噴嘴腔 的英文怎麼說

中文拼音 [pēnzuǐqiāng]
噴嘴腔 英文
nozzle chamber
  • 噴 : 噴動詞1. （液體等受壓力而射出） spurt; spout; gush; jet 2. （噴灑） spray; sprinkle
  • 嘴 : 名詞1. （口的通稱） mouth 2. （形狀或作用像嘴的東西） anything shaped or functioning like a mouth 3. （指說話） talk; speak
  • 腔 : 名詞1. （動物體內空的部分） cavity; chamber 2. （話） speech 3. （樂曲的調子） tune; pitch 4. （說話的腔調） accent; tone
  1. An ultrasonic crossjet with a non - symmetric laval cavity is designed based on the aerodynamic theory

    根據氣體動力學原理設計了一種超音速非對稱拉法爾腔體結構的噴嘴，並建立了噴嘴內部拉法爾曲線方程。
  2. The shearing layer is carried by the jet and the eddy is formed because of the instability and selective amplification of shearing layer which will propagate to the downstream. as the eddy impacts the impinging wall, a wave of pressure disturbance with certain frequency is induced. this wave then propagates to the upstream with high speed, and results in the overlap and amplification of the waves when the frequencies of them are close with each other

    當前噴嘴流束中的不穩定擾動波在穿過腔內的剪切層時，剪切層對其有選擇放大作用，形成渦環結構，剪切流動中渦環與碰撞壁撞擊，在碰撞區域產生壓力擾動波並向上游反射，在上游剪切層分離處誘發新的擾動的產生，當新擾動與原擾動匹配時，射流上游就被不斷地受到周期性激勵，腔內就產生流體自激振蕩並在後噴嘴出口形成脈沖射流。
  3. A very special rotating cavity with micro - turbine ( de - swirl nozzles ) was applied to investigate the flow characteristics inside the cavity under three mid rotating speeds

    摘要通過實驗對中等轉速下帶有微型渦輪（反預旋噴嘴）的旋轉渦輪盤腔內流動特性進行了系統研究。
  4. The screw is forced forward, injecting the plastic melt through the nozzle, on through the sprue and runners, and into the cavities of the closed mold

    螺桿向前推進，將熔融物料通過噴嘴、主流道、分流道注入閉合的模具型腔中。
  5. The hot runner series makes the plastics in the hot runner from the nozzle of a plastics injector to the inlet of cavity must be always kept at such a molten state by means of heating that you just pick out the product, there is no need for you to take the condensing stuffs from the injection system as the mould cavity is operated

    說明:熱流道系列用加熱的方法使從注塑機噴嘴到型腔入口為止這一段流道中的塑料一直保持熔融狀態，在開模時只需取出產品，而不必取澆注系統凝料。
分享友人
分享到 Line

分享到臉書