壁面 的英文怎麼說

中文拼音 [bìmiàn]
壁面 英文
wandung
  • 壁 : 名詞1 （墻） wall （of a house etc ） : 銅墻鐵壁 bastion of iron2 （作用像圍墻的部分） wall of st...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  1. Firstly, simulate flow field of rear smoke channel, plot velocity magnitude and ash concentration distribution in section of entry of heat pipe air preheater, compare with data which were measured in guiyang power station, verify simulation to be reasonable and right. secondly, simulate all kinds of factors which affect flow field ' s uniformity such as length, thickness, location of diffluent board, ash concentration, ash diameter, and so on, find the chiefly factors. thirdly, install guide board in curve channel in rear smoke channel, then simulate its " flow field, plot velocity magnitude and ash concentration distribution

    在此基礎上模擬在冬夏兩季不同情況下，不同流速對熱管空氣預熱器壁面溫度的影響；然後對影響整個流場分佈的各種因素：包括分流板長度、厚度、偏離中心流道位置的偏離度、飛灰濃度、飛灰粒徑等因素進行數值模擬；最後提出在分流煙道轉彎處加裝導流板，並模擬加裝導流板后的流場分佈，得到下級空氣預熱器出口、熱管空氣預熱器進口處的斷面速度場分佈、濃度場分佈，以論證加裝導流板能達到流場均勻化的作用。
  2. By comparing the dry plate pressures drop and distributions of velocities simulated on single valve with those of double valves, it was found that there was intense turbulence in the flow fields around fixed - valve, there were eddy areas between valve side orifices and tray wall, there were eddies above the valves too, these led to the complex behaviors of gas perforating valve, these had a great effect on the gas - liquid mass transfer process. at the same time, in order to prevent the disadvantageous effect of gas between one valve with another on the gas - liquid mass transfer, it was very effective to change the fields of gas perforating valve by folding the edges of valve

    通過對數值模擬得出的單閥和雙閥塔板的干板壓降及流場速度分佈分析對比后發現，固定閥周圍流場存在較強的湍動，閥側孔與塔板壁面區域以及閥體的上方空間存在明顯的渦流區，使氣體穿閥后的行為變得復雜，並對氣液傳質過程產生重大影響；模擬結果表明，為防止和削弱固定閥間的對沖造成的「死區」對傳質帶來的不利影響，通過折邊來改變氣體的氣路是非常有效的，模擬值與實驗值基本得到吻合。
  3. Under the assumption that the inner surface of stator sleeve and outer surface of rotor are smooth, taking the fact into account that the temperature of stator sleeve of evaporation cooling motor keeps almost the same, horizontal evaporation cooling motor is simplified as a physical model of two coaxial sleeves, with outer sleeve ( the stator ) holds still and keep at constant temperature and inner sleeve ( the rotor ) is rotating and heated

    本文通過數值和實驗手段研究了臥式蒸發冷卻電機楔形氣隙中的流體流動、傳熱現象。本文在定子套筒和轉子表面光滑的假設下，針對蒸發冷卻電機定子套筒壁面基本恆溫的特點，將實際蒸發冷卻電機簡化為同軸套筒內筒加熱旋轉、外簡靜止定溫的物理模型。
  4. Investigation on boundary layer prediction models near head wall in cylinder of diesel engine

    柴油機缸內近氣缸蓋壁面邊界層預測模型的研究
  5. Stick-slip flow is a jerky movement of compacted grains with velocity of particles at the walls slightly lower than in the rod like core.

    粘附滑移流動是一種密集顆粒的急跳式的運動，在壁面處，顆粒的速度稍低於呈桿狀的中心的速度。
  6. Study on the diseases of the tomb of chu king in xuzhou mountain lion and preventive measures

    徐州獅子山楚王陵壁面病害原因分析及防治
  7. Flows over a 2 - d rankine oval or a 3 - d rankine ovoid near a plane wall have been computed and the present numerical results agree well with that of viscous calculations as a whole concept

    壁面附近二維或三維rankine體的勢流結果與已有的粘性結果總體上符合，數值上的差別是由於忽略粘性引起的。
  8. Numerical study of the protuberance effects on capillary electrophoresis separation in the micro - channel

    微通道壁面突起對片上電泳分離流動特性影響數值計算研究
  9. Effect of secondary flow on erosion from solid particles in 90 curved duct of quadrate section

    彎管內二次流對固粒磨損壁面的影響
  10. Research on a new wall - climbing robot model with multi - suction cups

