳熱傳質過程分析和強化
  17. Liquid - liquid extraction, is a process that allows the separation of two or more components due to their unequal solubilities in two immiscible liquid phases

    具有密度差的多相混合液進入該實用新型后，在同一機器中完成混合傳質過程和分離過程。
  18. On the basis of chemical transfer theory, the transfer mechanism was studied for the process of adsorptive bubble separation and the mathematical model describing the axis diffusion in continuous foam column and basic equation about the rate of mass transfer are set up

    以化工傳遞理論為基礎，研究了吸附泡沫分離過程的傳質機理，建立描述該傳質過程速率的基本方程及軸向擴散連續泡沫分離塔數學模型。
  19. Establishes a performance test - bed for cross - flow regenerators and a mathematical model for the heat and mass transfer

    搭建了叉流再生器性能測試的實驗臺，並建立了叉流再生器中傳熱傳質過程的數學模型。
  20. Post - processing techniques are expounded and discussed from the basic theories and applications of commercial software. then visualization of heat and mass transfer is put into practice

    對后處理技術的基礎理論、商業軟體應用分別加以探討，以實現傳熱傳質過程的可視化。
分享友人
分享到 Line

分享到臉書