    一種新型多吸盤壁面清洗機器人模型研究
  11. Using the topological rules of the surface flow pattern, the separation configurations on the suction surface at different bowed angles is discussed

    應用壁面流譜的拓撲法則，詳細討論了不同彎角下的分離形態。
  12. The effect of air distributor on the flow fields was studied with emphasis. the working conditions of the bubble column simulated in the numerical study were as same as in the experiments. the velocity profile at axial direction showed a peek in the center, and a backward flow near the wall when usl / usg < 19. 6

    鼓泡塔內軸向液相速度的徑向分佈呈塔中心峰值、壁面附近倒流形式，且與氣相折算速度大小有關，當液相折算速度一定時，隨氣相折算速度增大而愈加陡峭，返混也劇烈。
  13. Considering the characters of the viscoidal turbulent flow over high - speed train, the computing model of the outer fiow field for high - speed train has been established based on the incompressible fluid navier - stokes epuation and the turbulent model of ke two equations. the equation set of the flow field problem via finite element methods ( fem ) has been set up

    根據高速列車粘性紊態繞流的特點，在較少簡化的條件下以navier - stokes方程和-兩方程紊流模型為基礎，建立了高速列車外流場的計算模型，在近壁區域採用壁面函數修正紊流模型。
  14. And an intelligent fault detecting system is established. starting from analyzing the possible faults existed ; relations between the fault patterns of the wall - climbing robot and the characteristic signals are established. so the problem of fault detection of the robot is in essence a problem of pattern recognition

    主要內容如下：對壁面機器人的可能故障進行分析，總結系統可能的故障類型，並選擇體現不同故障類型的特徵信號，構建系統的故障空間和故障徵兆空間，建立了兩者之間的映射關系，並在此基礎上制定了故障診斷方案。
  15. Experimental inve stigation of the heat transfer and hydromechanical characterist ics of single - head quot; w quot; type spirally fluted tubes

    對流換熱條件下微鋼管壁面軸向導熱的實驗研究
  16. Combining the generating method of molecular reflective thermal velocities according to diffuse reflection model, an algorithm named as inverse temperature sampling ( its ) is developed, which enables to evaluate the molecular reflective characteristic temperature from the molecular incident energy and the boundary heat flux

    在此基礎上，通過結合壁面漫反射模型下分子反射速度的抽樣方法，發展了一種從邊界熱流求得與壁面碰撞分子的平均反射特徵溫度的逆溫度抽樣演算法。
  17. 2. using cfd software - fluent, many flow states were been simulated. these states are the influence of nozzle structure with the flow, the distributing characteristic of inside flow, the influence of cold gas flow and outside flow with the work of the nozzle, the change of inside pressure load when the nozzle regulates

    2 、藉助cfd軟體fluent ，計算出可調噴管本身結構對流動的影響、可調噴管流場的參數分佈、冷卻氣流對噴管流動的影響、外流對可調噴管內流的影響、噴管的冷流流場和噴管調節過程中內壁面的壓強載荷變化。
  18. A normal transform is introduced, and there are enough much grids in the region between the critical layer and the wall, where the variation of the disturbance is the quickest. the finite - difference of governing equations with fourth - order accuracy in the normal direction is utilized in full regions including points close the wall, and is very important for accurately discreting equations. the combination of global and local methods is implemented, and a new iterative formula is derived

    對于曲線坐標系下的拋物化穩定性方程，文中發展了求解的高效數值方法:引進法向變換，使得在臨界層與壁面之間的擾動量變化最快的區域有更多的法向網格點;導出包含邊界鄰域在內的完全四階精度的法向有限差分格式，這對方程精確離散至關重要;採用全局法和局部法相結合的方法及其新的迭代公式，大大加速收斂並得到更精確的特徵值。
  19. 2. the temperature field got from macroscale theory and microscale theory are similar in the microscale theory, two demension heat transfer model is considered, and the temperature difference of the fluid between central axis and nearby the wall is considerably big. 3

    2 、兩種理論模型得到的溫度分佈趨勢基本一致，但微觀尺度理論考慮到流體的二維換熱，通道中心軸線處的流體的溫度與靠近壁面處流體的溫度有較大的溫差。
  20. Experimental study of measurement for dissipation rate scaling exponent in heated wall turbulence

    壁面加熱湍流耗散率標度指數測量的實驗研究
分享友人
分享到 Line

分享到臉書